- 您现在的位置：买卖IC网 > PDF目录384487 > IR3500 (International Rectifier) XPHASE3TM VR11.0 & AMD PVID CONTROL IC PDF资料下载
参数资料
| 型号： | IR3500 |
| 厂商： | International Rectifier |
| 英文描述： | XPHASE3TM VR11.0 & AMD PVID CONTROL IC |
| 中文描述： | XPHASE3TM VR11.0 |
| 文件页数： | 12/47页 |
| 文件大小： | 778K |
| 代理商： | IR3500 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页当前第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页
IR3500
Page 12 of 47
June 12, 2007
CS
CS
L
L
CS
CS
L
C
C
sR
sL
R
s
i
C
sR
s
v
s
v
+
+
=
+
=
1
)
(
1
1
)
(
)
(
Usually the resistor Rcs and capacitor Ccs are chosen so that the time constant of Rcs and Ccs equals the time
constant of the inductor which is the inductance L over the inductor DCR (R
L
). If the two time constants match, the
voltage across Ccs is proportional to the current through L, and the sense circuit can be treated as if only a sense
resistor with the value of R
L
was used. The mismatch of the time constants does not affect the measurement of
inductor DC current, but affects the AC component of the inductor current.
Figure 7 - Inductor Current Sensing and Current Sense Amplifier
The advantage of sensing the inductor current versus high side or low side sensing is that actual output current
being delivered to the load is obtained rather than peak or sampled information about the switch currents. The
output voltage can be positioned to meet a load line based on real time information. Except for a sense resistor in
series with the inductor, this is the only sense method that can support a single cycle transient response. Other
methods provide no information during either load increase (low side sensing) or load decrease (high side sensing).
An additional problem associated with peak or valley current mode control for voltage positioning is that they suffer
from peak-to-average errors. These errors will show in many ways but one example is the effect of frequency
variation. If the frequency of a particular unit is 10% low, the peak to peak inductor current will be 10% larger and
the output impedance of the converter will drop by about 10%. Variations in inductance, current sense amplifier
bandwidth, PWM prop delay, any added slope compensation, input voltage, and output voltage are all additional
sources of peak-to-average errors.
Current Sense Amplifier
A high speed differential current sense amplifier is located in the phase IC, as shown in Figure 7. Its gain is
nominally 32.5 and the 3850 ppm/oC increase in inductor DCR should be compensated in the voltage loop feedback
path.
The current sense amplifier can accept positive differential input up to 50mV and negative up to -10mV before
clipping. The output of the current sense amplifier is summed with the DAC voltage and sent to the control IC and
other phases through an on-chip 3K
resistor connected to the ISHARE pin. The ISHARE pins of all the phases are
tied together and the voltage on the share bus represents the average current through all the inductors and is used
by the control IC for voltage positioning and current limit protection. The input offset of this amplifier is calibrated to
+/- 1mV in order to reduce the current sense error.
The input offset voltage is the primary source of error for the current share loop. In order to achieve very small input
offset error and superior current sharing performance, the current sense amplifier continuously calibrates itself. This
calibration algorithm creates ripple on ISHARE bus with a frequency of fsw / 896 in a multiphase architecture.
C
O
L
R
L
R
CS
C
CS
V
O
Current
Sense Amp
CSOUT
i
L
v
L
v
CS
c
相关PDF资料 |
PDF描述 |
|---|---|
| IR3500MPBF | XPHASE3TM VR11.0 & AMD PVID CONTROL IC |
| IR3500MTRPBF | XPHASE3TM VR11.0 & AMD PVID CONTROL IC |
| IR3623MPBF | HIGH FREQUENCY 2-PHASE, SINGLE OR DUAL OUTPUT SYNCHRONOUS STEP DOWN CONTROLLER WITH OUTPUT TRACKING AND SEQUENCING |
| IR3624MPBF | HIGH FREQUENCY SYNCHRONOUS PWM BUCK CONTROLLER |
| IR3624MTRPBF | HIGH FREQUENCY SYNCHRONOUS PWM BUCK CONTROLLER |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IR3500A | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM VR11.0 & AMD PVID CONTROL IC |
| IR3500AMPBF | 功能描述:IC CTRL XPHASE3 VR11.0 32-MLPQ RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:XPhase3™ 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像，声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP（8x8） 包装:管件 |
| IR3500AMTRPBF | 功能描述:开关变换器、稳压器与控制器 IR3500 IC xPHASE3 AMD PVID CTRL IC RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
| IR3500MPBF | 功能描述:IC XPHASE3 CONTROL 32-MLPQ RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:XPhase3™ 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像，声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP（8x8） 包装:管件 |
| IR3500MTRPBF | 功能描述:开关变换器、稳压器与控制器 COMPLETE VR11.0 OR AMD PVID PWR SOLTION RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。