参数资料
| 型号： | KSZ8051MNL |
| 厂商： | Micrel Inc |
| 文件页数： | 13/59页 |
| 文件大小： | 0K |
| 描述： | TXRX PHY 10/T100 3.3V MII 32-QFN |
| 标准包装： | 640 |
| 类型： | PHY 收发器 |
| 驱动器/接收器数： | 1/1 |
| 规程： | MII |
| 电源电压： | 1.8V，2.5V，3.3V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-VFQFN 裸露焊盘 |
| 供应商设备封装： | 32-QFN（5x5） |
| 包装： | 托盘 |
| 配用： | 576-3865-ND - BOARD EVALUATION FOR KSZ8051MNL |
| 其它名称： | 576-3732 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页
Micrel, Inc.
KSZ8051MNL/RNL
July 2010
20
M9999-070910-1.0
Scrambler/De-scrambler (100Base-TX only)
The scrambler is used to spread the power spectrum of the transmitted signal to reduce EMI and baseline wander, and
the de-scrambler is needed to recover the scrambled signal.
SQE and Jabber Function (10Base-T only)
In 10Base-T operation, a short pulse is put out on the COL pin after each frame is transmitted. This SQE Test is required
as a test of the 10Base-T transmit/receive path. If transmit enable (TXEN) is high for more than 20 ms (jabbering), the
10Base-T transmitter is disabled and COL is asserted high. If TXEN is then driven low for more than 250 ms, the 10Base-
T transmitter is re-enabled and COL is de-asserted (returns to low).
PLL Clock Synthesizer
The KSZ8051MNL/RNL generates all internal clocks and all external clocks for system timing from an external 25MHz
crystal, oscillator, or reference clock. For the KSZ8051RNL in RMII 50MHz clock mode, these clocks are generated from
an external 50MHz oscillator or system clock.
Auto-Negotiation
The KSZ8051MNL/RNL conforms to the auto-negotiation protocol, defined in Clause 28 of the IEEE 802.3 Specification.
Auto-negotiation allows UTP (Unshielded Twisted Pair) link partners to select the highest common mode of operation.
During auto-negotiation, link partners advertise capabilities across the UTP link to each other, and then compare their own
capabilities with those they received from their link partners. The highest speed and duplex setting that is common to the
two link partners is selected as the mode of operation.
The following list shows the speed and duplex operation mode from highest to lowest priority.
Priority 1: 100Base-TX, full-duplex
Priority 2: 100Base-TX, half-duplex
Priority 3: 10Base-T, full-duplex
Priority 4: 10Base-T, half-duplex
If auto-negotiation is not supported or the KSZ8051MNL/RNL link partner is forced to bypass auto-negotiation, then the
KSZ8051MNL/RNL sets its operating mode by observing the signal at its receiver. This is known as parallel detection, and
allows the KSZ8051MNL/RNL to establish link by listening for a fixed signal protocol in the absence of auto-negotiation
advertisement protocol.
Auto-negotiation is enabled by either hardware pin strapping (NWAYEN, pin 30) or software (register 0h, bit 12).
By default, auto-negotiation is enabled after power-up or hardware reset. Afterwards, auto-negotiation can be enabled or
disabled by register 0h, bit 12. If auto-negotiation is disabled, the speed is set by register 0h, bit 13, and the duplex is set
by register 0h, bit 8.
The auto-negotiation link up process is shown in the following flow chart.
相关PDF资料 |
PDF描述 |
|---|---|
| VE-2V1-MX-F2 | CONVERTER MOD DC/DC 12V 75W |
| SY897132LKY | IC LINK REPLICATOR 28TSSOP |
| SP483CS-L | IC TXRX RS485 HALF DUPLEX 8PDIP |
| MS27497P20F41P | CONN RCPT 41POS WALL MNT W/PINS |
| MS3116P22-21S | CONN PLUG 21POS STRAIGHT W/SCKT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| KSZ8051MNL TR | 功能描述:以太网 IC 3.3V, 10Base-T/100Base-TX Physical Layer Transceiver w/ MII Support (32-QFN) RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ8051MNL-EVAL | 功能描述:以太网开发工具 3.3V, 10Base-T/100Base-TX Physical Layer Transceiver w/ MII Support (32-QFN) - Evaluation Board RoHS:否 制造商:Micrel 产品:Evaluation Boards 类型:Ethernet Transceivers 工具用于评估:KSZ8873RLL 接口类型:RMII 工作电源电压: |
| KSZ8051MNLI | 功能描述:TXRX PHY 10/T100 3.3V 32QFN RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:1,140 系列:AU 类型:收发器 驱动器/接收器数:1/1 规程:CAN 电源电压:5.3 V ~ 27 V 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SO 包装:管件 其它名称:935267940512AU5790D14AU5790D14-ND |
| KSZ8051MNLI TR | 功能描述:以太网 IC 3.3V, 10Base-T/100Base-TX Physical Layer Transceiver with MII support (32-QFN, Industrial Grade) RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ8051MNLITR | 制造商:Micrel 功能描述:Ethernet TXRX PHY 10 T100 3.3V 32 QFN |
发布紧急采购，3分钟左右您将得到回复。