参数资料
型号: IR3500
厂商: International Rectifier
英文描述: XPHASE3TM VR11.0 & AMD PVID CONTROL IC
中文描述: XPHASE3TM VR11.0
文件页数: 10/47页
文件大小: 778K
代理商: IR3500
IR3500
Page 10 of 47
June 12, 2007
Frequency and Phase Timing Control
The oscillator and system clock frequency is programmable from 250kHz to 9MHZ by an external resistor (ROSC).
The control IC system clock signal (CLKOUT) is connected to CLKIN of all the phase ICs. The phase timing of the
phase ICs is controlled by the daisy chain loop, where control IC phase clock output (PHSOUT) is connected to the
phase clock input (PHSIN) of the first phase IC, and PHSOUT of the first phase IC is connected to PHSIN of the
second phase IC, etc. and PHSOUT of the last phase IC is connected back to PHSIN of the control IC. During
power up, the control IC sends out clock signals from both CLKOUT and PHSOUT pins and detects the feedback at
PHSIN pin to determine the phase number and monitor any fault in the daisy chain loop. Figure 5 shows the phase
timing for a four phase converter. The switching frequency is set by the resistor ROSC as shown in Figure 23. The
clock frequency equals the number of phase times the switching frequency.
Phase IC1
PWM Latch SET
Control IC CLKOUT
(Phase IC CLKIN)
Control IC PHSOUT
(Phase IC1 PHSIN)
Phase IC 1 PHSOUT
(Phase IC2 PHSIN)
Phase IC 2 PHSOUT
(Phase IC3 PHSIN)
Phase IC 3 PHSOUT
(Phase IC4 PHSIN)
Phase IC4 PHSOUT
(Control IC PHSIN)
Figure 5 - Four Phase Oscillator Waveforms
PWM Operation
The PWM comparator is located in the phase IC. Upon receiving the falling edge of a clock pulse, the PWM latch is
set; the PWM ramp voltage begins to increase; the low side driver is turned off, and the high side driver is then
turned on after the non-overlap time. When the PWM ramp voltage exceeds the error amplifier’s output voltage the
PWM latch is reset. This turns off the high side driver, then turns on the low side driver after the non-overlap time,
and activates the ramp discharge clamp. The ramp discharge clamp quickly discharges the PWM ramp capacitor to
the output voltage of the share adjust amplifier in the phase IC until the next clock pulse.
The PWM latch is reset dominant allowing all phases to go to zero duty cycle within a few tens of nanoseconds in
response to a load step decrease. Phases can overlap and go up to 100% duty cycle in response to a load step
increase with turn-on gated by the clock pulses. An error amplifier output voltage greater than the common mode
input range of the PWM comparator results in 100% duty cycle regardless of the voltage of the PWM ramp. This
arrangement guarantees the error amplifier is always in control and can demand 0 to 100% duty cycle as required.
It also favors response to a load step decrease which is appropriate given the low output to input voltage ratio of
相关PDF资料
PDF描述
IR3500MPBF XPHASE3TM VR11.0 & AMD PVID CONTROL IC
IR3500MTRPBF XPHASE3TM VR11.0 & AMD PVID CONTROL IC
IR3623MPBF HIGH FREQUENCY 2-PHASE, SINGLE OR DUAL OUTPUT SYNCHRONOUS STEP DOWN CONTROLLER WITH OUTPUT TRACKING AND SEQUENCING
IR3624MPBF HIGH FREQUENCY SYNCHRONOUS PWM BUCK CONTROLLER
IR3624MTRPBF HIGH FREQUENCY SYNCHRONOUS PWM BUCK CONTROLLER
相关代理商/技术参数
参数描述
IR3500A 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM VR11.0 & AMD PVID CONTROL IC
IR3500AMPBF 功能描述:IC CTRL XPHASE3 VR11.0 32-MLPQ RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:XPhase3™ 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像,声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP(8x8) 包装:管件
IR3500AMTRPBF 功能描述:开关变换器、稳压器与控制器 IR3500 IC xPHASE3 AMD PVID CTRL IC RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel
IR3500MPBF 功能描述:IC XPHASE3 CONTROL 32-MLPQ RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:XPhase3™ 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像,声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP(8x8) 包装:管件
IR3500MTRPBF 功能描述:开关变换器、稳压器与控制器 COMPLETE VR11.0 OR AMD PVID PWR SOLTION RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel