- 您现在的位置：买卖IC网 > PDF目录15187 > ISL6569CRZ-T (Intersil)IC REG CTRLR DIVIDER PWM 32-QFN PDF资料下载
参数资料
| 型号： | ISL6569CRZ-T |
| 厂商： | Intersil |
| 文件页数： | 14/22页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR DIVIDER PWM 32-QFN |
| 标准包装： | 6,000 |
| PWM 型： | 控制器 |
| 输出数： | 1 |
| 频率 - 最大： | 2MHz |
| 占空比： | 75% |
| 电源电压： | 4.75 V ~ 5.25 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 是 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 32-VFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
ISL6569
Following the delay, the soft start ramps linearly until V RAMP
reaches VID. For the system described above, this first linear
ramp will continue for approximately
I
PGOOD
t RAMP1 = ----------- – t DELAY
T SS
1.4
= 5.27ms
(EQ. 11)
UV
The final portion of the soft-start sequence is the time
remaining after V RAMP reaches VID and before I RAMP gets to
+
350mV
-
POR
CIRCUIT
OC
-
+
90 μ A
I AVG
zero. This is also characterized by a slight change in the slope
of the output voltage ramp which, for the current example,
exists for a time of
DAC
REFERENCE
t RAMP2 = T SS – t RAMP1 – t DELAY
(EQ. 12)
VDIFF
+
-
OV
OVP
= 2.34ms
This behavior is seen in the example in Figure 10 of a converter
switching at 500kHz. For this converter, R FB is set to 2.67k ?
leading to T SS = 4.0ms, t DELAY = 700ns, t RAMP1 = 2.23ms,
and t RAMP2 = 1.17ms.
VOUT, 500mV/DIV
EN, 5V/DIV
2.2V
FIGURE 11. POWER GOOD AND PROTECTION CIRCUITRY
Power Good Signal
The power good pin (PGOOD) is an open-drain logic output
which indicates that the converter is operating properly and
the output voltage is within a set window. The under-voltage
(UV) and over-voltage (OV) comparators create the output
voltage window. The controller also takes advantage of
current feedback to detect output over-current (OC)
conditions. PGOOD pulls low during shutdown and releases
high during soft-start once the output voltage exceeds the
UV threshold. Once high, PGOOD will only transition low
when the controller is disabled or a fault condition is
detected. It will return high under certain circumstances
once a fault clears.
Under-Voltage Protection
The voltage on V DIFF is internally offset by 350mV before it
is compared with the DAC reference voltage. By positively
offsetting the output voltage, an UV threshold is created
t DELAY t RAMP1
t RAMP2
1ms/DIV
which moves relative to the VID code. During soft-start, the
slow rising output voltage eventually exceeds the UV
FIGURE 10. SOFT-START WAVEFORMS FOR ISL6569 BASED
MULTI-PHASE BUCK CONVERTER
NOTE: Switching frequency 500kHz and R FB = 2.67k ?
Fault Monitoring and Protection
The ISL6569 actively monitors voltage and current feedback
to detect fault conditions. Fault monitors trigger protective
measures to prevent damage to a microprocessor load. One
common power good indication signal is provided for linking
to external system monitors. The schematic in Figure 11
outlines the interaction between the fault monitors and the
power good signal.
14
threshold. Assuming the POR leg of the PGOOD NOR gate
has not detected an OC fault, the PGOOD signal will go
high.
If a fault condition arises during operation and the output
voltage drops below the UV threshold, PGOOD will
immediately pull low, but converter operation will continue.
PGOOD will return high once the output voltage surpasses
the UV threshold.
f the ISL6569 is disabled during operation, the PGOOD
signal will not pull low until the output voltage decays below
the UV threshold.
Over-Voltage Protection
When the output of the differential amplifier (VDIFF) reaches
2.2V, PGOOD immediately goes low indicating a fault. Two
protective actions are taken by the ISL6569 to protect the
microprocessor load.
FN9085.7
December 29, 2004
相关PDF资料 |
PDF描述 |
|---|---|
| H4BBG-10110-G1-ND | JUMPER-H9991TR/A3047G/H9991TR10" |
| H4BBG-10110-B1-ND | JUMPER-H9991TR/A3047B/H9991TR10" |
| H4BBG-10110-A1-ND | JUMPER-H9991TR/A3047A/H9991TR10" |
| B41043A4158M | 1500UF 16V 12.5X25 SINGLE END |
| ISL6744AUZ-TR5252 | IC REG CTRLR BUCK PWM VM 8-MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6571CR | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Intersil Corporation 功能描述: |
| ISL6571CR-T | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| ISL6571CRZ | 功能描述:IC MOSF DRVR/SYNC SW COMPL 68QFN RoHS:是 类别:集成电路 (IC) >> PMIC - MOSFET，电桥驱动器 - 内部开关 系列:- 标准包装:1,000 系列:- 类型:高端/低端驱动器 输入类型:SPI 输出数:8 导通状态电阻:850 毫欧，1.6 欧姆 电流 - 输出 / 通道:205mA，410mA 电流 - 峰值输出:500mA，1A 电源电压:9 V ~ 16 V 工作温度:-40°C ~ 150°C 安装类型:表面贴装 封装/外壳:20-SOIC（0.295"，7.50mm 宽） 供应商设备封装:PG-DSO-20-45 包装:带卷 (TR) |
| ISL6580CR | 功能描述:IC DRIVER HIGH SIDE FET 56-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - MOSFET，电桥驱动器 - 内部开关 系列:- 标准包装:1,000 系列:- 类型:高端/低端驱动器 输入类型:SPI 输出数:8 导通状态电阻:850 毫欧，1.6 欧姆 电流 - 输出 / 通道:205mA，410mA 电流 - 峰值输出:500mA，1A 电源电压:9 V ~ 16 V 工作温度:-40°C ~ 150°C 安装类型:表面贴装 封装/外壳:20-SOIC（0.295"，7.50mm 宽） 供应商设备封装:PG-DSO-20-45 包装:带卷 (TR) |
| ISL6580CR-T | 功能描述:IC DRIVER HIGH SIDE FET 56-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - MOSFET，电桥驱动器 - 内部开关 系列:- 标准包装:1,000 系列:- 类型:高端/低端驱动器 输入类型:SPI 输出数:8 导通状态电阻:850 毫欧，1.6 欧姆 电流 - 输出 / 通道:205mA，410mA 电流 - 峰值输出:500mA，1A 电源电压:9 V ~ 16 V 工作温度:-40°C ~ 150°C 安装类型:表面贴装 封装/外壳:20-SOIC（0.295"，7.50mm 宽） 供应商设备封装:PG-DSO-20-45 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。