- 您现在的位置：买卖IC网 > PDF目录1922 > FT232BL-REEL (FTDI, Future Technology Devices International Ltd)IC USB FS SERIAL UART 32-LQFP PDF资料下载
参数资料
| 型号： | FT232BL-REEL |
| 厂商： | FTDI, Future Technology Devices International Ltd |
| 文件页数： | 9/34页 |
| 文件大小： | 0K |
| 描述： | IC USB FS SERIAL UART 32-LQFP |
| 产品培训模块： | USB Introduction |
| 标准包装： | 1 |
| 系列： | USBmadeEZ-UART |
| 通道数： | 1，UART |
| FIFO's： | 256 字节 |
| 规程： | RS232，RS422，RS485 |
| 电源电压： | 4.35V ~ 5.25V |
| 带自动流量控制功能： | 是 |
| 带调制解调器控制功能： | 是 |
| 带CMOS： | 是 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-LQFP |
| 供应商设备封装： | 32-LQFP |
| 包装： | 标准包装 |
| 产品目录页面： | 634 (CN2011-ZH PDF) |
| 其它名称： | 768-1009-6 |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页
Copyright 2011 Future Technology Devices International Limited
17
Document No.: FT_000329
FT232BL
/BQ USB UART IC Datasheet Version 2.2
Clearance No.: FTDI#
171
6 USB Power Configurations
The following sections illustrate possible USB power configurations for the FT232B.
6.1 USB Bus Powered Configuration
Figure 6.1 Bus Powered Configuration
Figure 6.1 illustrates a typical USB bus powered configuration. A USB Bus Powered device gets its power
from the USB bus. Basic rules for USB Bus power devices are as follows:
a) On plug-in, the device must draw no more than 100mA
b) On USB Suspend the device must draw no more than 500uA (2.5mA for devices configured to
support remote wake-up).
c) A Bus Powered High Power Device (one that draws more than 100mA) should use the PWREN#
pin to keep the current below 100mA on plug-in and 500uA(2.5mA) on USB suspend.
d) A device that consumes more than 100mA cannot be plugged into a USB Bus Powered Hub
e) No device can draw more that 500mA from the USB Bus.
The power descriptor in the EEPROM should be programmed to match the current draw of the device.
PWRCTL (pin 14) is pulled low to configure the device with a USB Bus Power descriptor. A Ferrite Bead is
connected in series with USB power to prevent noise from the device and associated circuitry (EMI) being
radiated down the USB cable to the Host. The value of the Ferrite Bead depends on the total current
required by the circuit – a suitable range of Ferrite Beads is available from Steward (www.steward.com)
for example Steward Part # MI0805K400R-00, also available as DigiKey Part # 240-1035-1.
相关PDF资料 |
PDF描述 |
|---|---|
| FT232HL-REEL | IC HS USB TO UART/FIFO 48LQFP |
| FT232RL-REEL | IC USB FS SERIAL UART 28-SSOP |
| FT245BL-REEL | IC USB FS PARALLEL FIFO 32-LQFP |
| FT245RL-REEL | IC USB TO PARALLEL FIFO 28-SSOP |
| FT4232HQ-REEL | IC USB HS QUAD UART/SYNC 64-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FT232BL-TRAY | 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB-to-UART 1-CH 128Byte FIFO 5V 32-Pin LQFP Tray |
| FT232BM | 功能描述:UART 接口集成电路 Obsolete FT232BL RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| FT232BQ | 制造商:FTDI 制造商全称:FTDI 功能描述:USB UART ( USB - Serial) I.C. |
| FT232BQ-REEL | 功能描述:USB 接口集成电路 USB to Serial UART IC QFN-32 RoHS:否 制造商:Cypress Semiconductor 产品:USB 2.0 数据速率: 接口类型:SPI 工作电源电压:3.15 V to 3.45 V 工作电源电流: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:WLCSP-20 |
| FT232HL | 制造商:FTDI 制造商全称:FTDI 功能描述:FT232H Single Channel Hi-Speed USB to Multipurpose UART/FIFO IC |
发布紧急采购，3分钟左右您将得到回复。