参数资料
| 型号： | KSZ8995MAI |
| 厂商： | Micrel Inc |
| 文件页数： | 35/89页 |
| 文件大小： | 0K |
| 描述： | IC SWITCH 5-PORT 10/100 128PQFP |
| 标准包装： | 66 |
| 系列： | * |
| 类型： | * |
| 应用： | * |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 128-BFQFP |
| 供应商设备封装： | 128-PQFP（14x20） |
| 包装： | 托盘 |
| 产品目录页面： | 1081 (CN2011-ZH PDF) |
| 配用： | 576-1607-ND - BOARD EVAL EXPERIMENT KSZ8995MA |
| 其它名称： | 576-2126 KSZ8995MAI-ND |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页当前第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页
Micrel, Inc.
KS8995MA/FQ
October 2011
40
M9999-102611-3.0
VLAN Support
KS8995MA/FQ supports 16 active VLANs out of 4096 possible VLANs specified in IEEE 802.1q. KS8995MA/FQ provides
a 16-entry VLAN table, which converts VID (12 bits) to FID (4 bits) for address look-up. If a non-tagged or null-VID-tagged
packet is received, the ingress port VID is used for look-up. In the VLAN mode, the look-up process starts with VLAN table
look-up to determine whether the VID is valid. If the VID is not valid, the packet will be dropped and its address will not be
learned. If the VID is valid, FID is retrieved for further look-up. FID+DA is used to determine the destination port. FID+SA
is used for learning purposes.
DA Found In
Static MAC Table
USE FID Flag?
FID Match?
DA+FID Found In
Dynamic MAC Table
Action
No
Don’t Care
No
Broadcast to the membership ports defined in the VLAN
table bit [20:16].
No
Don’t Care
Yes
Send to the destination port defined in the dynamic
MAC table bit [54:52].
Yes
0
Don’t Care
Send to the destination port(s) defined in the static MAC
table bit [52:48].
Yes
1
No
Broadcast to the membership ports defined in the VLAN
table bit [20:16].
Yes
1
No
Yes
Send to the destination port defined in the dynamic
MAC table bit [54:52].
Yes
1
Yes
Don’t Care
Send to the destination port(s) defined in the static MAC
table bit [52:48].
Table 7. FID+DA Look-Up in the VLAN Mode
SA+FID found in
Dynamic MAC table
Action
No
The SA+FID will be learned into the dynamic table.
Yes
Time stamp will be updated.
Table 8. FID+SA Look-Up in the VLAN Mode
Advanced VLAN features are also supported in KS8995MA/FQ, such as “VLAN ingress filtering” and “discard non PVID”
defined in Register 18 Bit 6 and Bit 5. These features can be controlled on a port basis.
Rate Limit Support
KS8995MA/FQ supports hardware rate limiting on “receive” and “transmit” independently on a per port basis. It also
supports rate limiting in a priority or non-priority environment. The rate limit starts from 0Kbps and goes up to the line rate
in steps of 32Kbps. The KS8995MA/FQ uses one second as an interval. At the beginning of each interval, the counter is
cleared to zero, and the rate limit mechanism starts to count the number of bytes during this interval.
For receive, if the number of bytes exceeds the programmed limit, the switch will stop receiving packets on the port until
the “one second” interval expires. There is an option provided for flow control to prevent packet loss. If the rate limit is
programmed greater than or equal to 128Kbps and the byte counter is 8K bytes below the limit, the flow control will be
triggered. If the rate limit is programmed lower than 128Kbps and the byte counter is 2K bytes below the limit, the flow
control will be triggered.
For transmit, if the number of bytes exceeds the programmed limit, the switch will stop transmitting packets on the port
until the “one second” interval expires.
If priority is enabled, the KS8995MA/FQ can support different rate controls for both high priority and low priority packets.
This can be programmed through Registers 21 – 27.
相关PDF资料 |
PDF描述 |
|---|---|
| MIC5281-3.3YMME TR | IC REG LDO 3.3V 25MA 8MSOP-EP |
| RMC50DRYN-S13 | CONN EDGECARD 100PS .100 EXTEND |
| EMC44DRAI | CONN EDGECARD 88POS R/A .100 SLD |
| AMM22DRSI-S288 | CONN EDGECARD 44POS .156 EXTEND |
| ESC55DRST-S273 | CONN EDGECARD 110PS DIP .100 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| KSZ8995MAIB3 | 功能描述:IC SWITCH 5-PORT 10/100 128PQFP RoHS:是 类别:集成电路 (IC) >> 专用 IC 系列:* 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1 系列:- 类型:调帧器 应用:数据传输 安装类型:表面贴装 封装/外壳:400-BBGA 供应商设备封装:400-PBGA（27x27） 包装:散装 |
| KSZ8995MAL | 功能描述:IC SWITCH 10/100 5PORT 128PQFP RoHS:是 类别:集成电路 (IC) >> 专用 IC 系列:* 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1 系列:- 类型:调帧器 应用:数据传输 安装类型:表面贴装 封装/外壳:400-BBGA 供应商设备封装:400-PBGA（27x27） 包装:散装 |
| KSZ8995MI | 功能描述:以太网 IC 5 Port 10/100 Switch with PHY and Frame Buffers, Lead free RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ8995MIA4 | 功能描述:IC SWITCH 5-PORT 10/100 128PQFP RoHS:是 类别:集成电路 (IC) >> 专用 IC 系列:* 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1 系列:- 类型:调帧器 应用:数据传输 安装类型:表面贴装 封装/外壳:400-BBGA 供应商设备封装:400-PBGA（27x27） 包装:散装 |
| KSZ8995X | 功能描述:以太网 IC 5 Port 10/100 Switch with PHY and Frame Buffers, Lead free RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
发布紧急采购，3分钟左右您将得到回复。