- 您现在的位置：买卖IC网 > PDF目录17644 > ISL6273IRZ (Intersil)IC BUCK SYNC ADJ 1.2A 10DFN PDF资料下载
参数资料
| 型号： | ISL6273IRZ |
| 厂商： | Intersil |
| 文件页数： | 10/12页 |
| 文件大小： | 0K |
| 描述： | IC BUCK SYNC ADJ 1.2A 10DFN |
| 产品培训模块： | Solutions for Industrial Control Applications |
| 标准包装： | 100 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 5.5 V |
| 输入电压： | 2.7 V ~ 5.5 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 1.5MHz |
| 电流 - 输出： | 1.2A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | * |
| 封装/外壳： | * |
| 包装： | * |
| 供应商设备封装： | * |
ISL6273
Once the skip mode is entered, the pulse modulation starts
being controlled by the SKIP comparator shown in Figure 17.
Each pulse cycle is still synchronized by the PWM clock. The
N-MOSFET is turned on at the clock and turned off when its
current reaches 20% of the current limit value (0.2V at the
CSA output). As the average inductor current in each cycle
is higher than the average current of the load, the output
voltage rises cycle over cycle. When the output voltage
reaches 1.5% above the nominal voltage, the P-MOSFET is
turned off immediately. Then the inductor current is fully
discharged to zero and stays at zero. The output voltage
reduces gradually due to the load current discharging the
output capacitor. When the output voltage drops to the
nominal voltage, the P-MOSFET will be turned on again at
the clock, repeating the previous operations.
The regulator resumes normal PWM mode operation when
the output voltage drops 1.5% below the nominal voltage.
Mode Control
The ISL6273 has a MODE pin that controls the operation
mode. When the MODE pin is driven to low or shorted to
ground, the regulator operates in a forced PWM mode. The
forced PWM mode remains the fixed PWM frequency at light
load instead of entering the skip mode.
Overcurrent Protection
The overcurrent protection is realized by monitoring the CSA
output with the OCP comparator, as shown in Figure 17. The
current sensing circuit has a gain of 0.4V/A, from the
N-MOSFET current to the CSA output. When the CSA
output reaches 1V, which is equivalent to 2.5A for the switch
current, the OCP comparator is tripped to turn off the
P-MOSFET immediately.
Short-Circuit Protection
A short-circuit protection SCP comparator monitors the FB
pin voltage for output short-circuit protection. When the FB is
lower than 0.2V, the SCP comparator forces the PWM
oscillator frequency to drop to 1/3 of the normal operation
value. This comparator is effective during start-up or an
output short-circuit event.
POR Signal
The ISL6273 offers a power-on reset (POR) signal for
resetting the microprocessor at the power up. When the
output voltage is not within a power-good window, the POR
pin outputs an open-drain low signal to reset the
microprocessor. The output voltage is monitored through the
FB pin. For the fixed output voltage versions, the monitoring
node is the center of the resistive voltage divider. For the
adjustable version, the FB pin voltage is monitored directly.
When the voltage of the monitored node is within the window
of 0.736V and 0.864V, a power-good signal is issued to turn
off the open-drain POR pin. The rising edge of the POR
output is delayed by 200ms.
10
RSI Signal
The RSI signal is a reset input control for the POR signal.
The power-good signal is gated by the RSI signal, as shown
in Figure 17. When the RSI is high, the POR signal will
remain low, independent on the power good signal.
UVLO
When the input voltage is below the undervoltage lock out
(UVLO) threshold, the regulator is disabled.
Soft Start-Up
The soft start-up eliminates the inrush current during the
start-up. The soft start block outputs a ramp reference to
both the voltage loop and the current loop. The two ramps
limit the inductor current rising speed as well as the output
voltage speed so that the output voltage rises in a controlled
fashion. At the very beginning of the start-up, the output
voltage is less than 0.2V; hence the PWM operating
frequency is 1/3 of the normal frequency.
Figure 10 shows the start-up waveforms.
Power MOSFETs
The power MOSFETs are optimized for best efficiency. The
on resistance for the P-MOSFET is typically150m Ω and the
on resistance for the N-MOSFET is typically 150m Ω .
100% Duty Cycle
The ISL6273 features 100% duty cycle operation to
maximize the battery life. When the battery voltage drops to
a level that the ISL6273 can no longer maintain the
regulation at the output, the regulator completely turns on
the P-MOSFET. The maximum drop out voltage under the
100% duty-cycle operation is the product of the load current
and the on resistance of the P-MOSFET.
Enable
The enable (EN) input allows user to control the turning on
or off the regulator for purposes such as power-up
sequencing. The the regulator is enabled, there is typically a
300 μ s delay for waking up the bandgap reference. Then the
soft start-up begins. When the regulator is disabled, the
P-MOSFET is turned off immediately and the N-MOSFET is
turned on.
Thermal Shut Down
The ISL6273 has built-in thermal protection. When the
internal temperature reaches 150°C, the regulator is
completely shut down. As the temperature drops to 130°C,
the ISL6273 resumes operation by stepping through a soft
start-up.
VCC By-Passing
The VCC is voltage is the supply to the internal control circuit
and is derived from the PVIN pin. An internal 10 Ω resistor
connects the two pins and also serves as an filtering resistor.
An external 0.1 μ F ceramic capacitor is recommended to by-
pass the VCC supply.
FN9256.0
March 7, 2006
相关PDF资料 |
PDF描述 |
|---|---|
| A3AT-91K1-00EY | SWITCH PUSH SPST-NO 6A 125V |
| ISL6522CRZ | IC REG CTRLR BST PWM VM 16-QFN |
| A3AT-91K1-00ER | SWITCH PUSH SPST-NO 6A 125V |
| A3AT-91K1-00EG | SWITCH PUSH SPST-NO 6A 125V |
| SBG1630CT-T-F | DIODE SCHOTTKY CC 30V 16A D2-PAK |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6273IRZ-T | 功能描述:IC BUCK SYNC ADJ 1.2A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:4.5V 输入电压:2.65 V ~ 4.35 V PWM 型:电流模式 频率 - 开关:3.5MHz 电流 - 输出:800mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:9-UFBGA，DSBGA 包装:Digi-Reel® 供应商设备封装:9-DSBGA（1.2x1.3） 其它名称:296-29764-6 |
| ISL6274AIRZ-TR5256 | 制造商:Intersil Corporation 功能描述: |
| ISL62771HRTZ | 功能描述:IC PWM CTRLR MULTIPHASE 40TQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:Robust Ripple Regulator™ (R³) 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,000 系列:- 应用:电源，ICERA E400，E450 输入电压:4.1 V ~ 5.5 V 输出数:10 输出电压:可编程 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:42-WFBGA，WLCSP 供应商设备封装:42-WLP 包装:带卷 (TR) |
| ISL62771HRTZ-T | 功能描述:IC PWM CTRLR MULTIPHASE 40TQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:Robust Ripple Regulator™ (R³) 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| ISL62771IRTZ | 功能描述:IC PWM CTRLR MULTIPHASE 40TQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:Robust Ripple Regulator™ (R³) 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,000 系列:- 应用:电源，ICERA E400，E450 输入电压:4.1 V ~ 5.5 V 输出数:10 输出电压:可编程 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:42-WFBGA，WLCSP 供应商设备封装:42-WLP 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。