- 您现在的位置：买卖IC网 > PDF目录60615 > GSC24BC02 (GTM CORPORATION) 2-WIRE SERIAL EEPROMS PDF资料下载
参数资料
| 型号： | GSC24BC02 |
| 厂商： | GTM CORPORATION |
| 英文描述： | 2-WIRE SERIAL EEPROMS |
| 中文描述： | 2线串行EEPROM |
| 文件页数： | 6/9页 |
| 文件大小： | 305K |
| 代理商： | GSC24BC02 |
GSC24BC01/02/02/04/08/16
Page: 6/9
ISSUED DATE :2006/06/14
REVISED DATE :
Figure 6. START & STOP DEFINITION
Figure 7. Output ACKNOWLEDGE
Device Addressing
To enable the chip for a read or write operation, an 8-bit device address word followed by a START condition
must be issued. The 1st four bits of the device address word consists of a mandatory ‘1010’ pattern, while the
2nd four bits depend on the particular density being used (refer to Figure 8):
&In the 1K/2K chip, the next 3 bits should correspond to the hard-wired input A2, A1 and A0 device address
bits.
&In the 4K chip, the next 3 bits are the A2 and A1 device address bits and a memory page address bit. The
two device address bits must compare to their corresponding hard-wired input pins.
&In the 8K chip, the next 3 bits include the A2 device address bits with the next 2 bits used for memory
page addressing. The A2 bit must compare to its corresponding hard-wired input pin.
&In the 16K chip does not use any device address bits but instead the 3 bits are used for memory page
addressing.
Figure 8. Device Address
The memory page address bits, P2, P1 and P0 are used to select the page in the array. P2 represents the
most significant bit, while P1 and P0 are considered the next most significant bits.
The eight bit of the device address determines read or write operation. If the R/W bit is high, then a read
operation is initiated. Otherwise, if the R/W bit is low, then a write operation is started.
After comparing the device address and finding a match, the EEPROM device will issue an acknowledgment
by pulling SDA low. If the comparison fails, the chip will return to standby mode.
相关PDF资料 |
PDF描述 |
|---|---|
| GSC24BC04 | 2-WIRE SERIAL EEPROMS |
| GSC24BC08 | 2-WIRE SERIAL EEPROMS |
| GSC24BC16 | 2-WIRE SERIAL EEPROMS |
| GSC2596M | 150 KHz, 2A PWM Step-Down DC/DC Converter |
| GSC3842 | HIGH PERFORMANCE CURRENT MODE CONTROLERS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| GSC24BC04 | 制造商:GTM 制造商全称:GTM 功能描述:2-WIRE SERIAL EEPROMS |
| GSC24BC08 | 制造商:GTM 制造商全称:GTM 功能描述:2-WIRE SERIAL EEPROMS |
| GSC24BC16 | 制造商:GTM 制造商全称:GTM 功能描述:2-WIRE SERIAL EEPROMS |
| GSC-24D/B | 制造商:Crydom 功能描述: |
| GSC25 | 制造商:SLPOWER 制造商全称:SL Power Electronics 功能描述:25 Watt Global Performance Switchers |
发布紧急采购，3分钟左右您将得到回复。