- 您现在的位置：买卖IC网 > PDF目录16590 > ISL97652IRZ-TK (Intersil)IC LCD SUPPLY 4CH DUAL AMP 48QFN PDF资料下载
参数资料
| 型号： | ISL97652IRZ-TK |
| 厂商： | Intersil |
| 文件页数： | 19/25页 |
| 文件大小： | 0K |
| 描述： | IC LCD SUPPLY 4CH DUAL AMP 48QFN |
| 标准包装： | 1,000 |
| 应用： | LCD 电视机/监控器 |
| 电流 - 电源： | 500µA |
| 电源电压： | 8 V ~ 15 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 48-VFQFN 裸露焊盘 |
| 供应商设备封装： | 48-QFN（7x7） |
| 包装： | 带卷 (TR) |
ISL97652
VGH
VGHM
SLOPE CONTROLLED
VFLK
VGL
0
BY RE AND LOAD
CAPACITANCE
t
0
T CE
t
DELAY TIME CONTROLLED BY CE
~1.94V
CE
~1.265V
0
FIGURE 21. VON-SLICE TIMING WAVEFORM
t
High Performance V COM Amplifiers
The integrated high performance amplifiers are designed to
drive the V COM plane in TFT-LCD displays. Under normal
operational conditions, the amplifiers are permanently
enabled when the AVIN supply is present. Under fault
conditions and with EN1 active, the temperature shut-down
charge. Once the threshold is reached, the negative charge
pump will begin. Removing the DLY1 capacitor will cause the
negative charge pump to start immediately once the buck
regulator reaches 90% of the target value. The delay time
and soft-start times are determined using the following
equations:
T DLY1 = C DL1 × --------------
T SSB = C SSB × ---------------
I
(T OFF exceeded) will disable the amplifiers until the
temperature drops to T ON . Temperature shut-down of the
amplifiers is disabled if EN1 is disabled.
The amplifiers integrated in to the ISL97652 feature high
output current of 50mA minimum and high slew rate of
V DL1
I DL1
V SSB
SSB
(EQ. 20)
(EQ. 21)
50V/μs. Both inputs and outputs have rail-to-rail capability.
Start-Up Sequence Control
The ISL97652 features extensive start-up sequence control
options. Two enable pins and two delay control pins are
used to set the start-up sequence.
The EN1 enable pin controls the buck regulator and negative
charge pump controller. When EN1 goes H, the internal 5.3V
regulator starts up. Once the regulator output on pin 27
(VDC) exceeds it's UVLO threshold, the REF pin starts to
charge up to the normal output level. Once REF is within
15% of it's final value, the buck regulator will start to operate.
Note that if V REF moves more than 15% from it's target
The EN2 pin is used to control the boost and positive charge
pump circuits.Note that EN2 is ignored until the buck
converter has reached 90% of it's target value. When taken
high, the internal PFET is turned on to connect the input to
the A VDD output. A capacitor connected to SUI provides
control over the soft connect to limit inrush current. Next, the
boost converter starts to operate. The soft-start time for the
boost is set using the capacitor tied to the SS pin. Once the
output reaches 90% of the target value, the DLY2 timer
starts. Once completed, the positive V ON charge pump
starts to operate. If CDL2 is not present, the V ON charge
pump will start immediately once the boost is in regulation.
The delay time is determined using the following equation:
T DLY2 = C DL2 × --------------
I
T SS = C SS × -----------
I
value, all major functions will be disabled until REF returns to
it's normal range. This involves the chip going through the
normal start-up sequence from buck start-up onwards,
depending on the state of the enable signals EN1, EN2. The
soft-start time is set using the capacitor connected to SSB.
Once the output reaches 90% the DLY1 capacitor begins to
19
V DL2
DL2
V SS
SS
(EQ. 22)
(EQ. 23)
FN9287.1
November 2, 2007
相关PDF资料 |
PDF描述 |
|---|---|
| H3DWH-3418G | IDC CABLE - HKR34H/AE34G/HPL34H |
| ISL97652IRZ-T | IC LCD SUPPLY 4CH DUAL AMP 48QFN |
| H3DKH-3418G | IDC CABLE - HKR34H/AE34G/HPK34H |
| AK670M/2-2-GR-R | CABLE USB A-MINI B 4PIN V2.0 2M |
| EEM15DSEF | CONN EDGECARD 30POS .156 EYELET |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL97653AIRZ | 功能描述:电流型 PWM 控制器 5-CH INTEGRTD LCD SUPPLY W/TEMP SENSOR RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| ISL97653AIRZ-T | 功能描述:电流型 PWM 控制器 5-CH INTEGRTD LCD SUPPLY W/TEMP SENSOR RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| ISL97653AIRZ-TK | 功能描述:电流型 PWM 控制器 5-CH INTEGRTD LCD SUPPLY W/TEMP SENSOR RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| ISL97653IRZ | 制造商:Intersil Corporation 功能描述: |
| ISL97656IRTZ | 功能描述:IC REG BOOST ADJ 4A 10TDFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:1 输出电压:5V，1 V ~ 10 V 输入电压:3.5 V ~ 28 V PWM 型:电流模式 频率 - 开关:220kHz ~ 1MHz 电流 - 输出:600mA 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:16-SSOP（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:16-QSOP |
发布紧急采购，3分钟左右您将得到回复。