- 您现在的位置：买卖IC网 > PDF目录19800 > ISL6174IRZ-T (Intersil)IC CIRC BREAKER DUAL LV 28-QFN PDF资料下载
参数资料
| 型号： | ISL6174IRZ-T |
| 厂商： | Intersil |
| 文件页数： | 3/16页 |
| 文件大小： | 346K |
| 描述： | IC CIRC BREAKER DUAL LV 28-QFN |
| 标准包装： | 6,000 |
| 类型： | 热交换控制器 |
| 应用： | 通用 |
| 内部开关： | 无 |
| 电源电压： | 2.25 V ~ 3.63 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-VFQFN 裸露焊盘 |
| 供应商设备封装： | 28-QFN 裸露焊盘（5x5） |
| 包装： | 带卷 (TR) |
3
FN6830.0
December 19, 2008
Pinout
28 LEAD QFN
TOP VIEW
1
2
3
4
5
6
7
21
20
19
18
17
16
15
28 27 26 25 24 23 22
8
9 10 11 12 13 14
SNS2
VO2
SS2
GT2
FLT2
PG2
TCB2
SNS1
VO1
SS1
GT1
FLT1
PG1
TCB1
Pin Descriptions
PIN
NAME
FUNCTION
DESCRIPTION
1
SNS1
Current Sense Input
This pin is connected to the current sense resistor and control MOSFET Drain node. It provides
current sense signal to the internal comparator in conjunction with VS1 pin.
2
VO1
Output Voltage 1
This pin is connected to the control MOSFET switch source, which connects to a load. Internally, this
voltage is used for SS control.
3
SS1
Soft-Start Duration Set
Input
A capacitor from this pin to ground sets the output soft-start ramp slope. This capacitor is charged by
the internal 10礎 current source setting the soft-start ramp. The output voltage ramp tracks the SS
ramp by controlled enhancement of FET gate. Once ramp-up is completed, the capacitor continues
to charge to the CPVDD voltage rail. If common capacitor is used (by tying SS1, SS2 together and
the capacitor to GND from the connection) then both the outputs track each other as they ramp up.
4
GT1
Gate Drive Output
Direct connection to the gate of the external N-Channel MOSFET. At turn-on the Gate will charge to
4 X Vbias or 10V(max) from the 24礎 source.
5
FLT1
Fault Output
This is an open drain output. It asserts (pulls low) once the circuit breaker delay (determined by the
TCB timeout cap) has expired. This output is valid for Vbias>1V.
6
PG1
Power Good Output
This is an active low, open drain output. When asserted (logic zero), it indicates that the voltage on
UV1 pin is more than 643mV (633mV + 10mV hysteresis). This output is valid at VBIAS >1V.
7
TCB1
Circuit Breaker Delay
Timer
A capacitor from this pin to ground sets the delay from the onset of an over current event to channel
shutdown (circuit breaker delay). Once the voltage on TCB cap reaches V
CT_Vth
the GATE output is
pulled down and the FLT
is asserted.
The time for circuit breaker delay (t
CB
) = (C
TCB
*1.178)/10礎.
8
DNC
Do not connect
Do not connect
9
GND
Chip Gnd
This pin is also internally shorted to the metal tab at the bottom of the IC.
10
PGND
Charge pump ground. Both GND and PGND must be tied together externally.
11
CPQ-
Charge Pump Capacitor
Low Side
Flying cap lowside.
ISL6174
相关PDF资料 |
PDF描述 |
|---|---|
| MIC2086-LBQS TR | IC CTRLR HOW SWAP SGL 20-QSOP |
| VI-J50-CW-B1 | CONVERTER MOD DC/DC 5V 100W |
| TAJA335M016RNJ | CAP TANT 3.3UF 16V 20% 1206 |
| MIC39301-1.8BU | IC REG LDO 1.8V 3A TO263-5 |
| TEA1530AP/N2,112 | IC CTRLR SMPS GREEN OVP OTP 8DIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL617XEVAL1Z | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Dual Low Voltage Circuit Breaker |
| ISL6185 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Dual USB Port Power Supply Controller |
| ISL6185_11 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Dual USB Port Power Supply Controller 2.5V to 5V Operating Range |
| ISL61851ACBZ | 功能描述:热插拔功率分布 DL USB HOTSWAP W/INT FET-EN HI 8LD RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| ISL61851ACBZ-T | 功能描述:热插拔功率分布 DL USB HOTSWAP W/INT FET-EN HI 8LD RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。