- 您现在的位置：买卖IC网 > PDF目录1812 > IRU3146CFTR (International Rectifier)IC REG CTRLR BUCK PWM VM 28TSSOP PDF资料下载
参数资料
| 型号： | IRU3146CFTR |
| 厂商： | International Rectifier |
| 文件页数： | 8/30页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 28TSSOP |
| 标准包装： | 1 |
| PWM 型： | 电压模式 |
| 输出数： | 2 |
| 频率 - 最大： | 345kHz |
| 占空比： | 85% |
| 电源电压： | 4.5 V ~ 16 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 28-TSSOP（0.173"，4.40mm 宽） |
| 包装： | 剪切带 (CT) |
| 产品目录页面： | 1384 (CN2011-ZH PDF) |
| 其它名称： | *IRU3146CFTR IRU3146CFCT |
第1页第2页第3页第4页第5页第6页第7页当前第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
IRU3146
For a given start up time, the soft-start capacitor can be
The internal current source develops a voltage across
calculated by:
C SS ? 25 μ A × T START /1V
R SET . When the low side switch is turned on, the induc-
tor current flows through the Q2 and results a voltage
The soft-start is part of Over Current Protection scheme,
which is given by:
during the overload or short circuit condition the external
soft start capacitors will be charged and discharged in
certain slope rate to achieve the hiccup mode function.
25uA
Hiccup
V OCSET = I OCSET × R SET -R DS(ON) × i L
I OCSET
IRU3146
Q1
---(2)
OCSet R SET
L1
V OUT
SS1 / SD
20
3uA
Hiccup
Control
Q2
Figure 8 - 3uA current source for discharging soft
start-capacitor during Hiccup mode
Figure 9 - Diagram of the over current sensing.
The critical inductor current can be calculated by set-
Out-of-Phase Operation
The IRU3146 drives its two output stages 180 out-of-
ting:
V OCSET = I OCSET × R SET - R DS(ON) × I L = 0
phase. In 2-phase configuration, the two inductor ripple
currents cancel each other and result in a reduction of
the output current ripple and yield a smaller output ca-
I SET = I L(CRITICAL) =
R SET × I OCSET
R DS(ON)
---(3)
pacitor for the same ripple voltage requirement.
In single input voltage applications, the input ripple cur-
rent reduces. This result in much smaller input capacitor's
RMS current and reduces the input capacitor quantity.
Over-Current Protection
The IRU3146 can provide two different schemes for Over-
Current Protection (OCP). When the pin Hiccup is pulled
high, the OCP will operate in hiccup mode. In this mode,
during overload or short circuit, the outputs enter hiccup
mode and stay in that mode until the overload or short
circuit is removed. The converter will automatically re-
cover.
When the Hiccup pin is pulled low, the OCP scheme
will be changed to the latch up type, in this mode the
converter will be turned off during Overcurrent or short
circuit. The power needs to be recycled for normal
operation.
Each phase has its own independent OCP circuitry.
The OCP is performed by sensing current through the
R DS(ON) of low side MOSFET. As shown in Figure 9, an
external resistor (R SET ) is connected between OCSet pin
and the drain of low side MOSFET (Q2) which sets the
current limit set point.
If using one soft start capacitor in dual configuration for a
precise power up the OCP needs to be set to latch mode.
The value of R SET should be checked in an actual
circuit to ensure that the Over Current Protection
circuit activates as expected. The IRU3146 current
limit is designed primarily as disaster preventing, "no
blow up" circuit, and is not useful as a precision
current regulator.
In two independent mode, the output of each channel
is protected independently which means if one output
is under overload or short circuit condition, the other
output will remain functional. The OCP set limit can be
programmed to different levels by using the external
resistors. This is valid for both hiccup mode and latch
up mode.
In 2-phase configuration, the OCP's output depends on
any one channel, which means as soon as one
channel goes to overload or short circuit condition the
output will enter either hiccup or latch-up, dependes on
status of Hiccup pin.
8
www.irf.com
Rev. 1.1
6/25/04
相关PDF资料 |
PDF描述 |
|---|---|
| IRU431LCL5TR | IC VREF SHUNT PREC ADJ SOT-23-5 |
| ISL1801IVZ | IC CONV SOLAR PWR 48TSSOP |
| ISL21009BFB825Z-T7A | IC VREF SERIES PREC 2.5V 8-SOICN |
| ISL21010DFH310Z-TK | IC INTERFACE |
| ISL21070DIH306Z-TK | IC VREF SERIES 0.6V SOT-23-3 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IRU431AL | 制造商:IRF 制造商全称:International Rectifier 功能描述:LOW -VOLTAGE ADJUSTABLE PRECISION SHUNT REGULATOR |
| IRU431ALCL3 | 制造商:IRF 制造商全称:International Rectifier 功能描述:LOW -VOLTAGE ADJUSTABLE PRECISION SHUNT REGULATOR |
| IRU431ALCL3TR | 功能描述:IC VREF SHUNT PREC ADJ SOT-23-3 RoHS:否 类别:集成电路 (IC) >> PMIC - 电压基准 系列:- 标准包装:3,000 系列:- 基准类型:旁路，精度 输出电压:5V 容差:±0.5% 温度系数:100ppm/°C 输入电压:- 通道数:1 电流 - 阴极:80µA 电流 - 静态:- 电流 - 输出:15mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:TO-236-3，SC-59，SOT-23-3 供应商设备封装:SOT-23-3 包装:带卷 (TR) 其它名称:LM4040CIM3-5.0MLTRLM4040CIM3-5.0MLTR-ND |
| IRU431ALCL5 | 制造商:IRF 制造商全称:International Rectifier 功能描述:LOW -VOLTAGE ADJUSTABLE PRECISION SHUNT REGULATOR |
| IRU431ALCL5TR | 制造商:International Rectifier 功能描述:IC, SHUNT REGULATOR, 1.24V, 1%, 5-SOT-23, Topology:Shunt, Reference Voltage:1.24 |
发布紧急采购，3分钟左右您将得到回复。