- 您现在的位置：买卖IC网 > Datasheet目录325 > FAN53540UCX (Fairchild Semiconductor)IC REG SYNC BUCK 5A 20WLCSP Datasheet资料下载
参数资料
| 型号： | FAN53540UCX |
| 厂商： | Fairchild Semiconductor |
| 文件页数： | 11/15页 |
| 文件大小： | 0K |
| 描述： | IC REG SYNC BUCK 5A 20WLCSP |
| 标准包装： | 1 |
| 系列： | * |
| 其它名称： | FAN53540UCXDKR |
PGOOD Pin
The PGOOD pin is an open-drain that indicates that the IC is
in regulation when its state is open. PGOOD pulls LOW
under the following conditions:
? The IC has operated in cycle-by-cycle current limit for
eight consecutive PWM cycles;
Application Information
Selecting the Inductor
The output inductor must meet both the required inductance
and the energy handling capability of the application. The
inductor value affects the average current limit, output
?
The circuit is disabled, either after a fault occurs or when
EN is LOW; or
voltage ripple, transient response, and efficiency.
The ripple current ( ? I) of the regulator is:
? V ? V OUT ?
? ? ? IN
?
? The IC is performing a soft-start.
Thermal Shutdown
? I ?
V OUT
V IN
? L ? f SW ?
?
(5)
When the die temperature increases, due to a high load
condition and/or a high ambient temperature, the output
switching is disabled until the temperature on the die has
The maximum average load current, I MAX(LOAD) , is related to
the peak current limit, I LIM(PK) , by the ripple current as:
fallen sufficiently. The junction temperature at which the
thermal shutdown activates is nominally 155°C with a
20°C hysteresis.
I MAX ( LOAD ) ? I LIM ( PK ) ?
? I
2
(6)
Minimum Off-Time Effect on Switching
Frequency
t OFF(MIN) is 45 ns, which constrains the maximum V OUT /V IN
that the FAN53540 can provide, while still maintaining a fixed
switching frequency in PWM Mode. Regulation is maintained
even though the regulator is unable to provide sufficient
duty-cycle and operate at 2.4 MHz.
Switching frequency is the lower of 2.4 MHz or:
The FAN53540 is optimized for operation with L=470 nH, but
is stable with inductances up to 1.2 ? H (nominal). The
inductor should be rated to maintain at least 80% of its value
at I LIM(PK) . Failure to do so lowers the amount of DC current
the IC can deliver.
Efficiency is affected by the inductor DCR and inductance
value. Decreasing the inductor value for a given physical
size typically decreases the DCR; but since ? I increases, the
RMS current increases, as do core and skin-effect losses.
f SW ( MHz ) ? 22 . 2 ? ? ? 1 ?
?
?
I OUT ( DC ) 2 ?
? I 2
I RMS ?
?
?
V OUT ? I OUT ? R OFF
V IN ? I OUT ? ( R OFF ? R ON )
?
?
(4)
(7)
12
The increased RMS current produces higher losses through
where:
I OUT = load current, in A;
R ON = R DS(ON)_P + DCR L , in Ohms; and
R OFF = R DS(ON)_N + DCR L , in Ohms.
A result of <0 MHz indicates 100% duty cycle operation.
the R DS(ON) of the IC MOSFETs as well as the inductor ESR.
Increasing the inductor value produces lower RMS currents,
but degrades transient response. For a given physical
inductor size, increased inductance usually results in an
inductor with lower saturation current.
Table 3 shows the effects on regulator performance of higher
inductance than the recommended 470 nH.
Table 3. Inductor Value and Regulator
Performance
I MAX(LOAD)
Increase
? V OUT (EQ. 8)
Decrease
Transient Response
Degraded
Inductor Current Rating
The FAN53540’s current-limit circuit can allow a peak current
of about 8.8 A to flow through L1 under worst-case
conditions. If it is possible for the load to draw that much
continuous current, the inductor should be capable of
sustaining that current or failing in a safe manner.
For space-constrained applications, a lower current rating for
L1 can be used. The FAN53540 may still protect these
inductors in the event of a short circuit, but may not be able
to protect the inductor from failure if the load is able to draw
higher currents than the DC rating of the inductor.
? 2011 Fairchild Semiconductor Corporation
FAN53540 ? Rev. 1.0.3
11
www.fairchildsemi.com
相关PDF资料 |
PDF描述 |
|---|---|
| FAN5626LX | IC LED DVR 6CH INTERFACE 10-UMLP |
| FAN5640S7X | IC LED DRIVER DUAL CC SC70-6 |
| FAN5646S700X | IC LED DRIVER BLINKER SC70-5 |
| FAN5701UMP30X | IC LED DVR MULTI 30MA 16-UMLP |
| FAN5702UC30X | IC LED DVR 6LED 30MA I2C 16WLCSP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FAN53541UCX | 功能描述:直流/直流开关调节器 2.4 MHz 5A TinyBuck Synchronous Buck Reg RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| FAN5354MPX | 功能描述:直流/直流开关调节器 3MHz, 3a TinyBuck Sync Buck Regulator RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| FAN5355 | 制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:1A / 0.8A, 3MHz Digitally Programmable TinyBuckTM Regulator |
| FAN5355_10 | 制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:1A / 0.8A, 3MHz Digitally Programmable Regulator |
| FAN53555BUC08X | 制造商:Fairchild Semiconductor Corporation 功能描述:5A, 2.4 MHZ, DIGITALLY PROGRAMMABLE TINYBUCK TM - Tape and Reel 制造商:Fairchild Semiconductor Corporation 功能描述:IC REG PROGR 4A 2.4MHZ 20WLCSP 制造商:Fairchild Semiconductor Corporation 功能描述:TAPE REEL / 5A, 2.4 MHZ, DIGITALLY PROGRAMMABLE TINYBUCK TM |
发布紧急采购，3分钟左右您将得到回复。