- 您现在的位置：买卖IC网 > PDF目录11791 > ISL54102ACQZ (Intersil)IC TMDS REGEN W/MUX 128-MQFP PDF资料下载
参数资料
| 型号： | ISL54102ACQZ |
| 厂商： | Intersil |
| 文件页数： | 20/21页 |
| 文件大小： | 0K |
| 描述： | IC TMDS REGEN W/MUX 128-MQFP |
| 标准包装： | 66 |
| 应用： | 多媒体显示器，测试设备 |
| 接口： | I²C |
| 电源电压： | 3 V ~ 3.6 V |
| 封装/外壳： | 128-BFQFP |
| 供应商设备封装： | 128-MQFP（14x20） |
| 包装： | 托盘 |
| 安装类型： | 表面贴装 |
| 产品目录页面： | 1244 (CN2011-ZH PDF) |
8
FN6725.0
June 17, 2008
Pin Descriptions
SYMBOL
DESCRIPTION
RX0-_A, RX0+_A, RX1-_A, RX1+_A,
RX2-_A, RX2+_A
TMDS Inputs. Incoming TMDS data signals for Channel A.
RX0-_B, RX0+_B, RX1-_B, RX1+_B,
RX2-_B, RX2+_B
TMDS Inputs. Incoming TMDS data signals for Channel B (ISL54100A and ISL54102A only).
RX0-_C, RX0+_C, RX1-_C, RX1+_C,
RX2-_C, RX2+_C
TMDS Inputs. Incoming TMDS data signals for Channel C (ISL54100A only).
RX0-_D, RX0+_D, RX1-_D, RX1+_D,
RX2-_D, RX2+_D
TMDS Inputs. Incoming TMDS data signals for Channel D (ISL54100A only).
RXC-_A, RXC+_A, RXC-_B, RXC+_B,
RXC-_C, RXC+_C, RXC-_D, RXC+_D
TMDS Inputs. Incoming TMDS clock signals for Channels A, B, C and D (ISL54100A), Channels A and
B (ISL54102A), or Channel A (ISL54101A).
TX0-, TX0+, TX1-, TX1+, TX1-, TX1+
TMDS Outputs. TMDS output data for selected channel.
TXC-, TXC+
TMDS Outputs. TMDS output clock for selected channel.
SCL
Digital input, 5V tolerant, 500mV hysteresis. Serial data clock for 2-wire interface.
Note: Internal 65k
Ω pull-up to V
D.
SDA
Bidirectional Digital I/O, open drain, 5V tolerant. Serial data I/O for 2-wire interface.
Note: Internal 65k
Ω pull-up to V
D.
ADDR[6:0]
Digital inputs, 5V tolerant. 7-Bit address for serial interface.
Note: Internal 60k
Ω pull-down to GND.
CH_SEL_0, CH_SEL_1
Digital inputs, 3.3V. Channel select inputs for stand-alone operation. Pull to ground with a 47k resistor if
unused.
AUTO_CH_SEL
Digital Input. Pull high to have the mux automatically select the highest channel (A is highest, D is lowest)
with an active TMDS clock. Low is manual channel select.
CHA_Active, CHB_Active,
CHC_Active, CHD_Active
Digital Outputs, 3.3V. Output goes high when there is an active TMDS clock on that channel's input. Used
for activity detect in a stand-alone configuration.
CHC_Active and CHD_Active are NC (do Not Connect) for the ISL54102A.
CHB_Active, CHC_Active and CHD_Active are NC (do Not Connect) for the ISL54101A.
RES_BIAS
Tie to GND through a 3.16k external resistor. Sets up internal bias currents.
RES_TERM
Tie to VD through a 1.0k 1% external resistor. During calibration, the termination resistor closest in value
to RES_TERM/20 (= 50
Ω) is selected.
PD
Digital Input, 3.3V. PD = Power-down. Pull high to put the ISL5410xA in a minimum power consumption
mode.
Note: To ensure proper operation, this pin must be held low during power-up. It may be taken high 100ms
after the power supplies have settled to 3.3V ±10%.
When exiting Power-down, a termination resistor Recalibration cycle must be run to re-trim the
termination resistors (see register 0x03[7]).
Note: Internal 60k
Ω pull-down to GND.
RESET
Digital Input, 3.3V. Pull high then low to reset the mux. Tie to GND in final application.
Note: Internal 60k pull-down to GND.
TEST
Digital Input. Used for production testing only. Tie to GND in final application. This pin has an internal
pulldown to GND, so it is also acceptable to leave this pin floating.
VD
Power supply. Connect to a 3.3V supply and bypass each pin to GND with 0.1F.
VD_ESD
Power supply for ESD protection diodes. Connect one of these pins (pin 74 or 95) to the 3.3V VD supply
rail with a low VF (0.4V or lower) Schottky diode, with the cathode connected to VD_ESD and the anode
connected to VD. Bypass each pin to GND with 0.1F.
GND
Ground return for VD.
ISL54100A, ISL54101A, ISL54102A
相关PDF资料 |
PDF描述 |
|---|---|
| ISL54102CQZ | IC TMDS REGEN W/MUX 128MQFP |
| IA186ES-PTQ100I-R-03 | IC MCU 8/16BIT 40MHZ 100TQFP |
| PI7C8152BMAE | IC PCI-PCI BRIDGE 2PORT 160-MQFP |
| DS80C310-MCG+ | IC MCU HI SPEED 25MHZ 40-DIP |
| MS27468E21B41S | CONN RCPT 41POS JAM NUT W/SCKT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL54102CQZ | 功能描述:IC TMDS REGEN W/MUX 128MQFP RoHS:是 类别:集成电路 (IC) >> 接口 - 专用 系列:- 特色产品:NXP - I2C Interface 标准包装:1 系列:- 应用:2 通道 I²C 多路复用器 接口:I²C，SM 总线 电源电压:2.3 V ~ 5.5 V 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:剪切带 (CT) 安装类型:表面贴装 产品目录页面:825 (CN2011-ZH PDF) 其它名称:568-1854-1 |
| ISL54103 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:DDC Accelerator (DDCA) |
| ISL54103IHZ-T7 | 功能描述:接口 - 专用 ISL55016IRTZFREE DIF GAIN BLOCK(75OHM ZIN RoHS:否 制造商:Texas Instruments 产品类型:1080p60 Image Sensor Receiver 工作电源电压:1.8 V 电源电流:89 mA 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:BGA-59 |
| ISL54103IHZ-T7A | 功能描述:接口 - 专用 ISL55020IRZ FL DIFFR CFA W/LW DISTORTIO RoHS:否 制造商:Texas Instruments 产品类型:1080p60 Image Sensor Receiver 工作电源电压:1.8 V 电源电流:89 mA 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:BGA-59 |
| ISL54105A | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:TMDS Regenerator |
发布紧急采购，3分钟左右您将得到回复。