- 您现在的位置：买卖IC网 > PDF目录362744 > EPC16QI100 (Altera Corporation) 2. Enhanced Configuration Devices (EPC4, EPC8 & EPC16) Data Sheet PDF资料下载
参数资料
| 型号： | EPC16QI100 |
| 厂商： | Altera Corporation |
| 英文描述： | 2. Enhanced Configuration Devices (EPC4, EPC8 & EPC16) Data Sheet |
| 中文描述： | 2。增强型配置器件（EPC4，EPC8 |
| 文件页数： | 5/36页 |
| 文件大小： | 421K |
| 代理商： | EPC16QI100 |
第1页第2页第3页第4页当前第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
Altera Corporation
August 2005
2–5
Configuration Handbook, Volume 2
Enhanced Configuration Devices (EPC4, EPC8 & EPC16) Data Sheet
In addition to transmitting configuration data to the FPGAs, the
configuration circuit is also responsible for pausing configuration
whenever there is insufficient data available for transmission. This occurs
when the flash read bandwidth is lower than the configuration write
bandwidth. Configuration is paused by stopping the
DCLK
to the FPGA,
when waiting for data to be read from the flash or for data to be
decompressed. This technique is called “Pausing
DCLK
.”
The enhanced configuration device flash memories feature a 90-ns access
time (approximately 10 MHz). Hence, the flash read bandwidth is limited
to about 160 megabits per second (Mbps) (16-bit flash data bus,
DQ[]
, at
10 MHz). However, the configuration speeds supported by Altera FPGAs
are much higher and translate to high configuration write bandwidths.
For instance, 100-MHz Stratix FPP configuration requires data at the rate
of 800 Mbps (8-bit
DATA[]
bus at 100 MHz). This is much higher than the
160 Mbps the flash memory can support, and is the limiting factor for
configuration time. Compression increases the effective flash read
bandwidth since the same amount of configuration data takes up less
space in the flash memory after compression. Since Stratix configuration
data compression ratios are approximately two, the effective read
bandwidth doubles to about 320 Mbps.
Finally, the configuration controller also manages errors during
configuration. A
CONF_DONE
error occurs when the FPGA does not de-
assert its
CONF_DONE
signal within 64 DCLK cycles after the last bit of
configuration data is transmitted. When a
CONF_DONE
error is detected,
the controller pulses the
OE
line low, which pulls
nSTATUS
low and
triggers another configuration cycle.
A cyclic redundancy check (CRC) error occurs when the FPGA detects
corruption in the configuration data. This corruption could be a result of
noise coupling on the board such as poor signal integrity on the
configuration signals. When this error is signaled by the FPGA (by
driving the
nSTATUS
line low), the controller stops configuration. If the
Auto-Restart Configuration After Error
option is enabled in the FPGA,
it releases its
nSTATUS
signal after a reset time-out period and the
controller attempts to reconfigure the FPGA.
After the FPGA configuration process is complete, the controller drives
DCLK
low and the
DATA[]
pins high. Additionally, the controller tri-
states its internal interface to the flash memory, enables the weak internal
pull-ups on the flash address and control lines, and enables bus-keep
circuits on flash data lines.
The following sections briefly describe the different configuration
schemes supported by the enhanced configuration device: FPP, PS, and
concurrent configuration.
相关PDF资料 |
PDF描述 |
|---|---|
| EPC8xxx | 2. Enhanced Configuration Devices (EPC4, EPC8 & EPC16) Data Sheet |
| EPC8QC100 | 2. Enhanced Configuration Devices (EPC4, EPC8 & EPC16) Data Sheet |
| EPC8QI100 | 2. Enhanced Configuration Devices (EPC4, EPC8 & EPC16) Data Sheet |
| EPC16xxx | 435882001 |
| EPC4QC100 | 2. Enhanced Configuration Devices (EPC4, EPC8 & EPC16) Data Sheet |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EPC16QI100N | 功能描述:FPGA-配置存储器 IC - Ser. Config Mem Flash 16Mb 33 MHz RoHS:否 制造商:Altera Corporation 存储类型:Flash 存储容量:1.6 Mbit 工作频率:10 MHz 电源电压-最大:5.25 V 电源电压-最小:3 V 电源电流:50 uA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:PLCC-20 |
| EPC16UC88 | 功能描述:FPGA-配置存储器 IC - Ser. Config Mem Flash 16Mb 33 MHz RoHS:否 制造商:Altera Corporation 存储类型:Flash 存储容量:1.6 Mbit 工作频率:10 MHz 电源电压-最大:5.25 V 电源电压-最小:3 V 电源电流:50 uA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:PLCC-20 |
| EPC16UC88AA | 功能描述:IC CONFIG DEVICE 16MBIT 88-UBGA RoHS:否 类别:集成电路 (IC) >> 存储器 - 用于 FPGA 的配置 Proms 系列:EPC 产品变化通告:Product Discontinuation 28/Jul/2010 标准包装:98 系列:- 可编程类型:OTP 存储容量:300kb 电源电压:3 V ~ 3.6 V 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商设备封装:8-TSOP 包装:管件 |
| EPC16UC88N | 功能描述:FPGA-配置存储器 IC - Ser. Config Mem Flash 16Mb 33 MHz RoHS:否 制造商:Altera Corporation 存储类型:Flash 存储容量:1.6 Mbit 工作频率:10 MHz 电源电压-最大:5.25 V 电源电压-最小:3 V 电源电流:50 uA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:PLCC-20 |
| EPC16UI88AA | 功能描述:FPGA-配置存储器 IC - Ser. Config Mem Flash 16Mb 33 MHz RoHS:否 制造商:Altera Corporation 存储类型:Flash 存储容量:1.6 Mbit 工作频率:10 MHz 电源电压-最大:5.25 V 电源电压-最小:3 V 电源电流:50 uA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:PLCC-20 |
发布紧急采购，3分钟左右您将得到回复。