- 您现在的位置：买卖IC网 > PDF目录295504 > DS1845X-100 (DALLAS SEMICONDUCTOR) 100K DIGITAL POTENTIOMETER, 2-WIRE SERIAL CONTROL INTERFACE, 256 POSITIONS, UUC14 PDF资料下载
参数资料
| 型号： | DS1845X-100 |
| 厂商： | DALLAS SEMICONDUCTOR |
| 元件分类： | 数字电位计 |
| 英文描述： | 100K DIGITAL POTENTIOMETER, 2-WIRE SERIAL CONTROL INTERFACE, 256 POSITIONS, UUC14 |
| 封装： | FCP-14 |
| 文件页数： | 4/13页 |
| 文件大小： | 98K |
| 代理商： | DS1845X-100 |
DS1845
12 of 13
6. A fast mode device can be used in a standard mode system, but the requirement tSU:DAT > 250 ns
must then be met. This will automatically be the case if the device does not stretch the LOW period
of the SCL signal. If such a device does stretch the LOW period of the SCL signal, it must output the
next data bit to the SDA line tRMAX + tSU:DAT = 1000 + 250 = 1250 ns before the SCL line is
released.
7. After this period, the first clock pulse is generated.
8. The maximum tHD:DAT has only to be met if the device does not stretch the LOW period (tLOW) of
the SCL signal.
9. CB - total capacitance of one bus line in picofarads, timing referenced to (0.9(V
CC
) and (0.1)(V
CC
).
10. EEPROM write begins after a stop condition occurs.
11. Resistor inputs can not go beneath GND by more than 0.5V or above VCC by more that 0.5V.
12. The –3 dB cutoff frequency for the DS1845 is 1 MHz (10k/10k version).
13. Absolute linearity is used to measure expected wiper voltage as determined by wiper position. The
DS1845 is specified to provide an absolute linearity of ± 0.5 LSB (10k/10k version), ±1 LSB(10k/50k
version), and ± 1.5 LSB (10k/100k) version.
14. Relative linearity is used to determine the change of wiper voltage between two adjacent wiper
positions. The DS1845 is specified to have a relative linearity of ± 0.25 dB.
15. When used as a rheostat or variable resister the temperature coefficient applies: 650 ppm/°C. When
used as a voltage divider or potentiometer, the effective temperature coefficient approaches
30 ppm/°C.
16. ICC specified with SDA pin open.
17. Maximum Icc is dependent on clock rates.
18. Valid for VCC = 5V only.
19. Valid at 25°C only.
相关PDF资料 |
PDF描述 |
|---|---|
| DS1866N | DIGITAL POTENTIOMETER, 3-WIRE SERIAL CONTROL INTERFACE, 64 POSITIONS, PDIP8 |
| DS1867-100-IND | 100K DIGITAL POTENTIOMETER, 3-WIRE SERIAL CONTROL INTERFACE, 256 POSITIONS, PDIP14 |
| DS2009D-65 | 512 X 9 OTHER FIFO, 65 ns, PDIP28 |
| DS500008-12 | 8-BIT, 12 MHz, MICROCONTROLLER, PDIP40 |
| DS80C310-MCL | 8-BIT, MROM, 33 MHz, MICROCONTROLLER, PDIP40 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS1845X-100/T&R | 制造商:Maxim Integrated Products 功能描述:DUAL NV POT & MEM BUMP 10K/100K TR - Tape and Reel 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述:IC POT/MEM DUAL NV 100K 14-FCP |
| DS1845X-100/T&R | 功能描述:数字电位计 IC RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| DS1846 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:NV Tri-Potentiometer, Memory, and MicroMonitor |
| DS1846E-010 | 功能描述:数字电位计 IC RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| DS1846E-010/R | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:NV Tri-Potentiometer, Memory, and MicroMonitor |
发布紧急采购，3分钟左右您将得到回复。