- 您现在的位置：买卖IC网 > PDF目录13793 > IR3871MTRPBF (International Rectifier)IC REG BUCK SYNC ADJ 8A PQFN PDF资料下载
参数资料
| 型号： | IR3871MTRPBF |
| 厂商： | International Rectifier |
| 文件页数： | 15/21页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 8A PQFN |
| 产品培训模块： | SupIRBuck? Family and POL Design Tools Overview |
| 标准包装： | 4,000 |
| 系列： | SupIRBuck™ |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.5 V ~ 12 V |
| 输入电压： | 3 V ~ 26 V |
| 频率 - 开关： | 可调至 1MHz |
| 电流 - 输出： | 8A |
| 同步整流器： | 是 |
| 工作温度： | 0°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 17-PowerVQFN |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | PQFN（5x6） |
| 其它名称： | Q5214926 |
IR3871MPBF
COMPONENT SELECTION
OUTPUT CAPACITOR SELECTION
Selection of the output capacitor requires meeting
The second purpose of the output capacitor is to
minimize the overshoot of the output voltage
voltage
overshoot
requirements
during
load
when the load decreases as shown in Figure
removal, and meeting steady state output ripple
voltage requirements. The output capacitor is the
23. By using the law of energy before and after
the load removal, equation 8 shows the output
most
expensive
converter
component
and
capacitance requirement for a load step.
increases the overall system cost. The output
capacitor decoupling in the converter typically
includes the low frequency capacitor, such as
Specialty Polymer Aluminum, and mid frequency
ceramic capacitors.
The first purpose of output capacitors is to provide
current when the load demand exceeds the
inductor current, as shown in Figure 22. Equation
7 shows the charge requirement for a certain load.
The advantage provided by the IR3871 at a load
C OUT ?
V OUT
V L
V DROP
V ESR
L ? I STEP 2
V OS 2 ? V OUT 2
V OS
(8)
step is to reduce the delay compared to a fixed
frequency control method (in microseconds or (1-
D)*Ts). If the load increases right after the PWM
signal goes low, the longest delay will be equal to
the minimum lower gate on as shown in the
I OUT
I STEP
Electrical Specification table. The IR3871 also
reduces the inductor current slew time, the time it
takes for the inductor current to reach equality
Figure 23. Typical Output Voltage Response
Waveform.
with the output current, by increasing
the
BOOT CAPACITOR SELECTION
switching frequency up to 2.5MHz. The result
The boot capacitor starts the cycle fully charged
reduces the recovery time.
to a voltage of VB(0).
Cg equals 0.65nF in
Load
Current
Output
I STEP
IR3871. Choose a sufficiently small ΔV such
that VB(0)- ΔV exceeds the maximum gate
threshold voltage to turn on the high side
C BOOT ? C g ? ? B
? 1 ? (9)
Charge
Inductor
Slew
Rate
MOSFET.
? V (0)
? ΔV
?
?
Δ t
t
Choose a boot capacitor value larger than the
calculated C BOOT in equation 9. Equation 9 is
Figure 22. Charge Requirement during Load Step
based on charge balance at CCM operation.
Q ? C ? V ? 0.5 ? Istep ? ? t
(7a)
Usually the boot capacitor will be discharged to
a much lower voltage when the circuit is
1 ? 1 L ? Istep 2 ?
V DROP ?? 2 ? V IN ? V OUT ? ??
C OUT ?
?
(7b)
operating in DCM mode at light load, due to
much longer Q2 off time and the bias current
drawn by the IC. Boot capacitance needs to be
increased if insufficient turn-on of Q1 is
The output voltage drop, VDROP, initially depends
on the characteristic of the output capacitor.
VDROP is the sum of the equivalent series
inductance (ESL) of the output capacitor times the
rate of change of the output current and the ESR
times the change of the output current. VESR is
usually much greater than VESL. The IR3871
requires a total ESR such that the ripple voltage at
observed at light load, typically larger than
0.1μF is needed. The voltage rating of this part
needs to be larger than VB(0) plus the desired
derating voltage. Its ESR and ESL needs to be
low in order to allow it to deliver the large
current and di/dt’s which drive MOSFETs most
efficiently. In support of these requirements a
ceramic capacitor should be chosen.
the FB pin is greater than 7mV.
15
相关PDF资料 |
PDF描述 |
|---|---|
| GCM43DRYF | CONN EDGECARD 86POS DIP .156 SLD |
| GSM24DREF | CONN EDGECARD 48POS .156 EYELET |
| GMM24DREF | CONN EDGECARD 48POS .156 EYELET |
| EGM06DTMD-S273 | CONN EDGECARD 12POS R/A .156 SLD |
| GMM22DRAN | CONN EDGECARD 44POS R/A .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IR3876MBF | 制造商:IRF 制造商全称:International Rectifier 功能描述:12A HIGHLY INTEGRATED WIDE-INPUT VOLTAGE, SYNCHRONOUS BUCK REGULATOR |
| IR3876MPBF | 制造商:IRF 制造商全称:International Rectifier 功能描述:12A HIGHLY INTEGRATED WIDE-INPUT VOLTAGE, SYNCHRONOUS BUCK REGULATOR |
| IR3876MTR1PBF | 功能描述:直流/直流开关调节器 12A SupIRBuck Reg 1000kHz, 3.0-21V in RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| IR3876MTRPBF | 功能描述:直流/直流开关调节器 12A SupIRBuck Reg 1000kHz, 3.0-21V in RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| IR3876TR1PBF | 制造商:IRF 制造商全称:International Rectifier 功能描述:12A HIGHLY INTEGRATED WIDE-INPUT VOLTAGE, SYNCHRONOUS BUCK REGULATOR |
发布紧急采购，3分钟左右您将得到回复。