参数资料
型号: ISL6307ACRZ
厂商: Intersil
文件页数: 12/33页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM VM 48-QFN
标准包装: 43
PWM 型: 电压模式
输出数: 6
频率 - 最大: 275kHz
占空比: 66.7%
电源电压: 4.75 V ~ 5.25 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: 0°C ~ 70°C
封装/外壳: 48-VFQFN 裸露焊盘
包装: 管件
ISL6307A
voltage developed across the lower MOSFET’s R DS(ON) ,
which is the channel current scaled by R DS(ON) and R ISEN .
VR_RDY - VR_RDY is used as an indication of the end of
soft-start with certain delay per Intel VR11. It is an open-
drain logic output that is low impedance until the soft-start is
completed. It will be pulled low again once the undervoltage
point is reached.
OFS - The OFS input pin provides means to program a DC
offset current for generating a DC offset voltage at the REF
input. The offset current is generated via an external resistor
and precision internal voltage references. The polarity of the
offset is selected by connecting the resistor to GND or VCC.
For no offset, the OFS pin should be left unterminated.
TCOMP - Temperature compensation scaling input. The
voltage sensed on the TM pin is utilized as the temperature
input to adjust ldroop and the over current protection limit to
effectively compensate for the temperature coefficient of the
current sense element. To implement the integrated
temperature compensation, a resistor divider circuit is
needed as shown in the typical application diagrams.
Changing the ratio of the resistor values will set the gain of
the integrated thermal compensation. When integrated
temperature compensation function is not used, connect
TCOMP to GND.
OVP - The Overvoltage protection output indication pin. This
pin can be pulled to VCC and is latched when an overvoltage
condition is detected. When not used, keep this pin open.
IDROOP - The output pin of sensed average channel
current which is proportional to load current. In the
application which does not require load-line, leave this pin
open. In the application which requires load-line, connect
this pin to FB so that the sensed average current will flow
through the resistor between FB and VDIFF to create a
voltage drop which is proportional to load current.
IOUT - IOUT has the same output as IDROOP with
additional OCP adjustment function. In actual application, a
resistor needs to be placed between IOUT and GND to
ensure the proper operation. The voltage at IOUT pin will be
proportional to the load current. If the voltage is higher than
2V, ISL6307A will go into OCP mode. The OCP trip level can
be adjusted by changing the resistor value.
DRVEN - Driver enable output pin. This pin can be used to
enable the MOSFET drivers which have enable pins such as
ISL6609, ISL6608 or other DrMOS devices. If ISL6307A is
used with Intersil’s ISL6612 drivers, it’s not necessary to use
this pin.
TM - TM is an input pin for VR temperature measurement.
Connect this pin through a NTC thermistor to GND and a
resistor to 5V. The voltage at this pin is proportional to the
VR temperature. ISL6307A monitors the VR temperature
based on the voltage at TM and triggers VR_FAN and
VR_HOT signals based on the temperature thresholds.
12
VR_HOT - An indication output pin of high VR temperature.
It is an open-drain logic output with low impedance. It will be
pulled high when measured VR temperature reaches certain
level.
VR_FAN - An indication output pin of VR temperature high
warning with open-drain logic. It will be pulled high when
measured VR temperature reaches certain level. VR_FAN
will be pulled high before VR_HOT.
Operation
Multiphase Power Conversion
Microprocessor load current profiles have changed to the
point that the advantages of multiphase power conversion
are impossible to ignore. The technical challenges
associated with producing a single-phase converter which is
both cost-effective and thermally viable, have forced a
change to the cost-saving approach of multiphase. The
ISL6307A controller helps reduce the complexity of
implementation by integrating vital functions and requiring
minimal output components. The block diagrams on pages
4, 5, 6 and 7 provide top level views of multiphase power
conversion using the ISL6307A controller.
IL1 + IL2 + IL3, 7A/DIV
IL3, 7A/DIV
PWM3, 5V/DIV
IL2, 7A/DIV
PWM2, 5V/DIV
IL1, 7A/DIV
PWM1, 5V/DIV
1μs/DIV
FIGURE 1. PWM AND INDUCTOR-CURRENT WAVEFORMS
FOR 3-PHASE CONVERTER
Interleaving
The switching of each channel in a multiphase converter is
timed to be symmetrically out of phase with each of the other
channels. In a 3-phase converter, each channel switches 1/3
cycle after the previous channel and 1/3 cycle before the
following channel. As a result, the three-phase converter has
a combined ripple frequency three times greater than the
ripple frequency of any one phase. In addition, the peak-to-
peak amplitude of the combined inductor current is reduced
in proportion to the number of phases (Equations 1 and 2).
Increased ripple frequency and lower ripple amplitude mean
that the designer can use less per-channel inductance and
lower total output capacitance for any performance
specification.
FN9236.0
February 6, 2006
相关PDF资料
PDF描述
VE-B0Y-EY-B1 CONVERTER MOD DC/DC 3.3V 33W
VE-J5T-EY-F2 CONVERTER MOD DC/DC 6.5V 50W
ECM28DRAN CONN EDGECARD 56POS R/A .156 SLD
EEM36DTKT-S288 CONN EDGECARD 72POS .156 EXTEND
ISL88001IH17Z-T7A IC VOLT SUPERVISOR 1.67V SOT23-3
相关代理商/技术参数
参数描述
ISL6307ACRZ-T 功能描述:IC REG CTRLR BUCK PWM VM 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR)
ISL6307AIRZ 功能描述:IC REG CTRLR BUCK PWM VM 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR)
ISL6307AIRZ-T 功能描述:IC REG CTRLR BUCK PWM VM 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR)
ISL6307BCRZ 功能描述:软开关 PWM 控制器 W/ANNEAL 6-PHS VR11 CNTRLR COM RoHS:否 制造商:Fairchild Semiconductor 输出端数量: 输出电流: 开关频率: 工作电源电压:30 V 电源电流: 最大工作温度:+ 105 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel
ISL6307BCRZ-T 功能描述:软开关 PWM 控制器 W/ANNEAL 6-PHS VR11 CNTRLR COM TAPE AND RoHS:否 制造商:Fairchild Semiconductor 输出端数量: 输出电流: 开关频率: 工作电源电压:30 V 电源电流: 最大工作温度:+ 105 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel