- 您现在的位置：买卖IC网 > PDF目录384520 > ISL5239EVAL1 (Intersil Corporation) Pre-Distortion Linearizer PDF资料下载
参数资料
| 型号： | ISL5239EVAL1 |
| 厂商： | Intersil Corporation |
| 英文描述： | Pre-Distortion Linearizer |
| 中文描述： | 预失真线性化电路 |
| 文件页数： | 6/31页 |
| 文件大小： | 653K |
| 代理商： | ISL5239EVAL1 |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页
6
Functional Description
The ISL5239 is a full-featured digital pre-distortion part
featuring a high-performance lookup-table based pre-
distortion (PD) processing unit. It includes an interpolator for
upsampling and supports all varieties of upconversion
architectures with a programmable correction filter for
equalization including both sin(x)/x correction and removal of
frequency response imbalance between quadrature paths. It
also features gain, phase, and offset compensation for direct
upconversion, digital IF output for heterodyning, and
input/output capture memories with internal/external
triggering capabilities to facilitate closedloop feedback
processing. System implementation is typically as shown in
Figure 1. Although the power detect feedback is shown with
one Analog to Digital Converter (ADC), coherently
demodulated feedback signalsLO configurations with 1 or 2
ADC’s are also supported.
The block diagram on page 1 shows the internal functional
units within the ISL5239. In the following sections each
functional unit is described. The operation of the ISL5239 is
controlled by the register map listed in Table 3. Detailed
descriptions for each control/status register are given in
Tables 4 through 48. The control/status registers are referred
to in the discussion below.
Input Formatter and Interpolator (IFIP)
The Input Formatter and Interpolator interfaces to the data
source to provide for parallel data input via the IIN<17:0>,
QIN<17:0> busses, or serial input via the IIN<17:0> input
bus. In parallel input mode, both 18-bit input busses are
used to allow for parallel I and Q sample loading. In serial
mode, the data is input via the IIN<17:0> bus only, as the I
sample followed by the Q sample with the ISTRB input
asserted with each I sample. In this mode, the QIN<17:0>
bus is not utilized. The input data format is selectable as
either two’s complement or offset binary.
The Interpolator function is necessary because pre-
distorting a signal results in a much wider bandwidth signal
(typically 5x to 7x wider). The Input Formatter and
Interpolator is depicted in Figure 2.
Three interpolation rates (x2, x4, and x8) are supported by
the cascade of three Half-Band (HB) Filters. The ISL5239
includes an on-chip clock divider to facilitate input clocking.
The clock divider generates the CLKOUT signal which is
used to clock data from the input signal source. Typical input
sources include the ISL5217 quad programmable
upconverter, which is designed to operate seamlessly with
the ISL5239.
The interpolation factor is selectable in control word 0x02,
bits 6:4 as x1, x2, x4, and x8. The x1 mode bypasses all
three half-band filters. The x2 mode utilized HB1 and
bypasses HB2 and HB3. The x4 mode utilized HB1 and HB2
and bypasses HB3. Finally, the x8 mode utilizes all three
HBFs. Saturation status bits are provided for each of the
three HBFs in the status register 0x03.
Input data rates up to the CLK rate are supported, based on
the requirement CLK >= Fs * IP, where Fs is the input rate of
the incoming data and IP is the interpolation factor selected
in control word 0x02.
Each half-band filter performs a x2 interpolation by inserting
one zero between each input data sample, causing the
sampling frequency to double. The resulting zero-stuffed
data is then low pass filtered to reject the upsampling image.
The half-band filter frequency responses are as shown in
Figure 3.
FIGURE 1. SYSTEM OVERVIEW
FIGURE 3. x2, HB1 ENABLED FREQUENCY RESPONSE
FIGURE 2. INPUT FORMATTER AND INTERPOLATOR
BLOCK DIAGRAM
QIN<17:0>
IIN<17:0>
I
F
HALF
BAND
FILTER
1
HALF
BAND
FILTER
2
HALF
BAND
FILTER
3
20
/
20
/
18
/
20
/
I
Q
BYPASS
BYPASS
BYPASS
0
0.1
NORMALIZED FREQUENCY (NYQUIST=1)
0.2
0.3
0.4
0.5
0.6
0.7
0.8
0.9
1
-140
-120
-100
-80
-60
-40
-20
0
M
HALFBAND FILTER 1 RESPONSE
ISL5239
相关PDF资料 |
PDF描述 |
|---|---|
| ISL5239 | Pre-Distortion Linearizer |
| ISL5239KI | Pre-Distortion Linearizer |
| ISL5239KIZ | Pre-Distortion Linearizer |
| ISL5416 | Four-Channel Wideband Programmable DownConverter |
| ISL5416EVAL | Four-Channel Wideband Programmable DownConverter |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL5239KI | 功能描述:音频 DSP PA LINEARIZER IND TEMP 1 0MM PITCH RoHS:否 制造商:Texas Instruments 工作电源电压: 电源电流: 工作温度范围: 安装风格: 封装 / 箱体: 封装:Tube |
| ISL5239KIZ | 功能描述:音频 DSP PA LINEARIZER IND 0MM PITCH BGA PACKAG RoHS:否 制造商:Texas Instruments 工作电源电压: 电源电流: 工作温度范围: 安装风格: 封装 / 箱体: 封装:Tube |
| ISL5314 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Direct Digital Synthesizer |
| ISL5314_05 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Direct Digital Synthesizer |
| ISL5314EVAL2 | 制造商:Intersil Corporation 功能描述:DEV TOOL FOR COMMLINK DIRECT DGTL SYNTHESIZER - Bulk |
发布紧急采购，3分钟左右您将得到回复。