参数资料
型号: DS1682S
厂商: Maxim Integrated Products
文件页数: 14/14页
文件大小: 0K
描述: IC TIMEKEEPER ALARM ELAPSE 8SOIC
产品培训模块: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
标准包装: 100
类型: 耗用时间计数器
特点: 警报器,EEPROM
存储容量: 10B
时间格式: 二进制
数据格式: 二进制
接口: I²C,2 线串口
电源电压: 2.5 V ~ 5.5 V
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 8-SOIC(0.154",3.90mm 宽)
供应商设备封装: 8-SOIC
包装: 管件
Alarm
The alarm register is a 32-bit register that holds time in
quarter-second resolution. When a nonzero number is
programmed into the alarm register, the ALARM func-
tion is enabled and the DS1682 monitors the values in
the ETC for the programmed value in the alarm register.
When the ETC matches the alarm value, the alarm flag
is set.
EEPROM Array
When power is applied, the contents of the EEPROM are
transferred to the configuration register, alarm register,
ETC, event counter, and user memory. When the event
pin goes low, VCC must remain above VCC minimum for
tEW to ensure the EEPROM is properly written.
The EEPROM array for the ETC and the event counter is
made up of three banks. Each bank can be written a maxi-
mum of 50k times. The device switches between banks
based upon the value in the event counter. Resetting the
event counter before the counter reaches 50,000 causes
additional writes to the first bank, which can allow writes
in excess of 50k. If the event counter is set to greater
than 50k or 100k prior to reset, the device stays on the
selected bank. This could result in writes in excess of 50k
to one bank.
The configuration and alarm registers and the user mem-
ory are held in one bank of EEPROM. Writes at the end
of an event only occur if the data has changed in one or
more of those registers.
User-modified data in any of the registers is stored in
EEPROM only if the data was written while an event was
active and is stored when the event ends.
Event Counter Register
This 17-bit event counter register set provides the total
number of data samples logged during the life of the prod-
uct up to 131,072 separate events. The event counter
consists of 2 bytes of memory in the memory map plus
the event counter MSB bit (ECMSB) in the configuration
register. Once the event counter reaches 1FFFFh, event
counting stops.
Reset Command
If RE is set to a 1, a reset occurs when a reset command
is sent through the 2-wire bus. A reset command is issued
by writing 55h twice into memory location 1Dh. The writes
need not be consecutive. Cycling power on VCC prior to
the second write terminates the reset sequence.
Upon reset, the ETC and event counter registers are
cleared. The AF, RE, and ECMSB bits are cleared by the
device, and the configuration register becomes read-only.
The data are written to the EEPROM, and additional
resets are ignored.
When a reset command is issued, no additional command
should be issued during the EEPROM write time (tEW).
DS1682
Total-Elapsed-Time Recorder
with Alarm
www.maximintegrated.com
Maxim Integrated │ 9
相关PDF资料
PDF描述
DS1683S+T&R IC REAL TIME EVENT REC 8SOIC
DS1685EN-5/T&R IC RTC 5V 64BIT Y2K IND 24TSSOP
DS1688S+ IC RTC W/NV RAM CTRL 28-SOIC
DS1689SN+T&R IC RTC SER NV RAM CTRL IN 28SOIC
DS17285S-3NT IC RTC 3V 2K NV RAM 24-SOIC
相关代理商/技术参数
参数描述
DS1682S/GG8 制造商:Maxim Integrated Products 功能描述:
DS1682S/T&R 制造商:Maxim Integrated Products 功能描述:REAL TIME CLOCK SERL 10BYTE 8SOIC - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC TIMEKEEPER ALARM ELAPSE 8SOIC
DS1682S/T&R 功能描述:实时时钟 Total-Elapsed-Time Recorder w/Alarm RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube
DS1682S/TR 制造商:Maxim Integrated Products 功能描述:
DS1682S+ 功能描述:实时时钟 Total-Elapsed-Time Recorder w/Alarm RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube