- 您现在的位置：买卖IC网 > PDF目录15062 > ISL6569CB (Intersil)IC REG CTRLR DIVIDER PWM 24-SOIC PDF资料下载
参数资料
| 型号： | ISL6569CB |
| 厂商： | Intersil |
| 文件页数： | 1/22页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR DIVIDER PWM 24-SOIC |
| 标准包装： | 30 |
| PWM 型： | 控制器 |
| 输出数： | 1 |
| 频率 - 最大： | 2MHz |
| 占空比： | 75% |
| 电源电压： | 4.75 V ~ 5.25 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 是 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 24-SOIC（0.295"，7.50mm 宽） |
| 包装： | 管件 |
?
ISL6569
Data Sheet
December 29, 2004
FN9085.7
Multi-Phase PWM Controller
The ISL6569 provides core-voltage regulation by driving two
interleaved synchronous-rectified buck-converter channels
in parallel. Interleaving the channel timing results in
increased ripple frequency which reduces input and output
ripple currents. The reduction in ripple results in lower
component cost, reduced dissipation, and a smaller
implementation area.
The ISL6569 uses cost and space-saving r DS(ON) sensing
for channel current balance, active voltage positioning, and
over-current protection. Output voltage is monitored by an
internal differential remote sense amplifier. A high-bandwidth
error amplifier drives the output voltage to match the
programmed 5-bit DAC reference voltage. The resulting
compensation signal guides the creation of pulse width
modulated (PWM) signals to control companion Intersil
MOSFET drivers. The OFS pin allows direct offset of the
DAC voltage from 0V to 50mV using a single external
resistor. The reference and amplifiers are trimmed to ensure
a system accuracy of ± 1 % over temperature.
Outstanding features of this controller IC include
Dynamic VID TM technology allowing seamless on-the-fly VID
changing without the need of any external components.
Output voltage “droop” or active voltage positioning is
optional. When employed, it allows the reduction in size and
cost of the output capacitors required to support load
transients. A threshold-sensitive enable input allows the use
of an external resistor divider for start-up coordination with
Intersil MOSFET drivers or any other devices powered from
a separate supply.
Superior over-voltage protection is achieved by gating on the
lower MOSFET of all phases to crowbar the output voltage.
An optional second crowbar on V IN , formed with an external
MOSFET or SCR gated by the OVP pin, is triggered when
an over-voltage condition is detected. Under-voltage
conditions are detected, but PWM operation is not disrupted.
Over-current conditions cause a hiccup-mode response as
the controller repeatedly tries to restart. After a set number
of failed startup attempts, the controller latches off. A power
good logic signal indicates when the converter output is
between the UV and OV thresholds.
Features
? Multi-Phase Power Conversion
- 2 Phase Operation
? Active Channel Current Balancing
? Precision r DS(ON) Current Sharing
- Lossless
- Low Cost
? Input Voltage: 12V or 5V Bias
? Precision CORE Voltage Regulation
- ± 1 % System Accuracy Over Temperature
- Differential Remote Output Voltage Sensing
- Programmable Reference Offset
? Microprocessor Voltage Identification Input
- 5-Bit VID Input
- 0.800V to 1.550V in 25mV Steps
- Dynamic VID TM Technology
? Programmable Droop Voltage
? Fast Transient Recovery Time
? Over Current Protection
? Digital Soft Start
? Threshold Sensitive Enable Input
? High Ripple Frequency (160kHz to 2MHz)
? QFN Package:
- Compliant to JEDEC PUB95 MO-220 QFN - Quad Flat
No Leads - Package Outline
- Near Chip Scale Package footprint, which improves
PCB efficiency and has a thinner profile
? Pb-Free Available (RoHS Compliant)
Applications
? AMD Hammer Family Processor Voltage Regulator
? Low Output Voltage, High Current DC-DC Converters
? Voltage Regulator Modules
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright ? Intersil Americas Inc. 2002-2004. All Rights Reserved. All other trademarks mentioned are the property of their respective owners.
Dynamic VID? is a trademark of Intersil Americas Inc.
相关PDF资料 |
PDF描述 |
|---|---|
| VI-B5N-EV-F4 | CONVERTER MOD DC/DC 18.5V 150W |
| VI-JTR-EY-F2 | CONVERTER MOD DC/DC 7.5V 50W |
| ISL6565BCV | IC REG CTRLR BUCK PWM VM 28TSSOP |
| VI-JTR-EY-F1 | CONVERTER MOD DC/DC 7.5V 50W |
| VI-B5M-EV-F4 | CONVERTER MOD DC/DC 10V 150W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6569CB-T | 功能描述:IC REG CTRLR DIVIDER PWM 24-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:100% 电源电压:8.2 V ~ 30 V 降压:无 升压:无 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:0°C ~ 70°C 封装/外壳:8-DIP（0.300"，7.62mm） 包装:管件 产品目录页面:1316 (CN2011-ZH PDF) |
| ISL6569CBZ | 功能描述:IC REG CTRLR DIVIDER PWM 24-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6569CBZ-T | 功能描述:IC REG CTRLR DIVIDER PWM 24-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6569CR | 功能描述:IC REG CTRLR DIVIDER PWM 32-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:100% 电源电压:8.2 V ~ 30 V 降压:无 升压:无 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:0°C ~ 70°C 封装/外壳:8-DIP（0.300"，7.62mm） 包装:管件 产品目录页面:1316 (CN2011-ZH PDF) |
| ISL6569CR-T | 功能描述:IC REG CTRLR DIVIDER PWM 32-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:100% 电源电压:8.2 V ~ 30 V 降压:无 升压:无 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:0°C ~ 70°C 封装/外壳:8-DIP（0.300"，7.62mm） 包装:管件 产品目录页面:1316 (CN2011-ZH PDF) |
发布紧急采购，3分钟左右您将得到回复。