- 您现在的位置：买卖IC网 > PDF目录14588 > ISL8540IVEZ (Intersil)IC REG BUCK SYNC ADJ 2A 20HTSSOP PDF资料下载
参数资料
| 型号： | ISL8540IVEZ |
| 厂商： | Intersil |
| 文件页数： | 11/16页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 2A 20HTSSOP |
| 标准包装： | 74 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 1.21 V ~ 35 V |
| 输入电压： | 9 V ~ 40 V |
| PWM 型： | 电压模式 |
| 频率 - 开关： | 100kHz ~ 600kHz |
| 电流 - 输出： | 2A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-TSSOP（0.173"，4.40mm 宽）裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 20-TSSOP-EP |
| 产品目录页面： | 1248 (CN2011-ZH PDF) |
ISL8540
Applications Information
and a capacitor from RTCT to GND are used to program the
C 1 [ nF ] = ----------------- ? ------------------------------ – 0.3 ?
R [ k Ω ] ? f OSC [ kHz ]
Product Description
The ISL8540 is a non-synchronous, integrated FET 2A step
down regulator which operates from an unregulated input of
switching frequency through Equation 2.
6.25 1000
?
(EQ. 2)
R 2 × 1.21V
R 3 = --------------------------------------
9V to 40V. The output voltage is user-adjustable with a pair
of external resistors. Frequency of operation is adjustable
from 100kHz to 600kHz set by RTCT. An external signal with
higher frequency can be injected to SYNCH to synchronize
the controller.
The buck controller drives an internal N-Channel MOSFET
and requires an external diode to deliver load current up to
2A. A Schottky diode is recommended for improved
efficiency and performance over a standard diode. The
converter output is regulated down to 1.21V from an input
source. These features make the ISL8540 ideally suited for
telecommunication power applications.
The PWM control loop uses a single output voltage loop with
input voltage feed forward which simplifies feedback loop
compensation and rejects input voltage variation. External
feedback loop compensation allows flexibility in output filter
component selection.
The buck regulator is equipped with a lossless current limit
scheme. The current limit in the buck regulator is achieved
by monitoring the drain-to-source current of the internal
switching power MOSFET. The current limit threshold is
internally set at 4.5A peak. Additional features include
programmable soft-start to support proper start-up of wide
output capacitance range.
Start-Up and Shut-Down
When the EN pin is connected to a logic high, the ISL8540 is
in the shut-down mode. All the control circuitry and both
MOSFETs are off, and V OUT falls to zero. In this mode, the
total input current is less than 110μA.
When the EN pin is tied to GND, and V IN reaches
approximately 9V, the regulator begins to switch. The output
voltage is gradually increased to ensure proper soft-start
operation.
When the EN reaches logic LOW, the regulator repeats the
start-up procedure, including the soft-start function. Connect
a capacitor from SS pin to ground. This capacitor, along with
an internal 10μA current source sets the soft-start interval of
the converter, t SS .
Caution: When the ISL8540 is in disabled state, the voltage
across RTCT pin will reach V IN voltage. Make sure that the
voltage rating of the RTCT capacitor is rated as high as the
input voltage.
Output Voltage Selection
The output voltage of the regulator can be programmed via
an external resistor divider that is used to scale the output
voltage relative to the internal reference voltage and feed it
back to the inverting input of the error amplifier. Refer to
Figure 28.
The output voltage programming resistor, R 3 , will depend on
the value chosen for the feedback resistor and the desired
output voltage of the regulator. The value for the feedback
resistor is typically between 1k Ω and 10k Ω .
(EQ. 3)
V OUT – 1.21V
If the output voltage desired is 1.21V, then R 3 is left
unpopulated.
Fault Protection
The ISL8540 monitors the output of the regulator for
overcurrent and undervoltage events. The ISL8540 also
provides protection from excessive junction temperatures.
Overcurrent Protection
The overcurrent function protects the switching converter from
a shorted output by monitoring the current flowing through the
upper MOSFETs.
Upon detection of overcurrent condition, the upper MOSFET
will be immediately turned off and will not be turned on again
until the next switching cycle. Upon detection of the initial
overcurrent condition, the overcurrent fault counter is set to
1 and the overcurrent condition flag is set from LOW to
HIGH. If, on the subsequent cycle, another overcurrent
condition is detected, the OC fault counter will be
incremented. If there are 16 sequential OC fault detections,
the regulator will be shut down under an overcurrent fault
condition. An overcurrent fault condition will result with the
regulator attempting to restart in a hiccup mode with the
C SS [ μ F ] ≈ 8.3 ? t SS [ s ]
(EQ. 1)
delay between restarts being 4 soft-start periods. At the end
of the fourth soft-start wait period, the fault counters are
Operating Frequency
The ISL8540 can operate at switching frequencies from
100kHz to 600kHz. A resistor tied from the RTCT pin to VIN
11
reset and soft-start is attempted again. If the overcurrent
condition goes away prior to the OC fault counter reaching a
count of four, the overcurrent condition flag will set back to
LOW.
If the overcurrent condition flag is HIGH and the overcurrent
fault counter is less than four and an undervoltage event is
detected, the regulator will be shut down immediately.
FN6495.5
September 9, 2008
相关PDF资料 |
PDF描述 |
|---|---|
| MAX6468XS20D7+T | IC MPU/RESET CIRC 2.00V SC70-4 |
| MAX6468XS24D3+T | IC MPU/RESET CIRC 2.400V SC70-4 |
| MAX6467XS23D7+T | IC MPU/RESET CIRC 2.313V SC70-4 |
| 381LQ561M315J052 | CAP ALUM 560UF 315V 20% SNAP |
| 380LX271M450A022 | CAP ALUM 270UF 450V 20% SNAP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL8540IVEZ-T | 功能描述:IC REG BUCK SYNC ADJ 2A 20HTSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:1 输出电压:5V，1 V ~ 10 V 输入电压:3.5 V ~ 28 V PWM 型:电流模式 频率 - 开关:220kHz ~ 1MHz 电流 - 输出:600mA 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:16-SSOP（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:16-QSOP |
| ISL85410FRZ | 制造商:Intersil Corporation 功能描述:36VIN 1A SYNCHRONOUS SWITCHING REGULATOR- 4X3 12LD DFN PB-FR - Rail/Tube 制造商:Intersil Corporation 功能描述:IC REG BUCK SYNC ADJ 1A 12DFN |
| ISL85410FRZ-T | 制造商:Intersil Corporation 功能描述:36VIN 1A SYNCHRONOUS SWITCHING REGULATOR 4X3 12LD DFN T&R - Tape and Reel 制造商:Intersil Corporation 功能描述:IC REG BUCK SYNC ADJ 1A 12DFN |
| ISL85410FRZ-T7A | 制造商:Intersil Corporation 功能描述:IC REG BUCK SYNC ADJ 1A 12DFN |
| ISL85412FRTZ | 制造商:Intersil Corporation 功能描述:36VIN 150MA SYNCHRONOUS SWITCHING REGULATOR- 3X3 8LD TDFN PB - Tape and Reel |
发布紧急采购，3分钟左右您将得到回复。