- 您现在的位置：买卖IC网 > PDF目录1811 > IRU3007CWTR (International Rectifier)IC CTRL/REG SYNC BUCK 28-SOIC PDF资料下载
参数资料
| 型号： | IRU3007CWTR |
| 厂商： | International Rectifier |
| 文件页数： | 13/17页 |
| 文件大小： | 0K |
| 描述： | IC CTRL/REG SYNC BUCK 28-SOIC |
| 标准包装： | 1,000 |
| 应用： | 控制器，Intel Pentium? II |
| 输入电压： | 5V，12V |
| 输出数： | 4 |
| 输出电压： | 1.3 V ~ 3.5 V |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SOIC（0.295"，7.50mm 宽） |
| 供应商设备封装： | 28-SOIC W |
| 包装： | 带卷 (TR) |
IRU3007
P DH = 0.76 3 10 3 0.029 = 2.21W
P DH = D MAX 3 Io 2 3 R DS(MAX)
2
R DS(MAX) = Maximum R DS(ON) of the MOSFET at 125 8 C
For diode, the maximum power dissipation happens at
minimum Vo and minimum duty cycle.
D MIN ≈ (3.3 + 0.5) / (5.25 - 0.27 + 0.5) = 0.69
P DD = (1 - D MIN ) 3 Io 3 Vf
P DD = (1 - 0.69) 3 10 3 0.5 = 1.55W
Switcher Current Limit Protection
The IRU3007 uses the MOSFET R DS(ON) as the sensing
resistor to sense the MOSFET current and compares to
a programmed voltage which is set externally via a re-
sistor (Rcs) placed between the drain of the MOSFET
and the “CS+” terminal of the IC as shown in the appli-
cation circuit.
For example, if the desired current limit point is set to
be 22A for the synchronous and 16A for the non syn-
chronous, and from our previous selection, the maxi-
mum MOSFET R DS(ON) =19mW, then the current sense
resistor Rcs is calculated as:
Vcore
Vcs = I CL 3 R DS = 22 3 0.019 = 0.418V
Rcs = Vcs / I B = (0.418V) / (200 m A) = 2.1K V
Where:
I B =200 m A is the internal current setting of the
IRU3007
3.3V supply
Vcs = I CL 3 R DS = 16 3 0.019 = 0.3V
Rcs = Vcs / I B = (0.3V) / (200 m A) = 1.50K V
1.5V, GTL+ Supply LDO Power MOSFET Selection
The first step in selecting the power MOSFET for the
1.5V linear regulator is to select its maximum R DS(ON) of
the pass transistor based on the input to output Dropout
voltage and the maximum load current.
For Vo = 1.5V, V IN = 3.3V and I L = 2A:
R DS(MAX) = (V IN - Vo) / I L = (3.3 - 1.5) / 2 = 0.9 V
Note: Since the MOSFETs R DS(ON) increases with tem-
perature, this number must be divided by ≈ 1.5, in order
to find the R DS(ON) max at room temperature. The Motorola
MTP3055VL has a maximum of 0.18 V R DS(ON) at room
temperature, which meets our requirement.
To select the heat sink for the LDO MOSFET the first
step is to calculate the maximum power dissipation of
the device and then follow the same procedure as for the
switcher.
Where:
P D = Power Dissipation of the Linear Regulator
I L = Linear Regulator Load Current
For the 1.5V and 2A load:
P D = (V IN - Vo) 3 I L
P D = (3.3 - 1.5) 3 2 = 3.6W
Assuming T J(MAX) = 125 8 C:
Ts = T J - P D 3 ( u JC + u cs)
Ts = 125 - 3.6 3 (1.8 + 0.05) = 118 8 C
With the maximum heat sink temperature calculated in
the previous step, the heat-sink-to-air thermal resistance
( u SA ) is calculated as follows:
Assuming T A = 35 8 C:
D T = Ts - T A = 118 - 35 = 83 8 C
Temperature Rise Above Ambient
u SA = D T / P D = 83 / 3.6 = 23 8 C/W
The same heat sink as the one selected for the switcher
MOSFETs is also suitable for the 1.5V regulator.
2.5V Clock Supply
The IRU3007 provides a complete 2.5V regulator with a
minimum of 200mA current capability. The internal regu-
lator has short circuit protection with internal thermal
shutdown.
1.5V and 2.5V Supply Resistor Divider Selection
Since the internal voltage reference for the linear regula-
tors is set at 1.26V for IRU3007, there is a need to use
external resistor dividers to step up the voltage. The re-
sistor dividers are selected using the following equations:
Vo = (1 + Rt / R B ) 3 V REF
Where:
Rt = Top resistor divider
R B = Bottom resistor divider
V REF = 1.26V typical
For 1.5V supply
Assuming R B = 1K V :
Rt = R B 3 [ (Vo / V REF ) - 1 ]
Rt = 1 3 [ (1.5 / 1.26) - 1 ] = 191 V
Rev. 2.1
08/20/02
www.irf.com
13
相关PDF资料 |
PDF描述 |
|---|---|
| IRU3011CWTR | IC CTRL SYNC BUCK 5BIT 20SOIC(W) |
| IRU3013CWTR | IC CNTRL BUCK W/TRPL LDO 24-SOIC |
| IRU3018CWTR | IC CTRL/REG SYNC BUCK 24-SOIC |
| IRU3021MCWTR | IC CTRL/REG SYNC BUCK 28-SOIC |
| IRU3027CWTR | IC CTRL/REG SYNC BUCK 28-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IRU3008CWTR | 功能描述:IC REG 24-SOIC(W) RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:20 系列:SIMPLE SWITCHER® 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:12V 输入电压:4 V ~ 60 V PWM 型:电压模式 频率 - 开关:52kHz 电流 - 输出:1A 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:通孔 封装/外壳:16-DIP（0.300"，7.62mm） 包装:管件 供应商设备封装:16-DIP 其它名称:*LM2575HVN-12LM2575HVN-12 |
| IRU3010CW | 制造商:International Rectifier 功能描述:SWITCHING CONTROLLER |
| IRU3010CWTR | 功能描述:IC REG BUCK SYNC 20SOIC(W) RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:20 系列:SIMPLE SWITCHER® 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:12V 输入电压:4 V ~ 60 V PWM 型:电压模式 频率 - 开关:52kHz 电流 - 输出:1A 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:通孔 封装/外壳:16-DIP（0.300"，7.62mm） 包装:管件 供应商设备封装:16-DIP 其它名称:*LM2575HVN-12LM2575HVN-12 |
| IRU3011 | 制造商:IRF 制造商全称:International Rectifier 功能描述:5-BIT PROGRAMMABLE SYNCHRONOUS BUCK CONTROLLER IC |
| IRU3011CW | 功能描述:IC CTRL SYNC BUCK 5BIT 20-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,000 系列:- 应用:电源，ICERA E400，E450 输入电压:4.1 V ~ 5.5 V 输出数:10 输出电压:可编程 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:42-WFBGA，WLCSP 供应商设备封装:42-WLP 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。