参数资料
型号: FT232RQ-REEL
厂商: FTDI, Future Technology Devices International Ltd
文件页数: 19/43页
文件大小: 0K
描述: IC USB FS SERIAL UART 32-QFN
产品培训模块: USB Introduction
USB-UART Interface Solutions
标准包装: 1
系列: USBmadeEZ-UART
特点: USB 至 UART
通道数: 1,UART
FIFO's: 256 字节
规程: RS232,RS422,RS485
电源电压: 3.3 V ~ 5.25 V
带自动流量控制功能:
带调制解调器控制功能:
带CMOS:
安装类型: 表面贴装
封装/外壳: 32-VFQFN 裸露焊盘
供应商设备封装: 32-QFN 裸露焊盘(5x5)
包装: 标准包装
产品目录页面: 634 (CN2011-ZH PDF)
配用: 768-1023-ND - MOD USB RS232 DEV/EVAL FT232RL
768-1022-ND - MOD USB UART MINI B DEV FT232R
768-1021-ND - MOD USB UART MINI DEV FT232R
768-1019-ND - MOD USB UART DEV FT232R
其它名称: 768-1008-6
Copyright 2010 Future Technology Devices International Limited
26
Document No.: FT_000053
FT232R USB UART IC Datasheet Version 2.10
Clearance No.: FTDI# 38
6.4 USB Bus Powered with Selectable External Logic Supply
FT232R
A
G
N
D
G
N
D
G
N
D
G
N
D
T
E
S
T
100nF
3V3OUT
VCCIO
NC
RESET#
NC
10nF
TXD
RXD
RTS#
CTS#
DTR#
DSR#
DCD#
RI#
CBUS0
CBUS3
CBUS2
CBUS1
USBDP
USBDM
VCC
1
2
3
4
5
OSCI
OSCO
CBUS4
Ferrite
Bead
+
SHIELD
GND
3.3V or 5V
Supply to
External Logic
100nF
+
100nF
Vcc
4.7uF
GND
1
Jumper
SLEEP#
PWREN#
2
3
Vcc
VCCIO
10K
VCCIO
Figure 6.4 USB Bus Powered with +3.3V or +5V External Logic Power Supply
Figure 6.4 illustrates a USB bus power application with selectable external logic supply. The external logic
can be selected between +3.3V and +5V using the jumper switch. This jumper is used to allow the
FT232R to be interfaced with a +3.3V or +5V logic devices. The VCCIO pin is either supplied with +5V
from the USB bus (jumper pins1 and 2 connected), or from the +3.3V output from the FT232R 3V3OUT
pin (jumper pins 2 and 3 connected). The supply to VCCIO is also used to supply external logic.
With bus powered applications, the following should be noted:
i)
To comply with the 2.5mA current supply limit during USB suspend mode, PWREN# or
SLEEP# signals should be used to power down external logic in this mode. If this is not
possible, use the configuration shown in Section 6.3.
ii)
The maximum current sourced from the USB bus during normal operation should not exceed
100mA, otherwise a bus powered design with power switching (Section 6.3) should be used.
Another possible configuration could use a discrete low dropout (LDO) regulator which is supplied by the
5V on the USB bus to supply between +1.8V and +2.8V to the VCCIO pin and to the external logic. In
this case VCC would be supplied with the +5V from the USB bus and the VCCIO would be supplied from
the output of the LDO regulator. This results in the FT232R I/O pins driving out at between +1.8V and
+2.8V logic levels.
For a USB bus powered application, it is important to consider the following when selecting the regulator:
i)
The regulator must be capable of sustaining its output voltage with an input voltage of
+4.35V. An Low Drop Out (LDO) regulator should be selected.
ii)
The quiescent current of the regulator must be low enough to meet the total current
requirement of <= 2.5mA during USB suspend mode.
A suitable series of LDO regulators that meets these requirements is the MicroChip/Telcom
(www.microchip.com) TC55 series of devices. These devices can supply up to 250mA current and have a
quiescent current of under 1μA.
相关PDF资料
PDF描述
SC16C550BIA44,512 IC UART SINGLE W/FIFO 44-PLCC
SC16C550BIA44,518 IC UART SINGLE W/FIFO 44-PLCC
SC16IS750IPW,128 IC UART I2C/SPI 24-TSSOP
SC16IS740IPW/Q900, IC UART SINGLE W/FIFO 16-TSSOP
XR16L788CQ-F IC UART 64B 3.3V OCTAL 100QFP
相关代理商/技术参数
参数描述
FT232RQ-TRAY 制造商:Future Technology Devices International (FTDI Chip) 功能描述:
FT-23-43 制造商:Amidon 功能描述:Bulk
FT234XD-R 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC USB SERIAL BASIC UART 12DFN 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB to Serial UART Interface
FT234XD-T 功能描述:USB 接口集成电路 USB to Basic Serial UART IC RoHS:否 制造商:Cypress Semiconductor 产品:USB 2.0 数据速率: 接口类型:SPI 工作电源电压:3.15 V to 3.45 V 工作电源电流: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:WLCSP-20
FT-23-77 制造商:Amidon 功能描述: