- 您现在的位置：买卖IC网 > PDF目录67683 > IBM25PPC750FX-FB0533T 32-BIT, 700 MHz, RISC PROCESSOR, CBGA292 PDF资料下载
参数资料
| 型号： | IBM25PPC750FX-FB0533T |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 32-BIT, 700 MHz, RISC PROCESSOR, CBGA292 |
| 封装： | 21 X 21 MM, 1 MM PITCH, CERAMIC, BGA-292 |
| 文件页数： | 47/62页 |
| 文件大小： | 452K |
| 代理商： | IBM25PPC750FX-FB0533T |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页当前第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页
DD 2.X
Preliminary
PowerPC 750FX RISC Microprocessor
Body_750FX_DS_DD2.X.fm.2.0
June 9, 2003
5. System Design Information
Page 49 of 63
5.6 64 or 32-Bit Data Bus Mode
This mode selection varies for different design revision (DD) levels. For the 750FX DD2.X, mode setting is
determined by the state of the mode signal, TLBISYNC, at the transition of HRESET from low to high. If TLBI-
SYNC is high when HRESET transitions from active to inactive, 64-bit mode is selected. If TLBISYNC is low
when HRESET transitions from active to inactive, 32-bit mode is selected.
Special Note: (Reduced pin out mode) To transition from a previous processor with reduced pin out mode,
drive TLBISYNC appropriately, leave the DP(0..7) and AP(0..3) pins floating, and disable par-
ity checking. The 750FX does not have APE and DPE pins.
5.7 IIO Voltage Mode Selection
Selection between 1.8V, 2.5V, or 3.3V I/O modes is accomplished by using the BVSEL and L1_TSTCLK
pins:
If BVSEL = 1 and L1_TSTCLK = 0, then the 3.3V mode is enabled.
If BVSEL = 1 and L1_TSTCLK = 1, then the 2.5V mode is enabled.
If BVSEL = 0 and L1_TSTCLK = 1, then the 1.8V mode is enabled.
Note: Do not set BVSEL = 0 and L1_TSTCLK = 0 since it yields an INVALID MODE.
5.8 Thermal Management
This section provides thermal management information for the CBGA package for air cooled applications.
Proper thermal control design is primarily dependent upon the system-level design; that is, the heat sink, air
flow, and the thermal interface material. To reduce the die-junction temperature, heat sinks may be attached
to the package by several methods: adhesive, spring clip to holes in the printed-circuit board or package,
mounting clip, or a screw assembly, see Figure 5-10 Package Exploded Cross-Sectional View with Several
In general, a heat sink is required for all 750FX applications.
A design example is included in this section.
5.8.1 Heat Sink Selection Example
For preliminary heat sink sizing, the die-junction temperature can be expressed as follows:
Table 5-7. Summary of Mode Select
Mode
750FX (DD2.x)
32-bit mode
Sample TLBISYNC to select
HIGH = 64-bit mode
LOW = 32-bit mode
I/O mode selection
3.3V +/- 165mV (BVSEL = 1, L1_TSTCLK = 0) or
2.5V +/- 125mV (BVSEL = 1, L1_TSTCLK = 1) or
1.8V +/- 100mV (BVSEL = 0, L1_TSTCLK = 1)
相关PDF资料 |
PDF描述 |
|---|---|
| IBM25PPC750FX-FB0112T | 32-BIT, 600 MHz, RISC PROCESSOR, CBGA292 |
| IBM25PPC750FX-GB0123T | 32-BIT, 600 MHz, RISC PROCESSOR, CBGA292 |
| IBM25PPC750FX-EB0122T | 32-BIT, 600 MHz, RISC PROCESSOR, CBGA292 |
| IBM25PPC750GLECR5HA3T | 32-BIT, 1000 MHz, RISC PROCESSOR, CBGA292 |
| IBM25PPC750GXEAR5H42T | 32-BIT, 933 MHz, RISC PROCESSOR, CBGA292 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IBM25PPC750FX-FB1013T | 制造商:IBM 功能描述:32-BIT, 733 MHZ, RISC PROCESSOR, CBGA292 |
| IBM25PPC750FX-FB2513T | 制造商:IBM 功能描述:32-BIT, 800 MHz, RISC PROCESSOR, CBGA292 |
| IBM25PPC750FX-GB0122V | 制造商:IBM 功能描述:MPU 750XX RISC 32BIT - Trays |
| IBM25PPC750FX-GB0132T | 制造商:IC'S/TRANSISTORS/DIO 功能描述: 制造商:IC'S/TRANSISTORS/DIODES 功能描述: |
| IBM25PPC750FX-GB0132V | 制造商:IBM 功能描述:MPU 750XX RISC 32BIT - Trays |
发布紧急采购，3分钟左右您将得到回复。