- 您现在的位置：买卖IC网 > PDF目录1994 > DS14285SN+T&R (Maxim Integrated Products)IC RTC W/NV RAM CNTRL 24-SOIC PDF资料下载
参数资料
| 型号： | DS14285SN+T&R |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 20/26页 |
| 文件大小： | 0K |
| 描述： | IC RTC W/NV RAM CNTRL 24-SOIC |
| 标准包装： | 1,000 |
| 类型： | 时钟/日历 |
| 特点： | 警报器，夏令时，闰年，NVSRAM，方波输出 |
| 存储容量： | 114B |
| 时间格式： | HH:MM:SS（12/24 小时） |
| 数据格式： | YY-MM-DD-dd |
| 接口： | 并联 |
| 电源电压： | 4.5 V ~ 5.5 V |
| 电压 - 电源，电池： | 2.5 V ~ 3.6 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-SOIC（0.295"，7.50mm 宽） |
| 供应商设备封装： | 24-SOIC W |
| 包装： | 带卷 (TR) |
DS14285/DS14287
3 of 26
DETAILED DESCRIPTION
The DS14285/DS14287 Real Time Clock with NVRAM Control provides the industry standard DS1287
clock function with the additional feature of providing nonvolatile control for an external SRAM.
Functions include a nonvolatile time-of-day clock, alarm, 100-year calendar, programmable interrupt,
square wave generator, and 114 bytes of nonvolatile static RAM. For the DS14287 a lithium energy
source, quartz crystal, and write protection circuitry are contained within a 24-pin dual in-line package.
The DS14285 requires an external quartz crystal connected to the X1 and X2 pins as well as an external
energy source connected to the VBAT pin. A standard 32.768 kHz quartz crystal can be directly connected
to the DS14285 via pins 1 and 2 (X1, X2). The crystal selected for use should have a specified load
capacitance (CL) of 6 pF. For more information on crystal selection and crystal layout considerations,
please consult Application Note 58, “Crystal Considerations with Dallas Real-time Clocks.”
The DS14285/DS14287 uses its backup energy source and battery-backup controller to make a standard
CMOS static RAM nonvolatile during power-fail conditions. During power fail, the DS14285/DS14287
automatically write-protects the external SRAM and provides a VCC output sourced from its internal
battery.
For the DS14287 the internal lithium cell is electrically isolated from the clock and memory when
shipped from the factory. This isolation is removed after the first application of VCC, allowing the lithium
cell to provide data retention to the clock, internal RAM, VCCO and CEO on subsequent power-downs.
Care must be taken after this isolation has been broken to avoid inadvertently discharging the lithium cell
through the VCCO and CEO pins.
OPERATION
The block diagram in Figure 1 shows the pin connections with the major internal functions of the
DS14285/DS14287. The following paragraphs describe the function of each pin.
SIGNAL DESCRIPTIONS
GND, VCC - DC power is provided to the device on these pins. VCC is the +5 volt input.
SQW (Square Wave Output) - The SQW pin can output a signal from one of 13 taps provided by the 15
internal divider stages of the real time clock. The frequency of the SQW pin can be changed by
programming Register A as shown in Table 1. The SQW signal can be turned on and off using the SQWE
bit in Register B. The SQW signal is not available when VCC is less than 4.25 volts typical.
AD0-AD7 (Multiplexed Bi-directional Address/Data Bus) - Multiplexed buses save pins because
address information and data information time-share the same signal paths. The addresses are present
during the first portion of the bus cycle and the same pins and signal paths are used for data in the second
portion of the cycle. Address/data multiplexing does not slow the access time of the DS14285/DS14287
since the bus change from address to data occurs during the internal RAM access time. Addresses must be
valid prior to the falling edge of AS/ALE, at which time the DS14285/DS14287 latches the address from
AD0 to AD6. Valid write data must be present and held stable during the latter portion of the DS or WR
pulses. In a read cycle the DS14285/DS14287 outputs 8 bits of data during the latter portion of the DS or
RD
pulses. The read cycle is terminated and the bus returns to a high impedance state as DS transitions
low in the case of Motorola timing or as RD transitions high in the case of Intel timing.
相关PDF资料 |
PDF描述 |
|---|---|
| DS1486P-120+ | IC TIMEKEEPER RAM 1MB 34-PCM |
| DS1500WE | IC RTC Y2KC W/NV CTRL 32-TSOP |
| DS1501YSN+T&R | IC RTC WDOG Y2K 5V IND 28-SOIC |
| DS1553P-70+ | IC RTC RAM Y2K 5V 70NS 34-PCM |
| DS1554W-120IND | IC RTC RAM Y2K 3.3V 120NS 32EDIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS14287 | 功能描述:实时时钟 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| DS14287+ | 功能描述:实时时钟 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| DS1-48-0001 | 功能描述:固定电感器 DS Storage choke 3.15A RoHS:否 制造商:AVX 电感:10 uH 容差:20 % 最大直流电流:1 A 最大直流电阻:0.075 Ohms 工作温度范围:- 40 C to + 85 C 自谐振频率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接类型:SMD/SMT 封装 / 箱体:6.6 mm x 4.45 mm |
| DS1-48-0002 | 功能描述:固定电感器 DS Storage choke 4A RoHS:否 制造商:AVX 电感:10 uH 容差:20 % 最大直流电流:1 A 最大直流电阻:0.075 Ohms 工作温度范围:- 40 C to + 85 C 自谐振频率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接类型:SMD/SMT 封装 / 箱体:6.6 mm x 4.45 mm |
| DS1-48-0003 | 制造商:Schurter Electronic Components 功能描述: |
发布紧急采购，3分钟左右您将得到回复。