- 您现在的位置：买卖IC网 > PDF目录2070 > FXMA2104UMX (Fairchild Semiconductor)TRANSLATOR 4BIT DUAL 12-UMLP PDF资料下载
参数资料
| 型号： | FXMA2104UMX |
| 厂商： | Fairchild Semiconductor |
| 文件页数： | 12/15页 |
| 文件大小： | 0K |
| 描述： | TRANSLATOR 4BIT DUAL 12-UMLP |
| 标准包装： | 5,000 |
| 逻辑功能： | 变换器，双向，3 态，开路漏极 |
| 位数： | 4 |
| 输入类型： | 电压 |
| 输出类型： | 电压 |
| 数据速率： | * |
| 通道数： | 4 |
| 输出/通道数目： | 1 |
| 差分 - 输入:输出： | 无/无 |
| 传输延迟（最大）： | 4ns |
| 电源电压： | 1.65 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | * |
| 供应商设备封装： | * |
| 包装： | * |
2011 Fairchild Semiconductor Corporation
www.fairchildsemi.com
FXMA2104 Rev. 1.0.1
6
FXMA2104
—
Dual-S
upply,
4-Bit
Voltage
Translator
/
Buffer
/
Re
peater
/
for
Open-Drain
Applications
Application Information
The FXMA2104 has open-drain I/Os and requires
external pull-up resistors on the eight data I/O pins, as
shown in Figure 3. If a pair of data I/O pins (An/Bn) is not
used, both pins should be tied to GND (or both to VCC).
In this case, pull-down or pull-up resistors are not
required. The recommended values for the pull-up
resistors (RPUs) are 1K to 10K, depending on the total
bus capacitance, the user is free to vary the pull-up
resistor value to meet the maximum I
2C edge rate per
the I
2C specification (UM10204 rev. 03, June 19, 2007).
For example, the maximum edge rate (30% - 70%)
during Fast Mode (400kbit/s) is 300ns. If bus
capacitance is approaching the maximum 400pF, lower
the RPU value to keep the rise time below 300ns (Fast
Mode). Section 7.1 of the I
2C specification provides an
excellent guideline for pull-up resistor sizing.
Theory of Operation
The FXMA2104 is designed for high-performance level
shifting and buffer / repeating in an I
2C application.
Figure 1 shows that each bi-directional channel contains
two series-Npassgates and two dynamic drivers. This
hybrid architecture is highly beneficial in an I
2C
application where auto-direction is a necessity.
For example, during the following three I
2C protocol
events:
Clock Stretching
Slave’s ACK Bit (9
th bit = 0) following a Master’s
Write Bit (8
th bit = 0)
Clock Synchronization and Multi Master
Arbitration
the bus direction needs to change from master-to-slave
to slave-to-master without the occurrence of an edge. If
there is an I
2C translator between the master and slave
in these examples, the I
2C translator must change
direction when both A and B ports are LOW. The
Npassgates can accomplish this task very efficiently
because, when both A and B ports are LOW, the
Npassgates act as a low resistive short between the two
(A and B) ports.
Due to I
2C’s open-drain topology, I2C masters and
slaves are not push-pull drivers. Logic LOWs are “pulled
down” (Isink), while logic HIGHs are “let go” (3-state). For
example, when the master lets go of SCL (SCL always
comes from the master), the rise time of SCL is largely
determined by the RC time constant, where R = RPU and
C = the bus capacitance. If the FXMA2104 is attached
to the master [on the A port] and there is a slave on the
B port, the Npassgates act as a low resistive short
between the ports until either of the port’s VCC/2
thresholds are reached. After the RC time constant has
reached the VCC/2 threshold of either port, the port’s
edge detector triggers both dynamic drivers to drive
their respective ports in the LOW-to-HIGH (LH)
direction, accelerating the rising edge. The resulting rise
time resembles the scope shot in Figure 4. Effectively,
two distinct slew rates appear in rise time. The first slew
rate (slower) is the RC time constant of the bus. The
second slew rate (much faster) is the dynamic driver
accelerating the edge.
If both the A and B ports of the translator are HIGH, a
high-impedance path exists between the A and B ports
because both the Npassgates are turned off. If a master
or slave device decides to pull SCL or SDA LOW, that
device’s driver pulls down (Isink) SCL or SDA until the
edge reaches the A or B port VCC/2 threshold. When
either the A or B port threshold is reached, the port’s
edge detector triggers both dynamic drivers to drive
their respective ports in the HIGH-to-LOW (HL)
direction, accelerating the falling edge.
Figure 4. Waveform C: 600pF, Total RPU: 2.2K
Ω
相关PDF资料 |
PDF描述 |
|---|---|
| FXMAR2102UMX | TRANSLATOR 2BIT DUAL 8-UMLP |
| FXMAR2104UMX | TRANSLATOR 4BIT DUAL 12-UMLP |
| GTLP16616MTD | IC TRANSCVR 17BIT N-INV 56TSSOP |
| GTLP8T306MTC | IC TRSVR 8BIT LVTTL/GTLP 24TSSOP |
| HA1-2556-9 | IC MULTIPLIER 4QUAD VOUT 16-DIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| FXMAR1202UMX | 制造商:Fairchild Semiconductor Corporation 功能描述: |
| FXMAR2102 | 制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:Dual-Supply, 2-Bit Voltage Translator / Isolator for I2C Applications |
| FXMAR2102L8X | 功能描述:转换 - 电压电平 2xSupply 2-Bit Volt Translator/Isolator RoHS:否 制造商:Micrel 类型:CML/LVDS/LVPECL to LVCMOS/LVTTL 传播延迟时间:1.9 ns 电源电流:14 mA 电源电压-最大:3.6 V 电源电压-最小:3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:MLF-8 |
| FXMAR2102UMX | 功能描述:转换 - 电压电平 2xSupply 2-Bit Volt Translator/Isolator RoHS:否 制造商:Micrel 类型:CML/LVDS/LVPECL to LVCMOS/LVTTL 传播延迟时间:1.9 ns 电源电流:14 mA 电源电压-最大:3.6 V 电源电压-最小:3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:MLF-8 |
| FXMAR2104 | 制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:Dual-Supply, 4-Bit Voltage Translator / Isolator for Open-Drain |
发布紧急采购，3分钟左右您将得到回复。