- 您现在的位置：买卖IC网 > PDF目录13793 > IR3871MTRPBF (International Rectifier)IC REG BUCK SYNC ADJ 8A PQFN PDF资料下载
参数资料
| 型号： | IR3871MTRPBF |
| 厂商： | International Rectifier |
| 文件页数： | 13/21页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 8A PQFN |
| 产品培训模块： | SupIRBuck? Family and POL Design Tools Overview |
| 标准包装： | 4,000 |
| 系列： | SupIRBuck™ |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.5 V ~ 12 V |
| 输入电压： | 3 V ~ 26 V |
| 频率 - 开关： | 可调至 1MHz |
| 电流 - 输出： | 8A |
| 同步整流器： | 是 |
| 工作温度： | 0°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 17-PowerVQFN |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | PQFN（5x6） |
| 其它名称： | Q5214926 |
IR3871MPBF
CIRCUIT DESCRIPTION
GATE DRIVE LOGIC
The gate drive logic features adaptive dead
time, diode emulation, and a minimum lower
gate interval.
An adaptive dead time prevents the
simultaneous conduction of the upper and lower
MOSFETs. The lower gate voltage (LGATE)
must be below approximately 1V after PWM
goes HIGH before the upper MOSFET can be
gated on. Also, the upper gate voltage
(UGATE), the difference voltage between
UGATE and PHASE, must be below
approximately 1V after PWM goes LOW before
the lower MOSFET can be gated on.
The control MOSFET is gated on after the
adaptive delay for PWM = HIGH and the
synchronous MOSFET is gated on after the
STABILITY CONSIDERATIONS
Constant-on-time control is a fast , ripple based
control scheme. Unstable operation can occur
if certain conditions are not met. The system
instability is usually caused by:
? Switching noise coupled to FB input. This
causes the PWM comparator to trigger
prematurely after the 400ns minimum Q2 on-
time. It will result in double or multiple pulses
every switching cycle instead of the expected
single pulse. Double pulsing can causes
higher output voltage ripple, but in most
application it will not affect operation. This can
usually be prevented by careful layout of the
ground plane and the FB sensing trace.
? Steady state ripple on FB pin being too small.
The PWM comparator in IR3871 requires
minimum 7mVp-p ripple voltage to operate
adaptive delay for PWM = LOW.
The lower
stably. Not enough ripple will result in similar
MOSFET is driven ‘off’ when the signal
ZCROSS indicates that the inductor current has
reversed as detected by the PHASE voltage
crossing the zero current threshold. The
synchronous MOSFET stays ‘off’ until the next
PWM falling edge. When the lower peak of
inductor current is above zero, a forced
continuous current condition is selected. The
control MOSFET is gated on after the adaptive
delay for PWM = HIGH, and the synchronous
MOSFET is gated on after the adaptive delay for
PWM = LOW.
The synchronous MOSFET gate is driven on for
a minimum duration. This minimum duration
double pulsing issue described above. Solving
this may require using output capacitors with
higher ESR.
? ESR loop instability. The stability criteria of
constant on-time is: ESR*Cout>Ton/2. If ESR
is too small that this criteria is violated then
sub-harmonic oscillation will occur. This is
similar to the instability problem of peak-
current-mode control with D>0.5. Increasing
ESR is the most effective way to stabilize the
system, but the price paid is the larger output
voltage ripple.
? For applications with all ceramic output
capacitors, the ESR is usually too small to
allows time to recharge the bootstrap capacitor
meet
the
stability
criteria.
In
these
and allows the current monitor to sample the
PHASE voltage.
applications, external slope compensation is
necessary to make the loop stable. The ramp
injection circuit, composed of R6, C13, and
C14, shown in Figure 7 is required. The
inductor current ripple sensed by R6 and C13
is AC coupled to the FB pin through C14. C14
is usually chosen between 1 to 10nF, and C13
between 10 to 100nF. R6 should then be
chosen such that L/DCR = C13*R6.
13
相关PDF资料 |
PDF描述 |
|---|---|
| GCM43DRYF | CONN EDGECARD 86POS DIP .156 SLD |
| GSM24DREF | CONN EDGECARD 48POS .156 EYELET |
| GMM24DREF | CONN EDGECARD 48POS .156 EYELET |
| EGM06DTMD-S273 | CONN EDGECARD 12POS R/A .156 SLD |
| GMM22DRAN | CONN EDGECARD 44POS R/A .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IR3876MBF | 制造商:IRF 制造商全称:International Rectifier 功能描述:12A HIGHLY INTEGRATED WIDE-INPUT VOLTAGE, SYNCHRONOUS BUCK REGULATOR |
| IR3876MPBF | 制造商:IRF 制造商全称:International Rectifier 功能描述:12A HIGHLY INTEGRATED WIDE-INPUT VOLTAGE, SYNCHRONOUS BUCK REGULATOR |
| IR3876MTR1PBF | 功能描述:直流/直流开关调节器 12A SupIRBuck Reg 1000kHz, 3.0-21V in RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| IR3876MTRPBF | 功能描述:直流/直流开关调节器 12A SupIRBuck Reg 1000kHz, 3.0-21V in RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| IR3876TR1PBF | 制造商:IRF 制造商全称:International Rectifier 功能描述:12A HIGHLY INTEGRATED WIDE-INPUT VOLTAGE, SYNCHRONOUS BUCK REGULATOR |
发布紧急采购，3分钟左右您将得到回复。