- 您现在的位置：买卖IC网 > PDF目录16031 > DV42XXX (Microchip Technology)KIT EVAL DIGITAL POT MCP42XXX PDF资料下载
参数资料
| 型号： | DV42XXX |
| 厂商： | Microchip Technology |
| 文件页数： | 6/28页 |
| 文件大小： | 0K |
| 描述： | KIT EVAL DIGITAL POT MCP42XXX |
| 标准包装： | 1 |
| 其它名称： | Q1133465 |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
MCP41XXX/42XXX
DS11195C-page 14
2003 Microchip Technology Inc.
4.1
Modes of Operation
Digital potentiometer applications can be divided into
two categories: rheostat mode and potentiometer, or
voltage divider, mode.
4.1.1
RHEOSTAT MODE
In the rheostat mode, the potentiometer is used as a
two-terminal resistive element. The unused terminal
should be tied to the wiper, as shown in Figure 4-2.
Note that reversing the polarity of the A and B terminals
will not affect operation.
FIGURE 4-2:
Two-terminal or rheostat
configuration for the digital potentiometer. Acting
as a resistive element in the circuit, resistance is
controlled by changing the wiper setting.
Using the device in this mode allows control of the total
resistance between the two nodes. The total measured
resistance would be the least at code 00h, where the
wiper is tied to the B terminal. The resistance at this
code is equal to the wiper resistance, typically 52
for
the 10 k
MCP4X010 devices, 125 for the 50 k
(MCP4X050), and 100 k
(MCP4X100) devices. For
the 10 k
device, the LSB size would be 39.0625
(assuming 10 k
total resistance). The resistance
would then increase with this LSB size until the total
measured resistance at code FFh would be 9985.94
.
The wiper will never directly connect to the A terminal
of the resistor stack.
In the 00h state, the total resistance is the wiper resis-
tance. To avoid damage to the internal wiper circuitry in
this configuration, care should be taken to ensure the
current flow never exceeds 1 mA.
For dual devices, the variation of channel-to-channel
matching of the total resistance from A to B is less than
1%. The device-to-device matching, however, can vary
up to 30%. In the rheostat mode, the resistance has a
positive temperature coefficient. The change in wiper-
to-end terminal resistance over temperature is shown
in Figure 2-8. The most variation over temperature will
occur in the first 6% of codes (code 00h to 0Fh) due to
the wiper resistance coefficient affecting the total resis-
tance. The remaining codes are dominated by the total
resistance tempco RAB, typically 800 ppm/°C.
4.1.2
POTENTIOMETER MODE
In the potentiometer mode, all three terminals of the
device are tied to different nodes in the circuit. This
allows the potentiometer to output a voltage propor-
tional to the input voltage. This mode is sometimes
called voltage divider mode. The potentiometer is used
to provide a variable voltage by adjusting the wiper
position between the two endpoints as shown in
Figure 4-3. Note that reversing the polarity of the A and
B terminals will not affect operation.
FIGURE 4-3:
Three terminal or voltage
divider mode.
In this configuration, the ratio of the internal resistance
defines the temperature coefficient of the device. The
resistor matching of the RWB resistor to the RAB resistor
performs with a typical temperature coefficient of
1 ppm/°C (measured at code 80h). At lower codes, the
wiper resistance temperature coefficient will dominate.
Figure 2-3 shows the effect of the wiper. Above the
lower codes, this figure shows that 70% of the states
will typically have a temperature coefficient of less than
5 ppm/°C. 30% of the states will typically have a
ppm/°C of less than 1.
A
B
W
MCP4XXXX
Resistor
A
B
W
MCP4XXXX
V1
V2
相关PDF资料 |
PDF描述 |
|---|---|
| M3TKK-4020K | IDC CABLE - MSD40K/MC40F/MPK40K |
| A3RRB-4018G | IDC CABLE - APR40B/AE40G/APR40B |
| A3CKB-6436G | IDC CABLE - AKC64B/AE64G/APK64B |
| M3RRK-3418J | IDC CABLE - MPR34K/MC34G/MPR34K |
| M3GGK-3418J | IDC CABLE - MCS34K/MC34G/MCS34K |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DV4X12.5SR4A-SA1 | 制造商:Hikvision USA 功能描述:12.5~50mm Auto Iris Varifocal 5MP Lens 制造商:HIKVISION 功能描述:VARIFOCAL 1/1.8 LENS 5MP LEF1.6 12.5-50MM AUTO IRIS |
| DV50 | 功能描述:数字万用表 TELESCOPING AC VOLTAGE DETECTOR RoHS:否 制造商:Tektronix 产品:Multimeters 类型:Bench 准确性:0.04 % 电压范围:2 V to 2 kV 电阻范围: 电容范围: 显示计数: 频率:10 Hz to 45 Hz, 850 Hz to 1 MHz 测距: 真均方根值: 数据保持: |
| DV50K3225T | 制造商:SEI Stackpole Electronics Inc 功能描述:- Tape and Reel 制造商:SEI Stackpole Electronics Inc 功能描述:Var MOV 50VAC/65VDC 400A 82V 3225 SMD T/R |
| DV50K4032T | 制造商:SEI Stackpole Electronics Inc 功能描述:VAR 50VAC 65VDC 1200A 82V 4032 SMD - Tape and Reel 制造商:SEI Stackpole Electronics Inc 功能描述:Var MOV 50VAC/65VDC 1200A 82V 4032 SMD T/R |
| DV51-322-037 | 制造商:Moeller Electric Corporation 功能描述:FREQUENCY CONVERTER DV51(0.25 KW-230 V) |
发布紧急采购，3分钟左右您将得到回复。