- 您现在的位置：买卖IC网 > PDF目录20502 > IXDD414YI (IXYS)IC MOSFET DRVR LS 14A SGL 5TO263 PDF资料下载
参数资料
| 型号： | IXDD414YI |
| 厂商： | IXYS |
| 文件页数： | 8/10页 |
| 文件大小： | 0K |
| 描述： | IC MOSFET DRVR LS 14A SGL 5TO263 |
| 产品变化通告： | Discontinuation Notice 15/Jun/2010 |
| 标准包装： | 50 |
| 配置： | 低端 |
| 输入类型： | 非反相 |
| 延迟时间： | 30ns |
| 电流 - 峰： | 14A |
| 配置数： | 1 |
| 输出数： | 1 |
| 电源电压： | 4.5 V ~ 35 V |
| 工作温度： | -55°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | TO-263-6，D²Pak（5 引线+接片），TO-263BA |
| 供应商设备封装： | TO-263-5 |
| 包装： | 管件 |
| 配用： | EVDD414-ND - EVALUATION BOARD FOR IXDD414 DVR |
IXDD414PI/414YI/414CI/414SI
APPLICATIONS INFORMATION
Short Circuit di/dt Limit
A short circuit in a high-power MOSFET module such as the
VM0580-02F, (580A, 200V), as shown in Figure 26, can cause
the current through the module to flow in excess of 1500A for
10 μ s or more prior to self-destruction due to thermal runaway.
For this reason, some protection circuitry is needed to turn off
the MOSFET module. However, if the module is switched off
too fast, there is a danger of voltage transients occuring on the
drain due to Ldi/dt, (where L represents total inductance in
series with drain). If these voltage transients exceed the
MOSFET's voltage rating, this can cause an avalanche break-
down.
The IXDD414 has the unique capability to softly switch off the
high-power MOSFET module, significantly reducing these
ground. (Those glitches might cause false triggering of the
comparator).
The comparator's output should be connected to a SRFF(Set
Reset Flip Flop). The flip-flop controls both the Enable signal,
and the low power MOSFET gate. Please note that CMOS 4000-
series devices operate with a V CC range from 3 to 15 VDC, (with
18 VDC being the maximum allowable limit).
A low power MOSFET, such as the 2N7000, in series with a
resistor, will enable the VMO580-02F gate voltage to drop
gradually. The resistor should be chosen so that the RC time
constant will be 100us, where "C" is the Miller capacitance of
the VMO580-02F.
Ldi/dt transients.
For resuming normal operation, a Reset signal is needed at
Thus, the IXDD414 helps to prevent device destruction from
both dangers; over-current, and avalanche breakdown due to
di/dt induced over-voltage transients.
The IXDD414 is designed to not only provide ± 14A under
normal conditions, but also to allow it's output to go into a high
impedance state. This permits the IXDD414 output to control
a separate weak pull-down circuit during detected overcurrent
shutdown conditions to limit and separately control d VGS /dt gate
turnoff. This circuit is shown in Figure 27.
Referring to Figure 27, the protection circuitry should include
a comparator, whose positive input is connected to the source
of the VM0580-02. A low pass filter should be added to the input
of the comparator to eliminate any glitches in voltage caused
by the inductance of the wire connecting the source resistor to
the SRFF's input to enable the IXDD414 again. This Reset can
be generated by connecting a One Shot circuit between the
IXDD414 Input signal and the SRFF restart input. The One Shot
will create a pulse on the rise of the IXDD414 input, and this
pulse will reset the SRFF outputs to normal operation.
When a short circuit occurs, the voltage drop across the low-
value, current-sensing resistor, (Rs=0.005 Ohm), connected
between the MOSFET Source and ground, increases. This
triggers the comparator at a preset level. The SRFF drives a low
input into the Enable pin disabling the IXDD408 output. The
SRFF also turns on the low power MOSFET, (2N7000).
In this way, the high-power MOSFET module is softly turned off
by the IXDD414, preventing its destruction.
Figure 27 - Application Test Diagram
Ld
10uH
+
-
VB
Rd
IXDD414
0.1ohm
VCC
VCCA
Rg
High_Power
IN
EN
OUT
Rsh
1600ohm
1ohm
VMO580-02F
+
-
VCC
+
-
VIN
GND
GND
Rs
Low_Power
2N7002/PLP
One Shot Circuit
Rcomp
R+
10kohm
Ls
20nH
0
NOT1
CD4049A
Ros
1Mohm
Cos
1pF
NAND
CD4011A
NOT2
CD4049A
Q
R
5kohm
Ccomp
1pF
Comp
LM339
V+
V-
+
-
REF
+
-
C+
100pF
NOT3
CD4049A
NOR1
CD4001A
S
EN
NOR2
CD4001A
SR Flip-Flop
8
相关PDF资料 |
PDF描述 |
|---|---|
| S332M33Z5UN6TJ5R | CAP CER 3300PF 1KV 20% RADIAL |
| AT25160A-10TU-2.7 | IC EEPROM 16KBIT 20MHZ 8TSSOP |
| LQH32CN561K23L | INDUCTOR 560UH 60MA 1210 |
| AT25160A-10TU-1.8 | IC EEPROM 16KBIT 20MHZ 8TSSOP |
| T95C107M016EZAL | CAP TANT 100UF 16V 20% 2812 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IXDD415 | 制造商:IXYS 制造商全称:IXYS Corporation 功能描述:Dual 15 Ampere Low-Side Ultrafast MOSFET Driver |
| IXDD415SI | 功能描述:功率驱动器IC MOSFET Driver 30V 15A RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| IXDD430 | 制造商:IXYS 制造商全称:IXYS Corporation 功能描述:30 Amp Low-Side Ultrafast MOSFET / IGBT Driver |
| IXDD430CI | 功能描述:功率驱动器IC 30 Amps 40V 0.4 Rds RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| IXDD430MCI | 功能描述:功率驱动器IC 30 Amps 40V 0.4 Rds RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。