- 您现在的位置：买卖IC网 > PDF目录14647 > ISL8014IRZ-T (Intersil)IC REG BUCK SYNC ADJ 4A 16QFN PDF资料下载
参数资料
| 型号： | ISL8014IRZ-T |
| 厂商： | Intersil |
| 文件页数： | 15/16页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 4A 16QFN |
| 产品培训模块： | ISL8013/4 Synchronous Buck Regulators |
| 标准包装： | 1 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 5.5 V |
| 输入电压： | 2.7 V ~ 5.5 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 1MHz |
| 电流 - 输出： | 4A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-VQFN 裸露焊盘 |
| 包装： | 标准包装 |
| 供应商设备封装： | 16-QFN（4x4） |
| 产品目录页面： | 1248 (CN2011-ZH PDF) |
| 其它名称： | ISL8014IRZ-TDKR |
ISL8014
Revision History
The revision history provided is for informational purposes only and is believed to be accurate, but not warranted. Please go to
web to make sure you have the latest Rev.
DATE
11/23/09
09/10/09
08/04/08
12/20/07
11/28/07
REVISION
FN6576.4
FN6576.3
FN6576.2
FN6576.1
FN6576.0
CHANGE
Updated on page 13 in UVLO section, last sentence from “...programming resistor R5..., The
value of R4...” to “...programming resistor R4..., The value of R5...”. Replaced Figure 38,
Removed Equation after Figure 38. Reworded last sentence in Enable section from “It is
necessary to keep the voltage on the EN low until Vin is greater than 2.5V” to “It is
recommended that the EN voltage should be kept logic low (less than 400mV), until VIN
reaches 2.5V. Refer to Figure 39 for suggested circuit implementation with VIN slew rate.
Added Figure 39. Added Equations 1 and 2 and referencing text.
Added Revision History and Products information.
Moved Soft-Start section to read after PG section on page 13, changed "R4" to "R5" in last
sentence of UVLO section, added reference of both Figures 38 and 39 in Enable section.
9/10/09:
Page 6; Revised last sentence of EN section from:
"Do not leave this pin floating." TO:"Do not connect directly to VIN or leave this pin floating."
9/2/09:
Page 2: Order Info: Added MSL link to Order Info per new standard
Page 2: Revised Typical Application Diagram
Pages 4-5: Per new Intersil standard: Added "Boldface limits apply over the operating
temperature range, -40°C to +85°C." to common conditions of Electrical Specs table. Bolded
MIN MAX columns where applicable. Moved "Parameters with MIN and/or MAX limits are 100%
tested at +25°C, unless otherwise specified. Temperature limits established by
characterization and are not production tested." from common conditions of Electrical Specs
table to note in Min Max columns.
Page 6: Added following sentence to EN pin description:
" Keep the EN voltage low in disabled state until Vin settle or above 2.5V."
Revised "FIGURE 37. SKIP MODE OPERATION WAVEFORMS
Page 14: Added FIGURE 38. EXTERNAL RESISTOR DIVIDER graphic and following sentence to
UVLO section:
"To adjust the voltage level of power on and UVLO, use a resistive divider across EN. The input
voltage programming resistor R5 will depend on on the bottom resistor R4, as referred to in
Figure 38. The value of R4 is typically between 10kohm and 100kohm."
Added equation 1 to UVLO section:
Added following sentence to Enable section:
"It is necessary to keep the voltage of the EN low until Vin is greater than 2.5V."
Added to VIN, VDD and LX in Abs Max Rating (DC) or 7V (20ms). Added Intersil Standards as
follows: Added to Electrical Specs conditions at top over-temp note. Updated POD L16.4x4 to
latest version.
Removed the MIN and MAX value of "Peak Skip Limit " in the EC table at page 4.
Replaced the Trans-Resistance (RT) value "0.18" into "0.17" for MIN and "0.22" into "0.23" for
MAX in the EC table on page 4.
Initial Release to web
Products
Intersil Corporation is a leader in the design and manufacture of high-performance analog semiconductors. The
Company's products address some of the industry's fastest growing markets, such as, flat panel displays, cell
phones, handheld products, and notebooks. Intersil's product families address power management and analog
signal processing functions. Go to www.intersil.com/products for a complete list of Intersil product families.
*For a complete listing of Applications, Related Documentation and Related Parts, please see the respective
device information page on intersil.com: ISL8014
To report errors or suggestions for this datasheet, please go to www.intersil.com/askourstaff
FITs are available from our website at http://rel.intersil.com/reports/search.php
15
FN6576.4
November 23, 2009
相关PDF资料 |
PDF描述 |
|---|---|
| HBC20DREH-S734 | CONN EDGECARD 40POS .100 EYELET |
| GSC28DRXN-S734 | CONN EDGECARD 56POS DIP .100 SLD |
| GSC26DRXI-S734 | CONN EDGECARD 52POS DIP .100 SLD |
| VI-J52-CY | CONVERTER MOD DC/DC 15V 50W |
| VI-J51-CZ-S | CONVERTER MOD DC/DC 12V 25W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL8014IRZ-TS2715 | 制造商:Intersil Corporation 功能描述:S SPEC FOR TRACKING BROADCOM BUSINESS ONLY-SOLD THRU DISTI - Tape and Reel |
| ISL8016 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:6A Low Quiescent Current High Efficiency Synchronous Buck Regulator |
| ISL8016_1105 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:6A Low Quiescent Current High Efficiency Synchronous Buck Regulator |
| ISL8016CIR1EVAL1Z | 功能描述:EVAL BOARD 1 FOR ISL8016CIR RoHS:是 类别:编程器，开发系统 >> 评估板 - DC/DC 与 AC/DC（离线）SMPS 系列:- 标准包装:1 系列:- 主要目的:DC/DC，步降 输出及类型:1，非隔离 功率 - 输出:- 输出电压:3.3V 电流 - 输出:3A 输入电压:4.5 V ~ 28 V 稳压器拓扑结构:降压 频率 - 开关:250kHz 板类型:完全填充 已供物品:板 已用 IC / 零件:L7981 其它名称:497-12113STEVAL-ISA094V1-ND |
| ISL8016IR12Z | 功能描述:IC REG BUCK SYNC 1.2V 6A 20QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:1 输出电压:5V，1 V ~ 10 V 输入电压:3.5 V ~ 28 V PWM 型:电流模式 频率 - 开关:220kHz ~ 1MHz 电流 - 输出:600mA 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:16-SSOP（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:16-QSOP |
发布紧急采购，3分钟左右您将得到回复。