- 您现在的位置：买卖IC网 > PDF目录18712 > EZLC-4421 HB (Silicon Laboratories Inc)KIT EZLINK F930/SI4421 HIGH BAND PDF资料下载
参数资料
| 型号： | EZLC-4421 HB |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 23/45页 |
| 文件大小： | 0K |
| 描述： | KIT EZLINK F930/SI4421 HIGH BAND |
| 标准包装： | 1 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页当前第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页
Si4421
There are four operation modes:
1. ( a1 =0, a0 =0) Automatic operation of the AFC is off. Strobe bit can be controlled by the microcontroller.
2. ( a1 =0, a0 =1) The circuit measures the frequency offset only once after power up. This way, extended TX-RX distance can be
achieved. In the final application, when the user inserts the battery, the circuit measures and compensates for the frequency offset
caused by the crystal tolerances. This method allows for the use of cheaper quartz in the application and provides protection against
tracking an interferer.
3. ( a1 =1, a0 =0) The frequency offset is calculated automatically and the center frequency is corrected when the VDI is high. The
calculated value is dropped when the VDI goes low. To improve the efficiency of the AFC calculation two methods are recommended:
a. The transmit package should start with a low effective baud rate pattern (i.e.: 00110011) because it is easier to receive. The
circuit automatically measures the frequency offset during this initial pattern and changes the receiving frequency accordingly.
The further part of the package will be received by the corrected frequency settings.
b. The transmitter sends the first part of the packet with a step higher deviation than required during normal operation to ease
the receiving. After the frequency shift was corrected, the deviation can be reduced.
In both cases (3a and 3b), when the VDI indicates poor receiving conditions (VDI goes low), the output register is automatically
cleared. Use this “drop offset” mode when the receiver communicates with more than one transmitter.
4. ( a1 =1, a0 =1) It is similar to mode 3, but suggested to use when a receiver operates with only one transmitter. After a complete
measuring cycle, the measured value is kept independently of the state of the VDI signal. When the receiver is paired with only one
transmitter, it is possible to use this “keep offset” mode. In this case, the DRSSI limit should be selected carefully to minimize the
range hysteresis.
11. TX Configuration Control Command
Bit
15
1
14
0
13
0
12
1
11
1
10
0
9
0
8
mp
7
m3
6
m2
5
m1
4
m0
3
0
2
p2
1
p1
0
p0
POR
9800h
Bits 8-4 (mp, m3 to m0) : FSK modulation parameters:
The resulting output frequency can be calculated as:
f out = f 0 + (-1) SIGN · (M + 1) · (15 kHz)
P out
where:
f0 is the channel center frequency (see the
Frequency Setting Command )
df fsk
df fsk
M is the four bit binary number < m3 : m0>
Note:
SIGN = ( mp ) XOR FSK
For the optimal FSK modulation settings at different
f 0
f out
data rates see the table on page 37.
Bits 2-0 (p2 to p0) : Output power:
mp=0 and FSK=0
or
mp=1 and FSK=1
mp=0 and FSK=1
or
mp=1 and FSK=0
p2
0
p1
0
p0
0
Relative Output Power [dB]
0
0
0
0
1
1
1
1
0
1
1
0
0
1
1
1
0
1
0
1
0
1
-2.5
-5
-7.5
-10
-12.5
-15
-17.5
Note:
FSK represents the value of the actual data bit .
Note:
The output power given in the table is relative to the
maximum available power, which depends on the
actual antenna impedance. (See: Antenna
Application Note: IA ISM-AN1)
23
相关PDF资料 |
PDF描述 |
|---|---|
| 914CE1-Q1 | SWITCH MINI 1NC 1NO SPDT SNAP |
| SI4136M-EVB | BOARD EVALUATION FOR SI4136 |
| SI4126M-EVB | BOARD EVALUATION FOR SI4126 |
| SI4123M-EVB | BOARD EVALUATION FOR SI4123 |
| GLAA01B | SWITCH TOP PLUNGER SNAP SPDT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EZLC-4421LB | 制造商:Silicon Laboratories Inc 功能描述:EZLink 4421 development kit, 433MHz |
| EZLC4431B1-D434 | 功能描述:射频开发工具 EZLink Kit F930 Si4431 Rev B1 434MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| EZLC4431B1-D868 | 功能描述:射频开发工具 EZLink Kit F930 Si4431 Rev B1 868MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| EZLC-4432 HB | 功能描述:射频开发工具 EZLink Fast Prototype Kit Hiband RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| EZLC-4432 HB/LB KIT | 制造商:Silicon Laboratories Inc 功能描述: |
发布紧急采购，3分钟左右您将得到回复。