参数资料
型号: FTLF8528P2BNV
厂商: Finisar Corporation
文件页数: 2/12页
文件大小: 0K
描述: TXRX OPT SFP 8 GB/S 850NM
标准包装: 1
数据速率: 8.5Gbps
波长: 850nm
应用: 以太网
电源电压: 3 V ~ 3.6 V
连接器类型: LC 双工
安装类型: SFP+
产品目录页面: 326 (CN2011-ZH PDF)
其它名称: 775-1046
FTLF8528P2BNV Pluggable SFP+ Product Specification – November 2007
I.
Pin Descriptions
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
Symbol
V EET
T FAULT
T DIS
SDA
SCA
MOD_ABS
RS0
LOS
RS1
V EER
V EER
RD-
RD+
V EER
V CCR
V CCT
V EET
TD+
TD-
V EET
Name/Description
Transmitter Ground (Common with Receiver Ground)
Transmitter Fault.
Transmitter Disable. Laser output disabled on high or open.
2-wire Serial Interface Data Line (MOD-DEF2)
2-wire Serial Interface Clock (MOD-DEF1)
Module Absent, connected to V EET or V EER
Rx Rate Select:
Open or Low =
2.125 or 4.25 Gb/s Fibre Channel (Low Bandwidth)
High =
8.5 Gb/s Fibre Channel (High Bandwidth)
Loss of Signal indication. Logic 0 indicates normal operation.
Tx Rate Select:
Open or Low =
2.125 or 4.25 Gb/s Fibre Channel (Low Bandwidth)
High =
8.5 Gb/s Fibre Channel (High Bandwidth)
Receiver Ground (Common with Transmitter Ground)
Receiver Ground (Common with Transmitter Ground)
Receiver Inverted DATA out. AC Coupled
Receiver Non-inverted DATA out. AC Coupled
Receiver Ground (Common with Transmitter Ground)
Receiver Power Supply
Transmitter Power Supply
Transmitter Ground (Common with Receiver Ground)
Transmitter Non-Inverted DATA in. AC Coupled.
Transmitter Inverted DATA in. AC Coupled.
Transmitter Ground (Common with Receiver Ground)
Ref.
1
2
3
4
4
4
5
6
5
1
1
1
1
1
Notes :
1.
2.
3.
4.
5.
6.
Circuit ground is internally isolated from chassis ground.
T FAULT is an open collector/drain output, which should be pulled up with a 4.7k – 10k Ohms resistor on
the host board if intended for use. Pull up voltage should be between 2.0V to Vcc + 0.3V. A high
output indicates a transmitter fault caused by either the TX bias current or the TX output power
exceeding the preset alarm thresholds. A low output indicates normal operation. In the low state, the
output is pulled to <0.8V.
Laser output disabled on T DIS >2.0V or open, enabled on T DIS <0.8V.
Should be pulled up with 4.7k – 10kohms on host board to a voltage between 2.0V and 3.6V.
MOD_ABS pulls line low to indicate module is plugged in.
Rate select can also be set through the 2-wire bus in accordance with SFF-8472 v. 10.1 3 . Rx Rate
Select is set at Bit 3, Byte 110, Address A2h. Tx Rate Select is set at Bit 3, Byte 118, Address A2h.
Note: writing a “1” selects maximum bandwidth operation. Rate select is the logic OR of the input
state of Rate Select Pin and 2-wire bus.
LOS is open collector output. Should be pulled up with 4.7k – 10kohms on host board to a voltage
between 2.0V and 3.6V. Logic 0 indicates normal operation; logic 1 indicates loss of signal.
? Finisar Corporation November 21, 2007 Rev. B
Page 2
相关PDF资料
PDF描述
FTLX1341E2 TXRX OPT SFP+ 10 GB/S 220M
FTLX1371D3BCL TXRX OPT SFP+ 10 GB/S 220M
FTLX1412D3BCL TXRX OPT XFP 10 GB/S 1310NM
FTLX1412M3BCL TXRX OPT XFP 10 GB/S 1310NM
FTLX1441E2 TXRX OPT X2 10 GB/S 1310NM
相关代理商/技术参数
参数描述
FTLF8528P3BCV 功能描述:光纤发射器、接收器、收发器 2x/4x/8x FC8.5 Gb/s trnscvr LC Conn RoHS:否 制造商:Omron Electronics 产品:Transmitters 数据速率:3.5 Gbps 波长:850 nm 最大工作温度: 最小工作温度: 封装 / 箱体: 封装: 工作电源电压:
FTLF8528P3BNV 功能描述:光纤发射器、接收器、收发器 2x/4x/8x FC8.5 Gb/s trnscvr LC Conn RoHS:否 制造商:Omron Electronics 产品:Transmitters 数据速率:3.5 Gbps 波长:850 nm 最大工作温度: 最小工作温度: 封装 / 箱体: 封装: 工作电源电压:
FTLF8529P3BCV 功能描述:光纤发射器、接收器、收发器 4x/8x/16x FC, 14.025 Gb/s trnscvr RoHS:否 制造商:Omron Electronics 产品:Transmitters 数据速率:3.5 Gbps 波长:850 nm 最大工作温度: 最小工作温度: 封装 / 箱体: 封装: 工作电源电压:
FTLF8529P3BNV 功能描述:光纤发射器、接收器、收发器 4x/8x/16x FC, 14.025 Gb/s trnscvr RoHS:否 制造商:Omron Electronics 产品:Transmitters 数据速率:3.5 Gbps 波长:850 nm 最大工作温度: 最小工作温度: 封装 / 箱体: 封装: 工作电源电压:
FTLF8529P3PNV 制造商:Finisar Corporation 功能描述:TXRX 850NM VCSEL SFP