参数资料
型号: ICS84314AY-02LF
元件分类: 时钟产生/分配
英文描述: 700 MHz, OTHER CLOCK GENERATOR, PQFP32
封装: 7 X 7 MM, 1.40 MM HEIGHT, ROHS COMPLIANT, MS-026BBA, LQFP-32
文件页数: 5/17页
文件大小: 856K
代理商: ICS84314AY-02LF
84314AY-02
www.icst.com/products/hiperclocks.html
REV. B NOVEMBER 17, 2005
13
Integrated
Circuit
Systems, Inc.
ICS84314-02
700MHZ, CRYSTAL-TO-3.3V/2.5V LVPECL
FREQUENCY SYNTHESIZER W/FANOUT BUFFER
PRELIMINARY
The following component footprints are used in this layout
example: All the resistors and capacitors are size 0603.
POWER AND GROUNDING
Place the decoupling capacitors C14 and C15 as close as
possible to the power pins. If space allows, placing the
decoupling capacitor at the component side is preferred. This
can reduce unwanted inductance between the decoupling ca-
pacitor and the power pin generated by the via.
Maximize the pad size of the power (ground) at the decoupling
capacitor. Maximize the number of vias between power (ground)
and the pads. This can reduce the inductance between the
power (ground) plane and the component power (ground) pins.
If V
CCA shares the same power supply with VCC, insert the RC
filter R7, C11, and C16 in between. Place this RC filter as close
to the V
CCA as possible.
CLOCKTRACES ANDTERMINATION
The component placements, locations and orientations should
be arranged to achieve the best clock signal quality. Poor clock
signal quality can degrade the system performance or cause
system failure. In the synchronous high-speed digital system,
the clock signal is less tolerable to poor signal quality than other
signals. Any ringing on the rising or falling edge or excessive
ring back can cause system failure. The trace shape and the
trace delay might be restricted by the available space on the
board and the component location. While routing the traces, the
clock signal traces should be routed first and should be locked
prior to routing other signal traces.
The traces with 50
Ω transmission lines TL1 and TL2
at FOUT and nFOUT should have equal delay and
run adjacent to each other. Avoid sharp angles on the
clock trace. Sharp angle turns cause the characteris-
tic impedance to change on the transmission lines.
Keep the clock trace on the same layer. Whenever pos-
sible, avoid any vias on the clock traces. Any via on the
trace can affect the trace characteristic impedance and
hence degrade signal quality.
To prevent cross talk, avoid routing other signal traces
in parallel with the clock traces. If running parallel traces
is unavoidable, allow more space between the clock
trace and the other signal trace.
Make sure no other signal trace is routed between the
clock trace pair.
The matching termination resistors R1, R2, R3 and R4
should be located as close to the receiver input pins as
possible. Other termination schemes can also be used but
are not shown in this example.
CRYSTAL
The crystal X1 should be located as close as possible to the
pins 25 (XTAL_IN) and 26 (XTAL_OUT). The trace length be-
tween the X1 and U1 should be kept to a minimum to avoid
unwanted parasitic inductance and capacitance. Other sig-
nal traces should not be routed near the crystal traces.
FIGURE 6B. PCB BOARD LAYOUT FOR ICS84314-02
相关PDF资料
PDF描述
ICS84314AYLFT 350 MHz, OTHER CLOCK GENERATOR, PQFP32
ICS84314AYLF 350 MHz, OTHER CLOCK GENERATOR, PQFP32
ICS84314AY 350 MHz, OTHER CLOCK GENERATOR, PQFP32
ICS84314AYLFT 350 MHz, OTHER CLOCK GENERATOR, PQFP32
ICS8431AM-21LF 350 MHz, OTHER CLOCK GENERATOR, PDSO28
相关代理商/技术参数
参数描述
ICS84314AY-02LFT 功能描述:IC SYNTHESIZER 700MHZ 32-LQFP RoHS:是 类别:集成电路 (IC) >> 时钟/计时 - 时钟发生器,PLL,频率合成器 系列:HiPerClockS™ 标准包装:1,000 系列:- 类型:时钟/频率合成器,扇出分配 PLL:- 输入:- 输出:- 电路数:- 比率 - 输入:输出:- 差分 - 输入:输出:- 频率 - 最大:- 除法器/乘法器:- 电源电压:- 工作温度:- 安装类型:表面贴装 封装/外壳:56-VFQFN 裸露焊盘 供应商设备封装:56-VFQFP-EP(8x8) 包装:带卷 (TR) 其它名称:844S012AKI-01LFT
ICS84314AY-02T 制造商:ICS 制造商全称:ICS 功能描述:700MHZ, CRYSTAL-TO-3.3V/2.5V LVPECL FREQUENCY SYNTHESIZER W/FANOUT BUFFER
ICS84314AYLF 功能描述:IC SYNTHESIZER 350MHZ 32-LQFP RoHS:是 类别:集成电路 (IC) >> 时钟/计时 - 时钟发生器,PLL,频率合成器 系列:HiPerClockS™ 标准包装:1,000 系列:- 类型:时钟/频率合成器,扇出分配 PLL:- 输入:- 输出:- 电路数:- 比率 - 输入:输出:- 差分 - 输入:输出:- 频率 - 最大:- 除法器/乘法器:- 电源电压:- 工作温度:- 安装类型:表面贴装 封装/外壳:56-VFQFN 裸露焊盘 供应商设备封装:56-VFQFP-EP(8x8) 包装:带卷 (TR) 其它名称:844S012AKI-01LFT
ICS84314AYLFT 功能描述:IC SYNTHESIZER 350MHZ 32-LQFP RoHS:是 类别:集成电路 (IC) >> 时钟/计时 - 时钟发生器,PLL,频率合成器 系列:HiPerClockS™ 标准包装:1,000 系列:- 类型:时钟/频率合成器,扇出分配 PLL:- 输入:- 输出:- 电路数:- 比率 - 输入:输出:- 差分 - 输入:输出:- 频率 - 最大:- 除法器/乘法器:- 电源电压:- 工作温度:- 安装类型:表面贴装 封装/外壳:56-VFQFN 裸露焊盘 供应商设备封装:56-VFQFP-EP(8x8) 包装:带卷 (TR) 其它名称:844S012AKI-01LFT
ICS84314AYT 制造商:ICS 制造商全称:ICS 功能描述:350MHZ, CRYSTAL-TO-3.3V/2.5V LVPECL FREQUENCY SYNTHESIZER W/FANOUT BUFFER