- 您现在的位置：买卖IC网 > PDF目录20679 > ISL6207HBZ-T (Intersil)IC MOSFET DRVR SYNC BUCK 8-SOIC PDF资料下载
参数资料
| 型号： | ISL6207HBZ-T |
| 厂商： | Intersil |
| 文件页数： | 7/10页 |
| 文件大小： | 0K |
| 描述： | IC MOSFET DRVR SYNC BUCK 8-SOIC |
| 标准包装： | 2,500 |
| 配置： | 高端和低端，同步 |
| 输入类型： | PWM |
| 延迟时间： | 20ns |
| 电流 - 峰： | 2A |
| 配置数： | 1 |
| 输出数： | 2 |
| 高端电压 - 最大（自引导启动）： | 36V |
| 电源电压： | 4.5 V ~ 5.5 V |
| 工作温度： | -10°C ~ 100°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOIC |
| 包装： | 带卷 (TR) |
ISL6207
The next larger standard value capacitance is 0.22 μ F. A
good quality ceramic capacitor is recommended.
2.0
1000
900
800
Q U =100nC
Q L =200nC
Q U =50nC
Q L =100nC
Q U =50nC
Q L =50nC
1.8
700
1.6
1.4
1.2
1.0
0.8
600
500
400
300
200
Q U =20nC
Q L =50nC
0.6
0.4
0.2
0.0
0.0
20nC
0.1
Q GATE = 100nC
50nC
0.2 0.3 0.4 0.5 0.6
? V BOOT (V)
0.7
0.8
0.9
1.0
100
0
0 200 400 600 800 1000 1200 1400 1600 1800 2000
FREQUENCY (kHz)
FIGURE 3. POWER DISSIPATION vs FREQUENCY
FIGURE 2. BOOTSTRAP CAPACITANCE vs BOOT RIPPLE
VOLTAGE
Power Dissipation
Package power dissipation is mainly a function of the
switching frequency and total gate charge of the selected
MOSFETs. Calculating the power dissipation in the driver for
a desired application is critical to ensuring safe operation.
Exceeding the maximum allowable power dissipation level
will push the IC beyond the maximum recommended
operating junction tem perature of 125 ° C. The maximum
allowable IC power dissipation for the SO-8 package is
approximately 800mW. When designing the driver into an
application, it is recommende d that the following calculation
be performed to ensure safe operation at the desired
frequency for the selected MOSFETs. The power dissipated
by the driver is approximated as:
P = f sw ( 1.5V U Q U + V L Q L ) + I DDQ V CC
where f sw is the switching frequency of the PWM signal. V U
and V L represent the upper and lower gate rail voltage. Q U
and Q L is the upper and lower gate charge determined by
MOSFET s election and any external capacitance added to
the gate pins. The I DDQ V CC product is the quiescent power
of the driver and is typically negligible.
7
Layout Considerations
Reducing Phase Ring
The parasitic inductances of the PCB and power devices
(both upper and lower FETs) could cause increased PHASE
ringing, which may lead to voltages that exceed the absolute
maximum rating of the devices. When PHASE rings below
ground, the negative voltage could add charge to the
bootstrap capacitor through the internal bootstrap diode.
Under worst-case conditions, the added charge could
overstress the BOOT and/or PHASE pins. To prevent this
from happening, the user should perform a careful layout
inspection to reduce trace inductances, and select low lead
inductance MOSFETs and drivers. D 2 PAK and DPAK
packaged MOSFETs have high parasitic lead inductances, as
opposed to SOIC-8. If higher inductance MOSFETs must be
used, a Schottky diode is recommended across the lower
MOSFET to clamp negative PHASE ring.
A good layout would help reduce the ringing on the phase
and gate nodes significantly:
? Avoid using vias for decoupling components where
possible, especially in the BOOT-to-PHASE path. Little or
no use of vias for VCC and GND is also recommended.
Decoupling loops should be short.
? All power traces (UGATE, PHASE, LGATE, GND, VCC)
should be short and wide, and avoid using vias. If vias
must be used, two or more vias per layer transition is
recommended.
? Keep the SOURCE of the upper FET as close as thermally
possible to the DRAIN of the lower FET.
? Keep the connection in between the SOURCE of lower
FET and power ground wide and short.
? Input capacitors should be placed as close to the DRAIN
of the upper FET and the SOURCE of the lower FET as
thermally possible.
FN9075.8
December 2, 2005
相关PDF资料 |
PDF描述 |
|---|---|
| VE-2N0-EW-B1 | CONVERTER MOD DC/DC 5V 100W |
| GSC05DREI | CONN EDGECARD 10POS .100 EYELET |
| EBA18DTKH-S288 | CONN EDGECARD 36POS .125 EXTEND |
| EEM08DRMT-S288 | CONN EDGECARD 16POS .156 EXTEND |
| ISL6329CRZ | IC CTRLR PWM SYNC BUCK DL 60QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6207HRZ | 功能描述:功率驱动器IC VER OF ISL6207CR -10 TO +100 RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| ISL6207HRZ-T | 功能描述:功率驱动器IC VER OF ISL6207CR-T - 10 TO +100 RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| ISL6208 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:High Voltage Synchronous Rectified Buck MOSFET Driver |
| ISL6208_07 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:High Voltage Synchronous Rectified Buck MOSFET Driver |
| ISL6208_11 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:High Voltage Synchronous Rectified Buck MOSFET Drivers |
发布紧急采购，3分钟左右您将得到回复。