- 您现在的位置：买卖IC网 > PDF目录15184 > ISL6341IRZ (Intersil)IC REG CTRLR BUCK PWM VM 10-TDFN PDF资料下载
参数资料
| 型号： | ISL6341IRZ |
| 厂商： | Intersil |
| 文件页数： | 10/17页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 10-TDFN |
| 标准包装： | 100 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 330kHz |
| 占空比： | 85% |
| 电源电压： | 4.5 V ~ 14.4 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 包装： | 管件 |
ISL6341, ISL6341A, ISL6341B, ISL6341C
4ms during the sampling; that could discharge a pre-biased
output. Therefore, to avoid that case, but still come close to
disabling OCP, a resistor (>60k Ω ) is recommended.
Note that conditions during power-up may look different than
normal operation. For example, during power-up in a 12V
system, the IC starts operation just above 4V; if the supply
ramp is slow, the soft-start ramp might be over well before
12V is reached. So with lower gate drive voltages, the
r DS(ON) of the MOSFETs will be higher during power-up,
effectively lowering the OCP trip. In addition, the ripple
75%
GND>
LGATE (12V/DIV)
V OUT (0.25V/DIV)
current will likely be different at lower input voltage.
Another factor is the digital nature of the soft-start ramp. On
each discrete voltage step, there is in effect a small load
transient and a current spike to charge the output capacitors.
The height of the current spike is not controlled; it is affected
by the step size of the output, the value of the output
capacitors, as well as the IC error amp compensation. So it
is possible to trip the overcurrent with in-rush current, in
addition to the normal load and ripple considerations.
OCP is always enabled during soft-start, so there is
protection starting up into a shorted load.
Undervoltage Protection
The output is protected against undervoltage conditions by
monitoring the VOS pin. An external resistor divider (similar
ratio to the one on the FB pin) makes the voltage equal the
0.8V internal reference under normal operation. If the output
goes too low (25% below 0.8V = 0.6V nominal on VOS), the
output will latch off, with UGATE and LGATE both forced low.
This requires toggling V CC (power-down and up) to restart
(toggling COMP/EN will NOT restart it). The UV protection is
not enabled until the end of the soft-start ramp (as shown in
Figure 2).
Figure 7 shows a case where V OUT (and thus VOS) is pulled
down to the 75% point; both gate drivers stop switching, and
the V OUT is pulled low by the disturbance, as well as the
load, at a rate determine by the conditions, and the output
components.
The ISL6341C version does not have UVP; it relies on the
OCP for shorted loads. The PGOOD UV comparator is
separate, and is still active.
10
GND>
UGATE (24V/DIV)
GND>
FIGURE 7. UNDERVOLTAGE PROTECTION
Overvoltage Protection
The output is protected against overvoltage conditions by
monitoring the VOS pin, similar to undervoltage. If the output
goes too high (25% above 0.8V = 1.0V nominal on VOS), the
output will latch off. As shown in Figure 8, UGATE will be
forced low, but LGATE will be forced high (to try to pull-down
the output) until the output drops to 1/2 of the normal voltage
(50% of 0.8V = 0.4V nominal on VOS). The LGATE will then
shut off, but will keep turning back on whenever the output
goes too high again.
Overvoltage latch-off requires toggling V CC (power-down and
up) to restart (toggling COMP/EN will NOT restart it). The OV
protection is not enabled until the rising V CC POR trip point is
exceeded. The OV protection is active during soft-start at the
fixed 25% above the final expected voltage. The OVP is not
gated off by tripping OCP (but the UVP is gated off if OCP
trips first).
If the VOS pin is disconnected, a small bias current on-chip
will force an overvoltage condition.
V OUT (0.5V/DIV)
125%
50%
GND>
LGATE (12V/DIV)
GND>
UGATE (24V/DIV)
GND>
FIGURE 8. OVERVOLTAGE PROTECTION
FN6538.2
December 2, 2008
相关PDF资料 |
PDF描述 |
|---|---|
| B43088A9226M | 22UF 400V 12.5X25 SINGLE END |
| VI-2T1-EY-B1 | CONVERTER MOD DC/DC 12V 50W |
| B41043A5108M | 1000UF 25V 12.5X25 SINGLE END |
| ISL6439IBZ | IC REG CTRLR BUCK PWM VM 14-SOIC |
| ISL8106CRZ-T | IC REG CTRLR BUCK PWM VM 16-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6341IRZ-T | 功能描述:IC REG CTRLR BUCK PWM VM 10-TDFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6353CRTZ | 功能描述:电流型 PWM 控制器 VR12 MEMORY CNTRLR 3 PHS 2 INT 5V DRVRS RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| ISL6353CRTZ-T | 功能描述:电流型 PWM 控制器 VR12 MEMORY CNTRLR 3 PHS 2 INT 5V DRVRS RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| ISL6353CRTZ-TS2568 | 制造商:Intersil Corporation 功能描述:INTEL, ISL6353CRTZ-T W/BARCODE LABELS, 12 MONTH D/C RESTRICT - Tape and Reel |
| ISL6353CRZ | 制造商:Intersil 功能描述:Multiphase PWM Regulator for VR12 DDR Memory Systems |
发布紧急采购，3分钟左右您将得到回复。