参数资料
| 型号： | IR3082MTRPBF |
| 厂商： | International Rectifier |
| 文件页数： | 10/33页 |
| 文件大小： | 0K |
| 描述： | IC CTLR XPHASE 20-MLPQ |
| 标准包装： | 3,000 |
| 系列： | XPhase™ |
| 应用： | 处理器 |
| 电流 - 电源： | 10mA |
| 电源电压： | 9.6 V ~ 16 V |
| 工作温度： | 0°C ~ 100°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-MLPQ |
| 供应商设备封装： | 20-MLPQ（5x5） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页
IR3082P b F
The advantage of sensing the inductor current versus high side or low side sensing is that actual output current
being delivered to the load is obtained rather than peak or sampled information about the switch currents. The
output voltage can be positioned to meet a load line based on real time information. Except for a sense resistor in
series with the inductor, this is the only sense method that can support a single cycle transient response. Other
methods provide no information during either load increase (low side sensing) or load decrease (high side sensing).
An additional problem associated with peak or valley current mode control for voltage positioning is that they suffer
from peak-to-average errors. These errors will show in many ways but one example is the effect of frequency
variation. If the frequency of a particular unit is 10% low, the peak to peak inductor current will be 10% larger and
the output impedance of the converter will drop by about 10%. Variations in inductance, current sense amplifier
bandwidth, PWM prop delay, any added slope compensation, input voltage, and output voltage are all additional
sources of peak-to-average errors.
Current Sense Amplifier
A high speed differential current sense amplifier is located in the Phase IC, as shown in figure 6. Its gain decreases
with increasing temperature and is nominally 34 at 25oC and 29 at 125oC (-1470 ppm/oC). This reduction of gain
tends to compensate the 3850 ppm/oC increase in inductor DCR. Since in most designs the Phase IC junction is
hotter than the inductor these two effects tend to cancel such that no additional temperature compensation of the
load line is required.
The current sense amplifier can accept positive differential input up to 100mV and negative up to -20mV before
clipping. The output of the current sense amplifier is summed with the DAC voltage and sent to the Control IC and
other Phases through an on-chip 10K ? resistor connected to the ISHARE pin. The ISHARE pins of all the phases
are tied together and the voltage on the share bus represents the total current through all the inductors and is used
by the Control IC for voltage positioning and current limit protection.
L
Rcs
RL
Ccs
Co
CSOUT
+
CS A M P
-
Figure 6 – Inductor Current Sensing and Current Sense Amplifier
Average Current Share Loop
Current sharing between phases of the converter is achieved by the average current share loop in each Phase IC.
The output of the current sense amplifier is compared with the share bus less a 20mV offset. If current in a phase is
smaller than the average current, the share adjust amplifier of the phase will activate a current source that reduces
the slope of its PWM ramp thereby increasing its duty cycle and output current. The crossover frequency of the
current share loop can be programmed with a capacitor at the SCOMP pin so that the share loop does not interact
with the output voltage loop.
Page 10 of 33
01/31/05
相关PDF资料 |
PDF描述 |
|---|---|
| IR3084AMPBF | IC XPHASE CONTROL 28-MLPQ |
| IR3084MTRPBF | IC CTLR XPHASE 28-MLPQ |
| IR3084UMPBF | IC XPHASE CONTROL 28-MLPQ |
| IR3086AMPBF | IC PHASE CONTROLLER OVP 20MLPQ |
| IR3086MPBF | IC CONTROLLER PHASE 20MLPQ |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IR3083MPBF | 制造商:International Rectifier 功能描述:IC XPHASE CONTROL SMD 3083 |
| IR3084 | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASETM VR 10/11 CONTROL IC |
| IR3084A | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE TM VR 10/11 CONTROL IC |
| IR3084AMPBF | 功能描述:IC XPHASE CONTROL 28-MLPQ RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:XPhase™ 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像，声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP（8x8） 包装:管件 |
| IR3084AMTRPBF | 功能描述:开关变换器、稳压器与控制器 VR10 VR11 Athlon64 XPHASE CTRL IC RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。