- 您现在的位置：买卖IC网 > PDF目录383110 > IP82C59A-5 (INTERSIL CORP) CMOS Priority Interrupt Controller PDF资料下载
参数资料
| 型号： | IP82C59A-5 |
| 厂商： | INTERSIL CORP |
| 元件分类： | 中断控制器 |
| 英文描述： | CMOS Priority Interrupt Controller |
| 中文描述： | 80C86; 80C88; 80C286; 8080; 8085; 8086; 8088; 80286; NSC800 COMPATIBLE, INTERRUPT CONTROLLER, PDIP28 |
| 封装： | PLASTIC, DIP-28 |
| 文件页数： | 12/20页 |
| 文件大小： | 152K |
| 代理商： | IP82C59A-5 |
4-12
The Special Mask Mode is set by OCW3 where: ESMM = 1,
SMM = 1, and cleared where ESMM = 1, SMM = 0.
Poll Command
In this mode, the INT output is not used or the microproces-
sor internal Interrupt Enable flip flop is reset, disabling its
interrupt input. Service to devices is achieved by software
using a Poll command.
The Poll command is issued by setting P = 1 in OCW3. The
82C59A treats the next RD pulse to the 82C59A (i.e., RD =
0, CS = 0) as an interrupt acknowledge, sets the appropriate
IS bit if there is a request, and reads the priority level. Inter-
rupt is frozen from WR to RD.
The word enabled onto the data bus during RD is:
W0 - W2: Binary code of the highest priority level request-
ing service.
I:
Equal to a “1” if there is an interrupt.
This mode is useful if there is a routine command common to
several levels so that the INTA sequence is not needed (saves
ROM space). Another application is to use the poll mode to
expand the number of priority levels to more than 64.
Reading the 82C59A Status
The input status of several internal registers can be read to
update the user information on the system. The following
registers can be read via OCW3 (lRR and ISR) or OCW1
(lMR).
Interrupt Request Register (IRR):
8-bit register which con-
tains the levels requesting an interrupt to be acknowledged.
The highest request level is reset from the lRR when an
interrupt is acknowledged. lRR is not affected by lMR.
In-Service Register (ISR):
8-bit register which contains the
priority levels that are being serviced. The ISR is updated
when an End of Interrupt Command is issued.
Interrupt Mask Register:
8-bit register which contains the
interrupt request lines which are masked.
The lRR can be read when, prior to the RD pulse, a Read
Register Command is issued with OCW3 (RR = 1, RIS = 0).
The ISR can be read when, prior to the RD pulse, a Read
Register Command is issued with OCW3 (RR = 1, RIS = 1).
There is no need to write an OCW3 before every status read
operation, as long as the status read corresponds with the
previous one: i.e., the 82C59A “remembers” whether the lRR
or ISR has been previously selected by the OCW3. This is
not true when poll is used. In the poll mode, the 82C59A
D7
D6
D5
D4
D3
D2
D1
D0
I
-
-
-
-
W2
W1
W0
EDGE
SENSE
LATCH
LTIM BIT
0 = EDGE
1 = LEVEL
V
CC
IR
8080/85
MODE
80C86/
88/286
MODE
INTA
FREEZE
INTA
FREEZE
FREEZE
READ
IRR
WRITE
MASK
READ IMR
READ ISR
MASTER CLEAR
MASK LATCH
REQUEST
LATCH
IN - SERVICE
LATCH
NON-
MASKED
REQ
CLR
Q
SET
TO OTHER PRIORITY CELLS
PRIORITY
RESOLVER
CONTROL
LOGIC
SET ISR
CLR ISR
ISR BIT
Q
D
C
CLR
Q
D
C Q
CLR
SET
Q
NOTES:
1. Master clear active only during ICW1.
2. FREEZE is active during INTA and poll sequence only.
3. Truth Table for D-latch.
FIGURE 9. PRIORITY CELL - SIMPLIFIED LOGIC DIAGRAM
C
D
Q
Operation
1
D1
D1
Follow
0
X
Qn-1
Hold
82C59A
相关PDF资料 |
PDF描述 |
|---|---|
| IP82C59A-12 | CMOS Priority Interrupt Controller |
| IP82C83H | CMOS Octal Latching Inverting Bus Driver |
| IP82C84A | CMOS Clock Generator Driver |
| IP82C86H | CMOS Octal Bus Transceiver |
| IP82C86H-5 | CMOS Octal Bus Transceiver |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IP82C59AS2064 | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Harris Corporation 功能描述: |
| IP82C82 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| IP82C82/+ | 制造商:未知厂家 制造商全称:未知厂家 功能描述:8-Bit Non-Inverting Buffer/Driver |
| IP82C83H | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:CMOS Octal Latching Inverting Bus Driver |
| IP82C84A | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:CMOS Clock Generator Driver |
发布紧急采购，3分钟左右您将得到回复。