参数资料
| 型号： | ISL6313BIRZ |
| 厂商： | Intersil |
| 文件页数： | 10/33页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR PWM 2PHASE BUCK 36-QFN |
| 产品培训模块： | Solutions for Industrial Control Applications |
| 标准包装： | 50 |
| 应用： | 控制器，Intel VR11，AMD CPU |
| 输入电压： | 5 V ~ 12 V |
| 输出数： | 1 |
| 输出电压： | 0.5 V ~ 1.6 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 36-WFQFN 裸露焊盘 |
| 供应商设备封装： | 36-TQFN 裸露焊盘（6x6） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页
ISL6313B
channel. Tie the ISEN+ pins to the V CORE side of their
corresponding channel’s sense capacitor.
Tieing ISEN2- to VCC programs the part for single phase
operation.
UGATE1 and UGATE2
Connect these pins to the corresponding upper MOSFET
gates. These pins are used to control the upper MOSFETs
and are monitored for shoot-through prevention purposes.
BOOT1 and BOOT2
These pins provide the bias voltage for the corresponding
upper MOSFET drives. Connect these pins to appropriately
chosen external bootstrap capacitors. Internal bootstrap
diodes connected to the PVCC pin provides the necessary
bootstrap charge.
PHASE1 and PHASE2
Connect these pins to the sources of the corresponding
upper MOSFETs. These pins are the return path for the
upper MOSFET drives.
LGATE1 and LGATE2
These pins are used to control the lower MOSFETs. Connect
these pins to the corresponding lower MOSFETs’ gates.
SS
A resistor, R SS , placed from SS to ground or VCC, will set
the soft-start ramp slope. Refer to Equations 20 and 21 for
proper resistor calculation.
The state of the SS pin also selects which of the available DAC
tables will be used to decode the VID inputs and puts the
controller into the corresponding mode of operation. For Intel
VR11 mode of operation the R SS resistor should be tied to
ground. AMD compliance is selected if the R SS resistor is tied
to VCC.
PGOOD
For Intel mode of operation, PGOOD indicates whether VSEN
is within specified overvoltage and undervoltage limits after a
fixed delay from the end of soft-start. If VSEN exceeds these
limits, an overcurrent event occurs, or if the part is disabled,
PGOOD is pulled low. PGOOD is always low prior to the end
of soft-start.
For AMD modes of operation, PGOOD will always be high as
long as VSEN is within the specified undervoltage/overvoltage
window and soft-start has ended. PGOOD only goes low if
VSEN is outside this window.
Operation
only multi-phase converters can accomplish. The ISL6313B
controller helps simplify implementation by integrating vital
functions and requiring minimal external components. The
block diagram on page 3 provides a top level view of multi-
phase power conversion using the ISL6313B controller.
I L1 + I L2 + I L3 , 7A/DIV
I L3 , 7A/DIV
PWM3, 5V/DIV
I L2 , 7A/DIV
PWM2, 5V/DIV
I L1 , 7A/DIV
PWM1, 5V/DIV
1 μ s/DIV
FIGURE 1. PWM AND INDUCTOR-CURRENT WAVEFORMS
FOR 3-PHASE CONVERTER
Interleaving
The switching of each channel in a multi-phase converter is
timed to be symmetrically out of phase with each of the other
channels. In a 3-phase converter, each channel switches 1/3
cycle after the previous channel and 1/3 cycle before the
following channel. As a result, the three-phase converter has
a combined ripple frequency three times greater than the
ripple frequency of any one phase. In addition, the peak-to-
peak amplitude of the combined inductor currents is reduced
in proportion to the number of phases (Equations 1 and 2).
Increased ripple frequency and lower ripple amplitude mean
that the designer can use less per-channel inductance and
lower total output capacitance for any performance
specification.
Figure 1 illustrates the multiplicative effect on output ripple
frequency. The three channel currents (I L1 , I L2 , and I L3 )
combine to form the AC ripple current and the DC load
current. The ripple component has three times the ripple
frequency of each individual channel current. Each PWM
pulse is terminated 1/3 of a cycle after the PWM pulse of the
previous phase. The peak-to-peak current for each phase is
about 7A, and the DC components of the inductor currents
combine to feed the load.
To understand the reduction of ripple current amplitude in the
multi-phase circuit, examine Equation 1 representing an
individual channel peak-to-peak inductor current.
( V IN – V OUT ) ? V OUT
L ? f S ? V
Multiphase Power Conversion
Microprocessor load current profiles have changed to the
I PP = ----------------------------------------------------------
IN
(EQ. 1)
point that using single-phase regulators is no longer a viable
solution. Designing a regulator that is cost-effective,
thermally sound, and efficient has become a challenge that
10
In Equation 1, V IN and V OUT are the input and output
voltages respectively, L is the single-channel inductor value,
and f S is the switching frequency.
FN6809.0
November 6, 2008
相关PDF资料 |
PDF描述 |
|---|---|
| ISL6313IRZ | IC CTRLR PWM 2PHASE BUCK 36-QFN |
| ISL6314IRZ | IC CTRLR PWM 1PHASE BUCK 32-QFN |
| ISL6315IRZ | IC REG CTRLR BUCK PWM VM 24-QFN |
| ISL6316IRZ | IC REG CTRLR BUCK PWM VM 40-QFN |
| ISL6322GIRZ-T | IC CTRLR PWM BUCK 48-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6313BIRZ-T | 功能描述:IC CTRLR PWM BUCK 2PHASE 36-TQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| ISL6313CRZ | 制造商:Intersil Corporation 功能描述:TWO-PHASE BUCK PWM CNTRLR W/ INTEGRATED MOSFET DRVRS FOR INT - Rail/Tube 制造商:Intersil Corporation 功能描述:Switching Controllers 2-PH PWM CNTRLR W/2 INTEGRTD DRVRS 36LD |
| ISL6313CRZ-T | 功能描述:IC CTRLR PWM 2PHASE BUCK 36-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| ISL6313IRZ | 功能描述:IC CTRLR PWM 2PHASE BUCK 36-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| ISL6313IRZ-T | 功能描述:IC CTRLR PWM 2PHASE BUCK 36-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。