- 您现在的位置：买卖IC网 > PDF目录381719 > DS1388Z-3 (MAXIM INTEGRATED PRODUCTS INC) The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each PDF资料下载
参数资料
| 型号： | DS1388Z-3 |
| 厂商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分类： | XO, clock |
| 英文描述： | The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each |
| 中文描述： | REAL TIME CLOCK, PDSO8 |
| 封装： | 0.150 INCH, SOIC-8 |
| 文件页数： | 14/18页 |
| 文件大小： | 381K |
| 代理商： | DS1388Z-3 |
D
EEPROM
The DS1388 provides 512 bytes of EEPROM organized
into two blocks of 256 bytes. Each 256-byte block is
divided into 32 pages consisting of 8 bytes per page.
The EEPROM can be written one page at a time. Page
write operations are limited to writing bytes within a sin-
gle physical page, regardless of the number of bytes
actually being written. Physical page boundaries start at
addresses that are integer multiples of the page size (8
bytes) and end at addresses that are integer multiples
of [page size -1]. For example, page 0 contains word
addresses 00h to 07h. Similarly, page 1 contains word
addresses 08h to 0Fh. If a page write command
attempts to write across a physical page boundary, the
result is that the data wraps around to the beginning of
the current page (overwriting data previously stored
there), instead of being written to the next page as
might be expected. Therefore, it is necessary for the
application software to prevent page write operations
that would attempt to cross a page boundary.
I
2
C Serial Data Bus
The DS1388 supports a bidirectional I
2
C bus and data
transmission protocol. A device that sends data onto
the bus is defined as a transmitter and a device receiv-
ing data is defined as a receiver. The device that con-
trols the message is called a master. The devices that
are controlled by the master are slaves. The bus must
be controlled by a master device that generates the
serial clock (SCL), controls the bus access, and gener-
ates the START and STOP conditions. The DS1388
operates as a slave on the I
2
C bus. Connections to the
bus are made through the open-drain I/O lines SDA
and SCL. Within the bus specifications, a standard
mode (100kHz maximum clock rate) and a fast mode
(400kHz maximum clock rate) are defined. The DS1388
works in both modes.
The following bus protocol has been defined (Figure 7):
Data transfer may be initiated only when the bus is
not busy.
During data transfer, the data line must remain stable
whenever the clock line is high. Changes in the data
line while the clock line is high will be interpreted as
control signals.
Accordingly, the following bus conditions have been
defined:
Bus not busy:
Both data and clock lines remain
high.
Start data transfer:
A change in the state of the data
line from high to low, while the clock line is high,
defines a START condition.
Stop data transfer:
A change in the state of the data
line from low to high, while the clock line is high,
defines a STOP condition.
Data valid:
The state of the data line represents valid
data when, after a START condition, the data line is
stable for the duration of the high period of the clock
signal. The data on the line must be changed during
the low period of the clock signal. There is one clock
pulse per bit of data.
I
2
C RTC/Supervisor with Trickle Charger
and 512 Bytes EEPROM
14
____________________________________________________________________
R1
250
R2
2k
R3
4k
V
CC
V
BACKUP
BIT 7
TCS3
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
TCS2
TCS1
TCS0
DS1
DS0
ROUT1
ROUT0
TRICKLE-CHARGE REGISTER (00Ah)
1 0F 16 SELECT
NOTE: ONLY 1010b ENABLES CHARGER
1 OF 2
SELECT
1 OF 3
SELECT
TCS
0-3
= TRICKLE-CHARGE SELECT
DS
0-1
= DIODE SELECT
ROUT
0-1
= RESISTOR SELECT
Figure 6. Programmable Trickle Charger
相关PDF资料 |
PDF描述 |
|---|---|
| DS1390-DS1393 | RIBBON CABLE, 34WAY, PER M; Cores, No. of:34; Conductor make-up:7/36AWG; Wire size, AWG:28AWG; Impedance:119R; Pitch:1.27mm; Voltage rating, AC:50V; Colour:Grey; Capacitance:70.5pF/m; Approval Bodies:UL; Approval category:Style RoHS Compliant: Yes |
| DS1390U-18 | RIBBON CABLE, 40WAY, PER M; Cores, No. of:40; Conductor make-up:7/36AWG; Wire size, AWG:28AWG; Impedance:119R; Pitch:1.27mm; Voltage rating, AC:50V; Colour:Grey; Capacitance:70.5pF/m; Approval Bodies:UL; Approval category:Style RoHS Compliant: Yes |
| DS1390 | Low-Voltage SPI/3-Wire RTCs with Trickle Charger |
| DS1392U-33 | Low-Voltage SPI/3-Wire RTCs with Trickle Charger |
| DS1391U-3 | IGBT Module; Continuous Collector Current, Ic:200A; Collector Emitter Saturation Voltage, Vce(sat):3.4V; Power Dissipation, Pd:1500W; Collector Current:200A; Collector Emitter Voltage, Vceo:1.2kV; Leaded Process Compatible:No RoHS Compliant: No |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS1388Z-3+ | 功能描述:实时时钟 I2C RTC/Supervisor w/Trickle Charger RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| DS1388Z-3+T&R | 制造商:Maxim Integrated Products 功能描述:2WIRE RTC 3V,SUPRVSR &EPROM PB-F TR - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC RTC I2C W/CHARGER 8-SOIC |
| DS1388Z-3+T&R | 功能描述:实时时钟 I2C RTC/Supervisor w/Trickle Charger RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| DS1388Z-33 | 功能描述:实时时钟 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| DS1388Z-33+ | 功能描述:实时时钟 I2C RTC/Supervisor w/Trickle Charger RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。