- 您现在的位置：买卖IC网 > PDF目录13126 > ISL6322GIRZ (Intersil)IC CTRLR PWM BUCK 48-QFN PDF资料下载
参数资料
| 型号： | ISL6322GIRZ |
| 厂商： | Intersil |
| 文件页数： | 12/39页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR PWM BUCK 48-QFN |
| 标准包装： | 43 |
| 应用： | 控制器，Intel VR10、VR11、AMD CPU |
| 输入电压： | 5 V ~ 12 V |
| 输出数： | 1 |
| 输出电压： | 0.38 V ~ 1.99 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 48-VFQFN 裸露焊盘 |
| 供应商设备封装： | 48-QFN（7x7） |
| 包装： | 管件 |
| 产品目录页面： | 1248 (CN2011-ZH PDF) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页当前第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页
ISL6322G
Phase Dropping
The ISL6322G has the ability to change the number of active
phases firing on-the-fly. This can be done through one of two
I ER toward zero. The same method for error signal
correction is applied to each active channel
.
ways; through the use of the EN_PH2 pin, and through the
I 2 C interface.
The EN_PH2 pin is a digital logic input pin. Tieing this pin
V COMP
+
-
MODULATOR
RAMP
WAVEFORM
+
-
PWM1
TO GATE
CONTROL
LOGIC
high commands the part to operate in single phase mode
FILTER
f(s)
only. If EN_PH2 is tied low the part can operate in either
single phase or 2-phase mode depending on the state of
Bit 6 of I 2 C register 2. When the controller first powers up
I ER
-
I AVG
÷ N
Σ
I SEN2
Bit 6 is preset to “0”, which commands the controller to
operate in 2-phase mode. Changing bit 6 to a “1” commands
the controller to operate in single phase mode. For details on
how to change the state of the I 2 C registers please refer to
the “I 2 C Bus Interface” on page 26. If EN_PH2 is tied high,
the controller will operate in single phase mode only and will
ignore the state of Bit 6 in register 2, not allowing the I 2 C
interface to control the number of channel’s firing.
Once the ISL6322G receives a signal to change the number
of active phases it immediately responds by dropping or
adding phase 2 with no delay. When dropping from 2-phase
to single phase mode both LGATE2 and UGATE2 are
immediately tied low. These signals will stay in this state until
the controller is commanded to run in 2-phase mode again.
At this point LGATE2 and UGATE2 will be released to fire
normally.
Channel-Current Balance
One important benefit of multiphase operation is the thermal
advantage gained by distributing the dissipated heat over
multiple devices and greater area. By doing this the designer
avoids the complexity of driving parallel MOSFETs and the
expense of using expensive heat sinks and exotic magnetic
materials.
In order to realize the thermal advantage, it is important that
each channel in a multiphase converter be controlled to
carry equal amounts of current at any load level. To achieve
this, the currents through each channel must be sampled
every switching cycle. The sampled currents, I n , from each
active channel are summed together and divided by the
number of active channels. The resulting cycle average
current, I AVG , provides a measure of the total load-current
demand on the converter during each switching cycle.
Channel-current balance is achieved by comparing the
sampled current of each channel to the cycle average
current, and making the proper adjustment to each channel
pulse width based on the error. Intersil’s patented
current-balance method is illustrated in Figure 3, with error
correction for Channel 1 represented. In the figure, the cycle
average current, I AVG , is compared with the Channel 1
sample, I 1 , to create an error signal I ER .
The filtered error signal modifies the pulse width
commanded by V COMP to correct any unbalance and force
12
+
I SEN1
FIGURE 3. CHANNEL-1 PWM FUNCTION AND
CURRENT-BALANCE ADJUSTMENT
Continuous Current Sampling
In order to realize proper current-balance, the currents in
each channel are sensed continuously every switching
cycle. During this time the current-sense amplifier uses the
ISEN inputs to reproduce a signal proportional to the
inductor current, I L . This sensed current, I SEN , is simply a
scaled version of the inductor current.
PWM
SWITCHING PERIOD
I L
I SEN
TIME
FIGURE 4. CONTINUOUS CURRENT SAMPLING
The ISL6322G supports inductor DCR current sensing to
continuously sense each channel’s current for
channel-current balance (see Figure 4). The internal
circuitry, shown in Figure 5 represents Channel N of an
N-Channel converter. This circuitry is repeated for each
channel in the converter, but may not be active depending
on how many channels are operating.
FN6715.0
May 22, 2008
相关PDF资料 |
PDF描述 |
|---|---|
| 1945-32J | COIL RF 510UH MOLDED UNSHIELDED |
| HSC17DRYS-S93 | CONN EDGECARD 34POS DIP .100 SLD |
| GCC44DRYS-S93 | CONN EDGECARD 88POS DIP .100 SLD |
| VI-B6H-EU-F3 | CONVERTER MOD DC/DC 52V 200W |
| ESC26DRTS-S93 | CONN EDGECARD 52POS DIP .100 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6322GIRZ-T | 功能描述:IC CTRLR PWM BUCK 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| ISL6322IRZ | 功能描述:IC CTRLR PWM 4PHASE BUCK 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,000 系列:- 应用:电源，ICERA E400，E450 输入电压:4.1 V ~ 5.5 V 输出数:10 输出电压:可编程 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:42-WFBGA，WLCSP 供应商设备封装:42-WLP 包装:带卷 (TR) |
| ISL6322IRZ-T | 功能描述:IC CTRLR PWM 4PHASE BUCK 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,000 系列:- 应用:电源，ICERA E400，E450 输入电压:4.1 V ~ 5.5 V 输出数:10 输出电压:可编程 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:42-WFBGA，WLCSP 供应商设备封装:42-WLP 包装:带卷 (TR) |
| ISL6323ACRZ | 功能描述:IC PWM CTRLR SYNC BUCK DL 48QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| ISL6323ACRZR5381 | 制造商:Intersil Corporation 功能描述:4+1 PHASE CONT. FOR CORE+NORTHBRIDGE,1 PHASE PSI, 3.4MHZ SVI - Rail/Tube 制造商:Intersil Corporation 功能描述:IC PWM CTRLR SYNC BUCK DL 48QFN |
发布紧急采购，3分钟左右您将得到回复。