- 您现在的位置：买卖IC网 > PDF目录1811 > IRS27952SPBF (International Rectifier)IC DRIVER HALF-BRIDGE 8SOIC PDF资料下载
参数资料
| 型号： | IRS27952SPBF |
| 厂商： | International Rectifier |
| 文件页数： | 14/28页 |
| 文件大小： | 0K |
| 描述： | IC DRIVER HALF-BRIDGE 8SOIC |
| 标准包装： | 95 |
| 输出隔离： | 隔离 |
| 频率范围： | 46.6kHz ~ 285kHz |
| 输入电压： | 12 V ~ 18 V |
| 输出电压： | 12 V ~ 18 V |
| 功率（瓦特）： | 833mW |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOIC |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
IRS27951S
IRS27952(4)S
Multi-function 2 Pin Oscillator
The two pin oscillator is externally programmed by a resistor RT connected between pin#2 and COM and a
capacitor CT, connected from pin#3 to COM. The RT pin provides an accurate 2V reference (±2%) with a 2mA
source capability (higher the current sourced by the pin, the higher is the oscillator frequency).
In normal operation, CT is charged by a current defined by the network connected at the RT pin. The oscillator ramp
charges and discharges between the two ramp thresholds (3 and 5V). When the ramp voltage reaches 5V, it is
internally discharged by a fixed current of 2mA. The fall time for the ramp corresponds to the dead time between the
bridge devices.
At startup, a 10uA internal current source charges the oscillator capacitor at the CT pin to V EN1 . At this point, the IC
is pulled out of sleep mode and the 2V reference voltage at the RT pin is enabled. The low-side device is now also
turned ON to charge the bootstrap capacitor (this sequence at startup or while exiting sleep mode ensures that the
low-side device is always switched on first to charge the bootstrap capacitor which will be ready to supply the high-
side floating driver). The low-side device remains ON till the CT pin voltage reaches the upper ramp threshold of 5V
(see Fig 2).
The programmable features for the oscillator are listed below-
? Wide frequency range:
The high-speed oscillator allows an output frequency from 50 kHz up to 500 kHz.
? Programmable dead-time:
The oscillator timing capacitor CT also programs the dead time between LO and HO.
? Programmable soft-start time:
In resonant converter applications, the output power delivered is an inverse function of frequency i.e. soft- start is
achieved by sweeping the operating frequency from an initial high value until the control loop takes over.
Additionally, the resonant tank has a non-linear frequency dependence that makes the converter’s power transfer
capability change little when the frequency is away from resonance and change very quickly as frequency
approaches the resonant tank frequency.
An R-C series circuit (CSS + RSS) connected between the RT pin and COM programs the soft-start time for the
converter. Initially, the capacitor CSS is totally discharged, so that the series resistor RSS is effectively in parallel to
Rfmin and the resulting initial frequency is determined by RSS and RT only (the optocoupler’s phototransistor is cut
off). During this frequency sweep, the operating frequency will decay following the exponential charge of CSS, that
is, initially it will change relatively quickly but the rate of change will get slower. The CSS capacitor charges until its
voltage reaches 2V and, consequently, the current through RSS is reduced to zero.
The soft-start sequence is activated at normal startup and back to operation from Sleep mode.
? Programmable start-up, minimum and maximum frequency:
In resonant converter applications, it is important to operate the converter in the soft-switching region of operation.
IRS2795(1,2)(4) offers a trimmed voltage reference (±2%) at the RT pin to accurately program the converter
switching frequency range in the desired region of operation.
- The effective resistance (RSS//RT) at pin#2 during IC power up and the CT capacitor program the start-up
frequency of the converter.
- RT and CT program the minimum operating frequency.
November 8 , 2012
14
? 2012 International Rectifier
th
相关PDF资料 |
PDF描述 |
|---|---|
| IRSF3010S | IC FET SMART SW 50V 11A D2PAK |
| IRSF3011LTR | IC DRIVER LO SIDE 50V 5A SOT-223 |
| IRSF3021LTR | IC DRIVER LO SIDE 50V 3A SOT-223 |
| IRSF3031LTR | IC DRVR LO SIDE 50V 1.8A SOT-223 |
| IRU1010-18CYTR | IC REG LDO 1.8V 1A SOT-223 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IRS27952STRPBF | 功能描述:功率驱动器IC Resonant 1/2 Brdg Cntrl IC RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| IRS2980 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:功率半导体 |
| IRS2980S | 制造商:未知厂家 制造商全称:未知厂家 功能描述:LED DRIVER CONTROL IC |
| IRS2980SPBF | 功能描述:功率因数校正 IC Fluorescent PFC + Ballast Combo IC RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel |
| IRS2980STRPBF | 功能描述:功率因数校正 IC Fluorescent PFC + Ballast Combo IC RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。