参数资料
| 型号： | EL8102IW-T7A |
| 厂商： | Intersil |
| 文件页数： | 3/15页 |
| 文件大小： | 0K |
| 描述： | IC OP AMP 500MHZ R-R SOT-23-6 |
| 标准包装： | 250 |
| 放大器类型： | 电压反馈 |
| 电路数： | 1 |
| 输出类型： | 满摆幅 |
| 转换速率： | 600 V/µs |
| 增益带宽积： | 200MHz |
| -3db带宽： | 500MHz |
| 电流 - 输入偏压： | 6µA |
| 电压 - 输入偏移： | 800µV |
| 电流 - 电源： | 5.6mA |
| 电流 - 输出 / 通道： | 65mA |
| 电压 - 电源，单路/双路(±)： | 3 V ~ 5 V，±1.5 V ~ 2.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | SOT-23-6 |
| 供应商设备封装： | SOT-23-6 |
| 包装： | 带卷 (TR) |
11
FN7104.7
August 10, 2007
Typical Applications
VIDEO SYNC PULSE REMOVER
Many CMOS analog to digital converters have a parasitic
latch up problem when subjected to negative input voltage
levels. Since the sync tip contains no useful video
information and it is a negative going pulse, we can chop it
off. Figure 30 shows a gain of 2 connections for EL8102,
EL8103. Figure 31 shows the complete input video signal
applied at the input, as well as the output signal with the
negative going sync pulse removed.
MULTIPLEXER
Besides the normal power-down usage, the ENABLE pin of
the EL8102 can be used for multiplexing applications. Figure
32 shows two EL8102 with the outputs tied together, driving
a back terminated 75
Ω video load. A 2V
P-P 2MHz sine wave
is applied to Amp A and a 1VP-P 2MHz sine wave is applied
to Amp B. Figure 33 shows the ENABLE signal and the
resulting output waveform at VOUT. Observe the break-
before-make operation of the multiplexing. Amp A is on and
VIN1 is passed through to the output when the ENABLE
signal is low and turns off in about 25ns when the ENABLE
signal is high. About 200ns later, Amp B turns on and VIN2 is
passed through to the output. The break-before-make
operation ensures that more than one amplifier isn’t trying to
drive the bus at the same time.
SINGLE SUPPLY VIDEO LINE DRIVER
The EL8102 and EL8103 are wideband rail-to-rail output op
amplifiers with large output current, excellent dG, dP, and low
distortion that allow them to drive video signals in low supply
applications. Figure 34 is the single supply non-inverting
video line driver configuration and Figure 35 is the inverting
video line driver configuration. The signal is AC coupled by
C1. R1 and R2 are used to level shift the input and output to
provide the largest output swing. RF and RG set the AC gain.
C2 isolates the virtual ground potential. RT and R3 are the
termination resistors for the line. C1, C2 and C3 are selected
big enough to minimize the droop of the luminance signal.
FIGURE 30. SYNC PULSE REMOVER
5V
1k
VOUT
VIN
75
Ω
+
-
75
Ω
1k
75
Ω
VS+
VS-
FIGURE 31. VIDEO SIGNAL
1V
0.5V
0V
1V
0.5V
0V
M = 10s/DIV
VOUT
VIN
FIGURE 32. TWO TO ONE MULTIPLEXER
+2.5V
1k
2MHz
75
Ω
+
-
1k
75
Ω
-2.5V
VOUT
75
Ω
1V
P-P
B
+2.5V
1k
2MHz
+
-
1k
75
Ω
-2.5V
2VP-P
A
ENABLE
FIGURE 33.
0V
-0.5V
-1.5V
-2.5V
1V
0V
M = 50ns/DIV
A
ENABLE
B
-1V
EL8102, EL8103
相关PDF资料 |
PDF描述 |
|---|---|
| LTC2055CMS8#TRPBF | IC OPAMP ZERO DRFT DUAL LP 8MSOP |
| IXBOD1-20RD | IC DIODE MODULE BOD 0.2A 2000V |
| LTC2055CMS8#TR | IC OPAMP ZERO DRFT DUAL LP 8MSOP |
| IXBOD1-19RD | IC DIODE MODULE BOD 0.2A 1900V |
| EL8102IS-T7 | IC OP AMP 500MHZ R-R 8-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EL8102IWZ-T7 | 功能描述:运算放大器 - 运放 EL8102IWZ 500MHZ R2R AMP RoHS:否 制造商:STMicroelectronics 通道数量:4 共模抑制比（最小值）:63 dB 输入补偿电压:1 mV 输入偏流（最大值）:10 pA 工作电源电压:2.7 V to 5.5 V 安装风格:SMD/SMT 封装 / 箱体:QFN-16 转换速度:0.89 V/us 关闭:No 输出电流:55 mA 最大工作温度:+ 125 C 封装:Reel |
| EL8102IWZ-T7A | 功能描述:运算放大器 - 运放 EL8102IWZ 500MHZ R2R AMP RoHS:否 制造商:STMicroelectronics 通道数量:4 共模抑制比（最小值）:63 dB 输入补偿电压:1 mV 输入偏流（最大值）:10 pA 工作电源电压:2.7 V to 5.5 V 安装风格:SMD/SMT 封装 / 箱体:QFN-16 转换速度:0.89 V/us 关闭:No 输出电流:55 mA 最大工作温度:+ 125 C 封装:Reel |
| EL8103 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:500MHz Rail-to-Rail Amplifiers |
| EL8103IW-T7 | 功能描述:IC OP AMP 500MHZ R-R SOT23-5 RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1,000 系列:- 放大器类型:电压反馈 电路数:4 输出类型:满摆幅 转换速率:33 V/µs 增益带宽积:20MHz -3db带宽:30MHz 电流 - 输入偏压:2nA 电压 - 输入偏移:3000µV 电流 - 电源:2.5mA 电流 - 输出 / 通道:30mA 电压 - 电源，单路/双路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOIC 包装:带卷 (TR) |
| EL8103IW-T7A | 功能描述:IC OP AMP 500MHZ R-R SOT-23-5 RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:50 系列:- 放大器类型:通用 电路数:2 输出类型:满摆幅 转换速率:1.8 V/µs 增益带宽积:6.5MHz -3db带宽:4.5MHz 电流 - 输入偏压:5nA 电压 - 输入偏移:100µV 电流 - 电源:65µA 电流 - 输出 / 通道:35mA 电压 - 电源，单路/双路(±):1.8 V ~ 5.25 V，±0.9 V ~ 2.625 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽） 供应商设备封装:10-MSOP 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。