参数资料
型号: ICS93722CFLFT
厂商: INTEGRATED DEVICE TECHNOLOGY INC
元件分类: 时钟及定时
英文描述: 93722 SERIES, PLL BASED CLOCK DRIVER, 6 TRUE OUTPUT(S), 6 INVERTED OUTPUT(S), PDSO28
封装: 0.209 INCH, LEAD FREE, MO-150, SSOP-28
文件页数: 5/7页
文件大小: 84K
代理商: ICS93722CFLFT
IDTTM/ICSTM Low Cost DDR Phase Lock Loop Zero Delay Buffer
ICS93722
REV F 02/11/07
ICS93722
Low Cost DDR Phase Lock Loop Zero Delay Buffer
1.
The ICS clock generator is a slave/receiver, I
2C component. It can read back the data stored in the latches for verification.
Read-Back will support Intel PIIX4 "Block-Read" protocol.
2.
The data transfer rate supported by this clock generator is 100K bits/sec or less (standard mode)
3.
The input is operating at 3.3V logic levels.
4.
The data byte format is 8 bit bytes.
5.
To simplify the clock generator I
2C interface, the protocol is set to use only "Block-Writes" from the controller. The bytes
must be accessed in sequential order from lowest to highest byte with the ability to stop after any complete byte has been
transferred. The Command code and Byte count shown above must be sent, but the data is ignored for those two bytes.
The data is loaded until a Stop sequence is issued.
6.
At power-on, all registers are set to a default condition, as shown.
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D4(H)
ACK
Dummy Command Code
ACK
Dummy Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Byte 7
ACK
Stop Bit
How to Write:
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D5(H)
ACK
Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Byte 7
Stop Bit
How to Read:
General I
2C serial interface information
The information in this section assumes familiarity with I
2C programming.
For more information, contact ICS for an I
2C programming application note.
How to Write:
Controller (host) sends a start bit.
Controller (host) sends the write address D4
(H)
ICS clock will
acknowledge
Controller (host) sends a dummy command code
ICS clock will
acknowledge
Controller (host) sends a dummy byte count
ICS clock will
acknowledge
Controller (host) starts sending first byte (Byte 0)
through byte 6
ICS clock will
acknowledge each byte one at a
time.
Controller (host) sends a Stop bit
How to Read:
Controller (host) will send start bit.
Controller (host) sends the read address D5
(H)
ICS clock will
acknowledge
ICS clock will send the
byte count
Controller (host) acknowledges
ICS clock sends first byte
(Byte 0) through byte
7
Controller (host) will need to acknowledge each
byte
Controller (host) will send a stop bit
Notes:
相关PDF资料
PDF描述
ICS95VLP857AKLF-T PLL BASED CLOCK DRIVER, 10 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQCC40
ICS97U877AKT 97U SERIES, PLL BASED CLOCK DRIVER, 10 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQCC40
ICS95V857ALLF-T 95V SERIES, PLL BASED CLOCK DRIVER, 10 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO48
ICS95V857AGILF-T PLL BASED CLOCK DRIVER, 10 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO48
IF180C52TXXX-30D 8-BIT, MROM, 30 MHz, MICROCONTROLLER, PQFP44
相关代理商/技术参数
参数描述
ICS93722YFLFT 制造商:ICS 制造商全称:ICS 功能描述:Low Cost DDR Phase Lock Loop Zero Delay Buffer
ICS93725 制造商:ICS 制造商全称:ICS 功能描述:DDR and SDRAM Zero Delay Buffer
ICS93725YFT 制造商:ICS 制造商全称:ICS 功能描述:DDR and SDRAM Zero Delay Buffer
ICS93732 制造商:ICS 制造商全称:ICS 功能描述:Low Cost DDR Phase Lock Loop Zero Delay Buffer
ICS93732AF 功能描述:IC DDR PLL ZD BUFFER 28-SSOP RoHS:否 类别:集成电路 (IC) >> 时钟/计时 - 专用 系列:- 标准包装:28 系列:- 类型:时钟/频率发生器 PLL:是 主要目的:Intel CPU 服务器 输入:时钟 输出:LVCMOS 电路数:1 比率 - 输入:输出:3:22 差分 - 输入:输出:无/是 频率 - 最大:400MHz 电源电压:3.135 V ~ 3.465 V 工作温度:0°C ~ 85°C 安装类型:表面贴装 封装/外壳:64-TFSOP (0.240",6.10mm 宽) 供应商设备封装:64-TSSOP 包装:管件