参数资料
| 型号： | IR3086MPBF |
| 厂商： | International Rectifier |
| 文件页数： | 9/34页 |
| 文件大小： | 0K |
| 描述： | IC CONTROLLER PHASE 20MLPQ |
| 标准包装： | 5 |
| 系列： | XPhase™ |
| 应用： | 处理器 |
| 电流 - 电源： | 10mA |
| 电源电压： | 8.4 V ~ 14 V |
| 工作温度： | 0°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-MLPQ |
| 供应商设备封装： | 20-MLPQ（4x4） |
| 包装： | 剪切带 (CT) |
| 其它名称： | *IR3086MPBF |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页
IR3086
PHASE IC
CLOCK
PULSE
EAIN
PWMRMP
GATEH
GATEL
VDAC
91% VDAC
STEADY-STATE
OPERATION
DUTY CYCLE INCREASE
DUE TO LOAD
INCREASE
DUTY CYCLE DECREASE
DUE TO VIN INCREASE
(FEED-FORWARD)
DUTY CYCLE DECREASE DUE TO LOAD
DECREASE (BODY BRAKING) OR FAULT
(VCC UV, VCCVID UV, OCP, VID=11111X)
STEADY-STATE
OPERATION
Figure 4. PWM Operating Waveforms
Body Braking TM
In a conventional synchronous buck converter, the minimum time required to reduce the current in the inductor in
response to a load step decrease is;
T SLEW =
L * ( I MAX ? I MIN )
V O
The slew rate of the inductor current can be significantly increased by turning off the synchronous rectifier in
response to a load step decrease. The switch node voltage is then forced to decrease until conduction of the
synchronous rectifier’s body diode occurs. This increases the voltage across the inductor from Vo to Vo +
V BODYDIODE . The minimum time required to reduce the current in the inductor in response to a load transient
decrease is now;
T SLEW =
L * ( I MAX ? I MIN )
V O + V BODYDIODE
Since the voltage drop in the body diode is often higher than output voltage, the inductor current slew rate can be
increased by 2X or more. This patent pending technique is referred to as “body braking” and is accomplished
through the “0% Duty Cycle Comparator” located in the Phase IC. If the Error Amplifier’s output voltage drops below
91% of the VDAC voltage this comparator turns off the low side gate driver.
Lossless Average Inductor Current Sensing
Inductor current can be sensed by connecting a resistor and a capacitor in parallel with the inductor and measuring
the voltage across the capacitor, as shown in Figure 5. The equation of the sensing network is,
v CS ( s ) = v L ( s )
1
1 + sR CS C CS
= i L ( s )
R L + sL
1 + sR CS C CS
Usually the resistor Rcs and capacitor Ccs are chosen so that the time constant of Rcs and Ccs equals the time
constant of the inductor which is the inductance L over the inductor DCR (R L ). If the two time constants match, the
voltage across Ccs is proportional to the current through L, and the sense circuit can be treated as if only a sense
resistor with the value of R L was used. The mismatch of the time constants does not affect the measurement of
inductor DC current, but affects the AC component of the inductor current.
Page 9 of 34
9/30 /04
相关PDF资料 |
PDF描述 |
|---|---|
| IR3087MPBF | IC XPHASE W/OVP/TM CTRL 20MLPQ |
| IR3087M | IC XPHASE W/OVP/TM CTRL 20-MLPQ |
| IR3088AMPBF | IC XPHASE CONTROL 20L-MLPQ |
| IR3088AMTR | IC XPHASE W/FAULT DET 20L-MLPQ |
| IR3088MTRPBF | IC CTLR XPHASE 28-MLPQ |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IR3086MTR | 制造商:IRF 制造商全称:International Rectifier 功能描述:PHASE IC WITH OVP, FAULT AND OVERTEMP DETECT |
| IR3086MTRPBF | 功能描述:IC CTLR XPHASE 28-MLPQ RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:XPhase™ 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像，声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP（8x8） 包装:管件 |
| IR3087 | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE PHASE IC WITH OPTI-PHASE, OVP, AND OVERTEMP DETECT |
| IR3087M | 功能描述:IC XPHASE W/OVP/TM CTRL 20-MLPQ RoHS:否 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:XPhase™ 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像，声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP（8x8） 包装:管件 |
| IR3087MPBF | 功能描述:IC XPHASE W/OVP/TM CTRL 20MLPQ RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:XPhase™ 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像，声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP（8x8） 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。