参数资料
型号: DS2409P
厂商: MAXIM INTEGRATED PRODUCTS INC
元件分类: Telecom IC:Other
英文描述: SPECIALTY TELECOM CIRCUIT, PDSO6
封装: 3.70 X 4 MM, 1.50 MM HEIGHT, TSOC-6
文件页数: 10/18页
文件大小: 420K
代理商: DS2409P
DS2409
18 of 18
AC ELECTRICAL CHARACTERISTICS
(-40°C to +85°C, VDD = 5V ±10%)
PARAMETER
SYMBOL
MIN
TYP
MAX
UNITS
NOTES
Time Slot
tSLOT
60
120
s
Write 1 Low Time
tLOW1
115
s
10
Write 0 Low Time
tLOW0
60
120
s
Read Low Time
tLOWR
115
s
10
Read Data Valid
tRDV
15
s
9
Release Time
tRELEASE
015
45
s
Read Data Setup
tSU
1s
6
Recovery Time
tREC
1s
Reset Time High
tRSTH
480
s
5
Reset Time Low
tRSTL
480
960
s
7
Presence Detect High
tPDH
15
60
s
Presence Detect Low
tPDL
60
240
s
NOTES:
1. All voltages are referenced to ground.
2. Measured with outputs open.
3. VPUP = external pullup voltage.
4. Input load is to ground.
5. An additional reset or communication sequence cannot begin until the reset high time has expired.
6. Read data setup time refers to the time the bus master must pull the I/O line low to read a bit. Data is
guaranteed to be valid within 1 s of this falling edge.
7. The reset low time (tRSTL) should be restricted to a maximum of 960 s, to allow interrupt signaling,
otherwise, it could mask or conceal interrupt pulses. The DS2409 may perform a power-on reset cycle
and deactivate both 1-Wire outputs if the 1-Wire input is low for minimum 8 ms. A low time of 12 ms
or more will always cause a power-on reset cycle.
8. The main output has a slew rate controlled output. The indicated current is a DC value. The sink
current typically reaches 80% of its DC value 1 s after turning on the transistor.
9. The optimal sampling point for the master is as close as possible to the end time of the 15s tRDV
period without exceeding tRDV. For the case of a Read-One Time Slot, this maximizes the amount of
time for the pull-up resistor to recover to a high level. For a Read-Zero Time Slot, it ensures that a
read will occur before the fastest 1-Wire device(s) release the line.
10. The duration of the low pulse sent by the master should be a minimum of 1s with a maximum value
as short as possible to allow time for the pull-up resistor to recover the line to a high level before the
1-Wire device samples in the case of a Write-One Time or before the master samples in the case of a
Read-One Time.
Not
Recommended
for
New
Design
相关PDF资料
PDF描述
DS2415P 0 TIMER(S), REAL TIME CLOCK, PDSO6
DS2415X 0 TIMER(S), REAL TIME CLOCK, X6
DS2417X 0 TIMER(S), REAL TIME CLOCK, PBGA6
DS2417P 0 TIMER(S), REAL TIME CLOCK, PDSO6
DS2422X SPECIALTY MEMORY CIRCUIT, UUC
相关代理商/技术参数
参数描述
DS2409P/T&R 制造商:Maxim Integrated Products 功能描述:IC COUPLER MICROLAN 1-WIRE 6TSOC
DS2409P/T&R 功能描述:接口 - 专用 RoHS:否 制造商:Texas Instruments 产品类型:1080p60 Image Sensor Receiver 工作电源电压:1.8 V 电源电流:89 mA 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:BGA-59
DS2409P+ 制造商:Maxim Integrated Products 功能描述:MICROLAN COUPLER 制造商:Maxim Integrated Products 功能描述:MICROLAN COUPLER SMD TSOC-6 2409
DS2411 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Silicon Serial Number with Vcc Input
DS2411C/W 制造商:Maxim Integrated Products 功能描述:SINGLE, UNSORTED UN-BACKLAPPED WAFER - Gel-pak, waffle pack, wafer, diced wafer on film