- 您现在的位置：买卖IC网 > PDF目录1914 > DS2151QN (Maxim Integrated Products)IC TXRX T1 1-CH 5V LP IND 44PLCC PDF资料下载
参数资料
| 型号： | DS2151QN |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 34/60页 |
| 文件大小： | 0K |
| 描述： | IC TXRX T1 1-CH 5V LP IND 44PLCC |
| 标准包装： | 1 |
| 功能： | 单芯片收发器 |
| 接口： | T1 |
| 电路数： | 1 |
| 电源电压： | 4.75 V ~ 5.25 V |
| 电流 - 电源： | 65mA |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 44-LCC（J 形引线） |
| 供应商设备封装： | 44-PLCC（16.59x16.59） |
| 包装： | 管件 |
| 包括： | 警报检测器和发生器，CSU 回路代码发生器和检测器，DSX-1和CSU 线路补偿发生器 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页当前第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页
DS2151Q
4 of 60
1 DETAILED DESCRIPTION
The DS2151Q T1 single-chip transceiver (SCT) contains all the necessary functions for connection to T1
lines whether they be DS-1 long haul or DSX-1 short haul. The clock recovery circuitry automatically
adjusts to T1 lines from 0 feet to over 6000 feet in length. The device can generate both DSX-1 line
build-outs as well as CSU build-outs of -7.5dB, -15dB, and -22.5dB. The on-board jitter attenuator
(selectable to either 32 bits or 128 bits) can be placed in either the transmit or receive data paths. The
framer locates the frame and multiframe boundaries and monitors the data stream for alarms. It is also
used for extracting and inserting robbed-bit signaling data and FDL data. The device contains a set of 64
8-bit internal registers that the user can access to control the operation of the unit. Quick access via the
parallel control port allows a single micro to handle many T1 lines. The device fully meets all of the latest
T1 specifications including ANSI T1.403-199X, AT&T TR 62411 (12-90), and ITU G.703, G.704,
G.706, G.823, and I.431.
1.1 Introduction
The analog AMI waveform off of the T1 line is transformer coupled into the RRING and RTIP pins of
the DS2151Q. The device recovers clock and data from the analog signal and passes it through the jitter
attenuation mux to the receive side framer where the digital serial stream is analyzed to locate the framing
pattern. If needed, the receive side elastic store can be enabled in order to absorb the phase and frequency
differences between the recovered T1 data stream and an asynchronous backplane clock which is
provided at the SYSCLK input.
The transmit side of the DS2151Q is totally independent from the receive side in both the clock
requirements and characteristics. Data can be either provided directly to the transmit formatter or via an
elastic store. The transmit formatter will provide the necessary data overhead for T1 transmission. Once
the data stream has been prepared for transmission, it is sent via the jitter attenuation mux to the
waveshaping and line driver functions. The DS2151Q will drive the T1 line from the TTIP and TRING
pins via a coupling transformer.
相关PDF资料 |
PDF描述 |
|---|---|
| DS2152L+ | IC TXRX T1 1CHIP ENHNCD 100-LQFP |
| DS2153Q-A7+T&R | IC TXRX E1 1-CHIP 5V 44-PLCC |
| DS2154LNA2+ | IC TXRX E1 5V 100-LQFP |
| DS2154L | IC TXRX E1 1CHIP 5V ENH 100-LQFP |
| DS2155LN | IC TXRX T1/E1/J1 1-CHIP 100-LQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS2151QN/T&R+ | 制造商:Maxim Integrated Products 功能描述:FRAMER DS1/E1/ISDN-PRI/T1 5V 44PLCC - Tape and Reel |
| DS2151QN/T&R | 功能描述:网络控制器与处理器 IC RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| DS2151QNB | 功能描述:网络控制器与处理器 IC RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| DS2151QNB/T&R | 制造商:Maxim Integrated Products 功能描述:T1 SINGLE CHIP XCVR REV B IND - Tape and Reel |
| DS2151QNB/T&R | 功能描述:网络控制器与处理器 IC RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
发布紧急采购，3分钟左右您将得到回复。