参数资料
| 型号： | ISL22326UFV14Z |
| 厂商： | Intersil |
| 文件页数： | 10/15页 |
| 文件大小： | 0K |
| 描述： | IC POT DGTL 128TP LN LP 14-TSSOP |
| 标准包装： | 960 |
| 系列： | XDCP™ |
| 接片： | 128 |
| 电阻（欧姆）： | 50k |
| 电路数： | 2 |
| 温度系数： | 标准值 ±80 ppm/°C |
| 存储器类型： | 非易失 |
| 接口： | I²C（设备位址） |
| 电源电压： | 2.7 V ~ 5.5 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 14-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 14-TSSOP |
| 包装： | 管件 |
4
FN6176.2
September 8, 2009
RESISTOR MODE (Measurements between RWi and RLi with RHi not connected, or between RWi and RHi with RLi not connected. i = 0 or 1)
RINL
(Note 15)
Integral Non-linearity
DCP register set between 10h and 7Fh;
monotonic over all tap positions
-1
1
MI
(Note 12)
RDNL
(Note 14)
Differential Non-linearity
DCP register set between 10h and 7Fh;
monotonic over all tap positions, W option
-1
1
MI
(Note 12)
DCP register set between 10h and 7Fh;
monotonic over all tap positions, U option
-0.5
0.5
MI
(Note 12)
Roffset
(Note 13)
Offset
W option
0
1
5
MI
(Note 12)
U option
0
0.5
2
MI
(Note 12)
RMATCH
(Note 16)
DCP to DCP Matching
Any two DCPs at the same tap position with
the same terminal voltages
-2
2
MI
(Note 12)
Analog Specifications
Over recommended operating conditions, unless otherwise stated. (Continued)
SYMBOL
PARAMETER
TEST CONDITIONS
MIN
(Note 20)
TYP
(Note 4)
MAX
(Note 20)
UNIT
Operating Specifications Over the recommended operating conditions, unless otherwise specified.
SYMBOL
PARAMETER
TEST CONDITIONS
MIN
(Note 20)
TYP
(Note 4)
MAX
(Note 20)
UNIT
ICC1
VCC Supply Current (Volatile
Write/Read)
fSCL = 400kHz; SDA = Open; (for I
2C, active,
read and write states)
0.5
mA
ICC2
VCC Supply Current (Non-volatile
Write/Read)
fSCL = 400kHz; SDA = Open; (for I
2C, active,
read and write states)
3mA
ISB
VCC Current (Standby)
VCC = +5.5V @ +85°C, I
2C interface in
standby state
5A
VCC = +5.5V @ +125°C, I
2C interface in
standby state
7A
VCC = +3.6V @ +85°C, I
2C interface in
standby state
3A
VCC = +3.6V @ +125°C, I
2C interface in
standby state
5A
ISD
VCC Current (Shutdown)
VCC = +5.5V @ +85°C, I
2C interface in
standby state
3A
VCC = +5.5V @ +125°C, I
2C interface in
standby state
5A
VCC = +3.6V @ +85°C, I
2C interface in
standby state
2A
VCC = +3.6V @ +125°C, I
2C interface in
standby state
4A
ILkgDig
Leakage Current, at Pins A0, A1, A2,
SHDN, SDA and SCL
Voltage at pin from GND to VCC
-1
1
A
tWRT
(Note 19)
DCP Wiper Response Time
SCL falling edge of last bit of DCP data byte
to wiper new position
1.5
s
tShdnRec
(Note 19)
DCP Recall Time from Shutdown
Mode
From rising edge of SHDN signal to wiper
stored position and RH connection
1.5
s
SCL falling edge of last bit of ACR data byte
to wiper stored position and RH connection
1.5
s
Vpor
Power-on Recall Voltage
Minimum VCC at which memory recall
occurs
2.0
2.6
V
VccRamp
VCC Ramp Rate
0.2
V/ms
ISL22326
相关PDF资料 |
PDF描述 |
|---|---|
| DS1100LZ-75 | IC DELAY LINE 5TAP 75NS 8-SOIC |
| DS1100Z-25L | IC DELAY LINE 5TAP 25NS 8-SOIC |
| VE-J2W-MZ-S | CONVERTER MOD DC/DC 5.5V 25W |
| DS1013S-40 | IC DELAY LINE 40NS 16-SOIC |
| DS1013S-25 | IC DELAY LINE 25NS 16-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL22326UFV14Z-TK | 功能描述:数字电位计 IC 128 TAP FL RNG IND DCP 14LD RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| ISL22326WFR16Z | 功能描述:数字电位计 IC 128 TAP FL RNG DCP 16LD 4X4 RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| ISL22326WFR16Z-TK | 功能描述:数字电位计 IC 128 TAP FL RNG IND DL DCP 16LD 4X4 RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| ISL22326WFV14Z | 功能描述:数字电位计 IC 128 TAP FL RNG DCP 14LD RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| ISL22326WFV14Z-TK | 功能描述:数字电位计 IC 128 TAP FL RNG IND DCP 14LD RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。