参数资料
| 型号： | ISL97701IRZ |
| 厂商： | Intersil |
| 文件页数： | 7/10页 |
| 文件大小： | 0K |
| 描述： | IC REG BOOST ADJ 0.1A 10DFN |
| 标准包装： | 100 |
| 类型： | 升压（升压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 可调 |
| 输入电压： | 2.3 V ~ 5.5 V |
| 频率 - 开关： | 1MHz |
| 电流 - 输出： | 100mA |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-VFDFN 裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 10-DFN（3x3） |
ISL97701
Pin Descriptions
PIN
When NEN is driven low the ISL97701 begins with the
start-up sequence.
NUMBER
1
2
3
4
5
6
7
8
9
10
PIN NAME
GND
VDDOUT
VDD
NSYNC
FB
NC
GND
NEN
V OUT
LX
PIN FUNCTION
Ground
Protection Switch Output
Supply Input
Synchronization Input (Falling Edge)
Feedback Input
Do Not Connect
Ground
Enable Input (Active Low)
Boost Output Voltage
Boost FET
Start-Up Sequence
After pin NEN is pulled low or a restart is triggered from Fault
Control during operation, the ISL97701 goes through a start-
up sequence with the following six states: Soft Inrush ->
VDDOUT Enable -> Soft Boost 25 -> Soft Boost 50 -> Soft
Boost 75 -> Normal.
If the sequence has completed, the ISL97701 stays in the
“Normal” state until NEN is high again or any fault is detected.
SOFT INRUSH: STATE DURATION ~2.048ms
The switch at VDDOUT is configured as current source and
provides a limited current through the inductor to pre-charge
the capacitor at V OUT .
Function Overview
The ISL97701 is a high frequency, high efficiency boost
regulator which operates in constant frequency PWM mode.
The boost converter generates a stable, higher output
voltage from a variable, low voltage input source (e.g. Li-ion
battery). The output voltage level is defined from the
feedback resistor network in Equation 1.
VDDOUT ENABLE: STATE DURATION ~128μs
The switch at VDDOUT is fully enabled and connects the
inductor to VDD with a low ON-resistance.
SOFT BOOST 25 -> 50 -> 75: STATE DURATION
3x ~2.048ms
The boost regulator begins to switch at LX.
V OUT = V refFB ? ( R 1 + R 2 ) ? R 2
(EQ. 1)
The LX current limit increases in three steps representing
The switching frequency is either generated from the fixed
1MHz internal oscillator or provided externally at the
synchronization pin in the range from 600kHz to 1.4MHz.
The compensation network and soft-start functions are built
in with fixed parameters without any need for further external
components.
To stop battery discharge into the output load when disabled,
the inductor is disconnected from the input supply with a low
ON-resistance power switch.
Built-in fault protection monitors inductor current and output
voltage as well as junction temperature in order to interrupt
the high current circuit path through the inductor and diode in
the event of a load failure.
Low logic input thresholds allow the ISL97701 to interface
25%, 50% and 75% of its final value.
NORMAL
If no fault was detected Normal state is entered ~8.256ms
after NEN is pulled low.
The LX current limit steps up to 100%.
In all states Fault Control can force the sequence to restart
or even to shutdown (see Table 1).
V(NEN)
V(V OUT )
directly to microcontrollers with lower supply voltage.
Alternatively, the internal pull-up resistors on all logic inputs
provide level shifting when driven from open collector outputs.
75
NORMAL
I(VDD)
Description of Operation
Enable Pin (Active Low) - NEN
If NEN is high, the ISL97701 shuts down all its internal
SOFT
INRUSH
25
50
VDD OUT ENABLE
functions and deactivates its I/So. Only the internal pull-up
resistor at NEN remains active. If NEN is high, the input
disconnect switch between VDD and VDDOUT interrupts the
circuit path from the input voltage VDD through inductor and
diode to the output load at V OUT . If shutdown, the total
supply current in VDD is typically less than 0.1μA.
7
FIGURE 14. FAULT CONTROL SEQUENCE
Fault Control
The input voltage at VDD, current in the VDD OUT switch,
voltage at V OUT and junction temperature T J are
continuously monitored and can either restart the start-up
FN6474.1
February 22, 2008
相关PDF资料 |
PDF描述 |
|---|---|
| ISL97702IRZ-T7 | IC REG BOOST ADJ 0.13A DL 10DFN |
| ISL98012IUZ | IC REG BOOST ADJ 0.6A 10MSOP |
| ISPPAC-POWR1208-01TN44E | IC ISP POWER MGR ANLG/LOG 44TQFP |
| ISPPAC-POWR604-01TN44E | IC ISP POWER MGR ANLG/LOG 44TQFP |
| ISPPAC-POWR6AT6-01NN32I | IC ISP POWER SUPPLY PROGR 32QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL97701IRZ-T13 | 功能描述:IC REG BOOST ADJ 0.1A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:1 输出电压:5V，1 V ~ 10 V 输入电压:3.5 V ~ 28 V PWM 型:电流模式 频率 - 开关:220kHz ~ 1MHz 电流 - 输出:600mA 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:16-SSOP（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:16-QSOP |
| ISL97701IRZ-T7 | 功能描述:IC REG BOOST ADJ 0.1A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:1 系列:EZBuck™ 类型:降压（降压） 输出类型:可调式 输出数:1 输出电压:0.8 V ~ 22.1 V 输入电压:3 V ~ 26 V PWM 型:电流模式 频率 - 开关:1.5MHz 电流 - 输出:1.8A 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-WFDFN 裸露焊盘 包装:剪切带 (CT) 供应商设备封装:8-DFN（2x2） 其它名称:785-1276-1 |
| ISL97702IRZ | 功能描述:IC REG BOOST ADJ 0.13A DL 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:1 系列:EZBuck™ 类型:降压（降压） 输出类型:可调式 输出数:1 输出电压:0.8 V ~ 22.1 V 输入电压:3 V ~ 26 V PWM 型:电流模式 频率 - 开关:1.5MHz 电流 - 输出:1.8A 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-WFDFN 裸露焊盘 包装:剪切带 (CT) 供应商设备封装:8-DFN（2x2） 其它名称:785-1276-1 |
| ISL97702IRZ-T13 | 功能描述:IC REG BOOST ADJ 0.13A DL 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:1 输出电压:5V，1 V ~ 10 V 输入电压:3.5 V ~ 28 V PWM 型:电流模式 频率 - 开关:220kHz ~ 1MHz 电流 - 输出:600mA 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:16-SSOP（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:16-QSOP |
| ISL97702IRZ-T7 | 功能描述:IC REG BOOST ADJ 0.13A DL 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:1 输出电压:5V，1 V ~ 10 V 输入电压:3.5 V ~ 28 V PWM 型:电流模式 频率 - 开关:220kHz ~ 1MHz 电流 - 输出:600mA 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:16-SSOP（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:16-QSOP |
发布紧急采购，3分钟左右您将得到回复。