- 您现在的位置：买卖IC网 > PDF目录1913 > DS1852B-00C+ (Maxim Integrated Products)IC MONITOR TXRX OPTICAL 25-BGA PDF资料下载
参数资料
| 型号： | DS1852B-00C+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 23/26页 |
| 文件大小： | 0K |
| 描述： | IC MONITOR TXRX OPTICAL 25-BGA |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 103 |
| 类型： | 收发器 |
| 电源电压： | 2.7 V ~ 5.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 25-TFBGA，CSPBGA |
| 供应商设备封装： | 25-BGA（5x5） |
| 包装： | 托盘 |
DS1852
6 of 26
ANALOG-TO-DIGITAL CONVERTER
The ADC reads a total of five inputs: VCC (internal), temperature (internal), and external inputs Bin, Pin,
and Rin. All conversions are updated every 13ms (nominal) or 20ms (max) in rotation. The conversions
are absolute and compared to an internal reference. While the 16-bit values are read, only the upper 12
are significant. The lower four bits are undefined.
The temperature and analog voltage inputs are calibrated by Dallas Semiconductor and read with the
following scale:
Temperature: High byte: -128
°C to +127°C signed; low byte: 1/256°C. The lower four bits
should be ignored.
S
26
25
24
23
22
21
20
2-1
2-2
2-3
2-4
2-5
2-6
2-7
2-8
VCC: This reads as an unsigned 16-bit quantity at 100
mV LSB, with a maximum range of
6.5535V, when using the factory default value. The lower four bits should be ignored.
Bin, Pin, Rin: These read as an unsigned 16-bit quantity at 38.147
mV LSB, with a maximum range
of 2.500V, when using factory default values. The lower four bits should be ignored.
215
214
213
212
211
210
29
28
27
26
25
24
23
22
21
20
Each analog input has a 16-bit scaling calibration in Table 03h EEPROM. This allows the analog
conversion values to be calibrated for full scale at any input voltage from 0.2V to 6.5535V. The ADC
conversion value will clamp rather than roll over. Each external analog channel has a maximum input
voltage of VCC independent of the calibration factor.
The upper four bits of scaling select the coarse range; the lower 12 bits are for fine adjustments. The
algorithm to trim the scale is described below.
The scaling factors for each input (VCC, VBin, VPin, and VRin) are 16 bits wide. They are located in
Table 03h at addresses C8h to CFh, respectively. The 16 bits are a combination of two trims. The lower
12 bits are binary weighted and give the high resolution trim for scaling the input to output relationship.
The upper four bits are a coarse-adjust of the lower 12 bits. In other words, the upper four bits scale the
LSB value of the binary weighted lower 12 bits.
As an illustration, assume a value of 1V is needed to read full scale. Force a voltage less than 1V
(975mV, for example) to keep clamping out of the way. The closer to max voltage the better, but not too
close.
1) Set the scale trim to 0FFFh (the upper four bits to all zeros and the lower 12 bits to all ones).
2) Use a SAR approach on the upper four bits, starting with 1000b, to find the smallest 4-bit trim
necessary to cause the voltage reading to be above the input (in this case, greater than or equal to
975mV). If they all clamp, that is okay. That means 0000b is the needed value for the upper four
相关PDF资料 |
PDF描述 |
|---|---|
| DS1854E-050 | IC RES TEMP-CNTRL 50/50K 16TSSOP |
| DS1855X-050#T&R | IC DUAL NV DGTL POT/MEM 14-FCP |
| DS1856B-030+ | IC RES TEMP-CNTRL 30/10K 16-BGA |
| DS1857E-050+ | IC RES TEMP 50/50K 2MON 16-TSSOP |
| DS1857E-050 | IC RES TEMP 50/50K 2MON 16-TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS1852B-00C+ | 功能描述:模数转换器 - ADC Optical Transceiver Diagnostic Monitor RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| DS1852B-00C+T&R | 制造商:Maxim Integrated Products 功能描述:OPT TRANS DIAG MON REV C1 T&R LF - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC MONITOR TXRX OPTICAL 25-BGA 制造商:Maxim Integrated Products 功能描述:Data Converter ICs - Various Optical Transceiver Diagnostic Monitor |
| DS1852B-00C+T&R | 功能描述:模数转换器 - ADC Optical Transceiver Diagnostic Monitor RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| DS1854 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Dual Temperature-Controlled Resistors with Two Monitors |
| DS1854B-050 | 功能描述:数字电位计 IC RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。