参数资料
型号: DS1685S-5
厂商: DALLAS SEMICONDUCTOR
元件分类: Timer or RTC
英文描述: 1 TIMER(S), REAL TIME CLOCK, PDSO24
封装: SOIC-24
文件页数: 4/39页
文件大小: 290K
代理商: DS1685S-5
DS1685/DS1687
12 of 39
NONVOLATILE RAM - RTC
The 242 general purpose nonvolatile RAM bytes are not dedicated to any special function within the
DS1685/DS1687. They can be used by the application program as nonvolatile memory and are fully
available during the update cycle.
The user RAM is divided into two separate memory banks. When the bank 0 is selected, the 14 real time
clock registers and 114 bytes of user RAM are accessible. When bank 1 is selected, an additional 128
bytes of user RAM are accessible through the extended RAM address and data registers.
INTERRUPT CONTROL
The DS1685/DS1687 includes six separate, fully automatic sources of interrupt for a processor:
1. Alarm interrupt
2. Periodic interrupt
3. Update-ended interrupt
4. Wake-up interrupt
5. Kickstart interrupt
6. RAM clear interrupt
The conditions which generate each of these independent interrupt conditions are described in greater
detail elsewhere in this data sheet. This section describes the overall control of the interrupts.
The application software can select which interrupts, if any, are to be used. There are a total of 6 bits
including 3 bits in Register B and 3 bits in Extended Register B which enable the interrupts.
The
extended register locations are described later. Writing a logic 1 to an interrupt enable bit permits that
interrupt to be initiated when the event occurs. A logic 0 in the interrupt enable bit prohibits the IRQ pin
from being asserted from that interrupt condition. If an interrupt flag is already set when an interrupt is
enabled, IRQ will immediately be set at an active level, even though the event initiating the interrupt
condition may have occurred much earlier. As a result, there are cases where the software should clear
these earlier generated interrupts before first enabling new interrupts.
When an interrupt event occurs, the relating flag bit is set to a logic 1 in Register C or in Extended
Register A. These flag bits are set regardless of the setting of the corresponding enable bit located either
in Register B or in Extended Register B. The flag bits can be used in a polling mode without enabling the
corresponding enable bits.
However, care should be taken when using the flag bits of Register C as they are automatically cleared to
0 immediately after they are read. Double latching is implemented on these bits so that bits which are set
remain stable throughout the read cycle. All bits which were set are cleared when read and new interrupts
which are pending during the read cycle are held until after the cycle is completed. One, 2, or 3 bits can
be set when reading Register C. Each utilized flag bit should be examined when read to ensure that no
interrupts are lost.
The flag bits in Extended Register A are not automatically cleared following a read. Instead, each flag bit
can be cleared to 0 only by writing 0 to that bit.
相关PDF资料
PDF描述
DS1685EN-3 1 TIMER(S), REAL TIME CLOCK, PDSO24
DS1685E-3 1 TIMER(S), REAL TIME CLOCK, PDSO24
DS1685EN-5 1 TIMER(S), REAL TIME CLOCK, PDSO24
DS1685-5 1 TIMER(S), REAL TIME CLOCK, PDIP24
DS1685SN-3 1 TIMER(S), REAL TIME CLOCK, PDSO24
相关代理商/技术参数
参数描述
DS1685S-5/T&R 功能描述:实时时钟 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube
DS1685S-5/TR 制造商:DALLAS 制造商全称:Dallas Semiconductor 功能描述:3V/5V Real-Time Clocks
DS1685S-5_12 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:3V/5V Real-Time Clocks
DS1685S-5+ 功能描述:实时时钟 3V/5V RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube
DS1685S-5+T& 制造商:DALLAS 制造商全称:Dallas Semiconductor 功能描述:3V/5V Real-Time Clocks